R;=2K Vd

Q: Q2: In the figure below, replace RE with 4.7 kN RL int 10 k2. The value for B is 200. (a) Name the a...

A:

Q: b) Electric field can be created either by a voltage source or by time varying magnetic field. Betwe...

A: Electric field can be created in two ways one by using a constant voltage source or a varying magnet...

Q: Two 3.3 k2 resistors are in series combination are in parallel with a 4.7 ko resistor. What will be ...

A: To find the voltage across 4.7 kiloohms resistor 

Q: ent, show that the alternating

A: Thevenin's theorem states that if a circuit containing multiple voltage and current source and conta...

Q: Can you solve this question please

A:

Q: Question 3 a) Find minimized POS form of given Boolean algebraic expression ABCD+AB CD+ ABCD+ABCD

A: NOTE: Since you have posted multiple independent questions in the same request, We will solve the fi...

Q: Explain the following: 1) LTI Systems2) Frequency response of LTI Systems 3) LTI System Eigen-functi...

A: 1) LTI system means Linear Time invariant system  Linearity means a system that maps an input x(t) ...

Q: AB'C(BD+CDE)+AC' boolean expression

A: Given boolean expression, F=AB'CBD+CDE+AC' Reduce it, F=AB'CBD+CDE+AC'F=ABB'C+AB'CCDE+AC'F=0+AB'CDE+...

Q: Most real time clock chips use 32.678 KHz crystals (2^15), Why clock chips of 2^12 Hz or 2^18 Hz are...

A: The explanation is as follows.

Q: 3. An RC circuit initially uncharged, has a 60 V battery connected to a capacitor C = 200µF, and a r...

A:

Q: Question two: For the circuit in Figure below, ß = 120, VB = 5V. a. Find VE, IE, Ic, Vc Rc 4 ΚΩ Vc b...

A:

Q: 20 k2 +15 10 kQ E, o 10 k2 -15 FIGURE P3-4 3-5. Calculate V, and the op amp's output current in Fig....

A: Given circuit is -

Q: This answers it is true or false!?

A: Dear student please find the following calculation.

Q: Accurately draw the resultant wave form when the following two pulses meet. Assume the meeting point...

A: Here from the question figure, it can be seen that both the pulses meet after a certain distance. Si...

Q: A certain logic gate has a VOL(max) = 0.45 V, and it is driving a gate with a VIL(max) = 0.75 V. Ar...

A: This question is from "Digital Electronics". Under which we are going to study the basic working cri...

Q: Form an AM DSBFC envelope with a 40V positive maximum voltage and a 10V positive minimum voltage, de...

A:

Q: Find thaurent in 30 37 24 4V614

A:

Q: R2 R3 R1 RL For the above circuit, use the RTh short circuit method to determine the short circuit c...

A: Here i have deeived Isc using current division rule.

Q: Q2/ Using Thevenin's theorem to the left of the terminals a-b to find V of RL=2 Q, as shown in the c...

A: Applying Nodal analysis, we get-   Vx-75+Vx16+4= 2 ⇒Vx  = 13.6V Since Vx and Vth are at the same pot...

Q: A galvanometer with a resistance of 15.0 N gives a full-scale reading for a current of 3.0 A. (a) Wh...

A: (a) Let R be the resistance of the galvanometer, V be the full-scale deflection of the galvanometer ...

Q: Find the z-transform expansion for the sequence below.

A: The solution can be achieved as follows.

Q: A 35Hp, 225.35 volts DC shunt motor draws 135 amperes at full load and operates at 1893 rpm. The fie...

A: A 35Hp, 225.35 volts DC shunt motor Full load draws current 135 amperes The field and armature resis...

Q: C2 C3 C1 Find Ceg at the (a,b) terminals given that C1-2.9 uF C2-4.9 uF Ca-8.4 uF

A:

Q: Use the equation describing the FT representation to determine the time-domain -2 lol

A:

Q: Why are these versions of diode circuits called clipping circuits?   **please type it using keyboard...

A: The explanation is as follows.

Q: Question 1: Electric Circuits and Kirchhoff's Laws In the circuit shown in the figure, ɛ1 R1 = 2kN, ...

A: The solution can be achieved as follows.

Q: 2.5. Find the half-power beamwidth (HPBW) and first-null beamwidth (FNBW), in radians and degrees, f...

A: Dear student as per our guidelines we are supposed to solve only one question in which it should con...

Q: - Find the current through the ( I,,12 and I; ) ? – Calculate the power dissipat ed in (3 N) ?

A: To solve above problem one can use either nodal analysis or mesh analysis In nodal analysis we apply...

Q: Refer to section 3.5.3 in your textbook that deals with a bridge rectifier. If the input signal is a...

A: Average voltage and Peak diode current is determined as shown below   

Q: 4. An alternating voltage is represented by the expression v= 35 sin (314.2 t) volt. Determine, i) t...

A: From the given alternating voltage waveform we can able to calculate the value of frequency, time pe...

Q: For which frequency the current is 37 ° behind the voltage in the R = 50, L = 10mH series circuit.

A: Given      Phase Angle = 37 Resistance, R = 50 ohm Inductance, L = 10 mH

Q: Q3/B: Find the equivalent resistance R(a-b) in the circuit of the figure below (

A:

Q: A J- type thermocouple is used to measure the temperature in a heating process. The length of the ba...

A: Given Data:

Q: 3. Charging a capacitor through a resistor. The capacitor initially starts with no charge. Refer to ...

A: Dear student as per our guidelines we are supposed to solve only one question in which it should con...

Q: A J- type thermocouple  is used to measure the temperature in a heating process. Sheath material use...

A:

Q: Charges A and B are placed a distance of 1.5m from one another. The charge of particle A is 0.3 C wh...

A: The solution can be achieved as follows.

Q: What will be the In (natural logarithmic) value of the temperature (t), if a sensor has medium tempe...

A: Given, Medium temperature, To = 190 oC Initial temperature, Ti = 25 oC Actual temperature, T = 30 oC

Q: A single - phase transformer rated 60 KVA in connected to 400/235 VA 5HZ supply, has an efficiency o...

A: Given Data: No load voltage = 235 V Full load voltage = 200 V  

Q: If the phasor current is 45 degrees ahead of the phasor voltage, write down all the possibilities ab...

A: A good question based on simple current and voltage phasor . Have a look at the solutiom I have prov...

Q: Determine the current through each resistor. 12 V CB. 10 2 9 V 12 V 59 10 N 5 V 9 V 10 N

A: As per our policy I have to do the first one only. Let, Current i1 flows in the upper circuit. Curr...

Q: circuit analysisIn the circuit shown below, v (t) voltage is given. Energy stored in iC (t), vR (t),...

A:

Q: ing Portal Courses Reports Vices www A A=A mmeter V = Vo Itmeter R= Resistor B = Battery K= Key 上二 w...

A: For verification of ohms law we use a experimental setup as used in this question 

Q: There are point loads ,Q1 = 5, Q2 = 8 and Q3 = 6 at points A(-8,0), O(0,0) and B (6,0) in the OXY pl...

A: Any electrical charge produces an electric field around it. The electric field lines direction is fr...

Q: Quiq plz

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other qu...

Q: Find the z-transform expansion for the sequence below.

A:

Q: Plz I need the answer of

A: In discrete, Step function is defined as: u(n)=1 when n≥0=0; else where u(-n)=1 when n≤0 =0; else wh...

Q: The input power of a three-phase motor was measured by a two-watt method. The readings were BKW and...

A:

Q: What is I and I1?

A: DIODE ON:- a diode is said to be in the ON state if the direction of the current through the diode i...

Q: R3 R2 RL R1 Given I = 6 A R1 =50 R2 = 72 R3 = 42 For the above circuit, determine VTh and RTh to the...

A:

Q: Q2. The structure in the figure has 4 concentric spherical media, which have; O<r<a free space a<r<b...

A: