recent Internet of Things (IoT) technology in the field of communication and value the knowledge related to the following points of IoT: a) Basics of IoT b) Characteristics (Intelligence, Architecture, Complexity) c) Applications (5) d) IoT enabling Technologies e) Security in IoT f) Pros and Cons of IoT g) Future of IoT

Q: Q3 /mention (3) main differences between TCP/IP AND OSI MODEL?

A: Difference between TCP/IP Model and OSI Model: 1. TCP/IP is a client-server model, which means, when…

Q: Discussion 1. Define the PID controller? 2. How does PID correct the error ? Explain that 3. Find…

A: define PID controller PID to correct error to find error signal for experiment reads and indicate…

Q: The "assign" statement implements continuous assignment between the expression specified on the…

A: The solution is given below.

Q: Using five bits, perform the following binary addition in the 2's complement system: (-10) + (6)

A: Aim: We have to use 5 bits to perform the addition in binary 2's complement system.

Q: Suppose Bob joins a BitTorrent torrent, but he does not want to upload any data to any other peers…

A:

Q: the following services: CB radio at 27 MHz; cordless phone at MHz; FRS at 460 MHz; cellular radio at…

A:

Q: Q.2) What is the method of arbitration of the PCI bus? Modify the following diagram arbitration,…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: Which value of signal to noise ratio (SNR) is required for attaining the maximum data rate supported…

A: According to the question, which value of signal to noise ratio (SNR) is required for attaining the…

Q: A network engineer in his office situated in Beijing China was trying to connect a server in…

A: Since he is unable to connect from Beijing to Singapore as well as to a server in his another office…

Q: Suppose that each cell in a 4-Gbit memory chipmust be refreshed every 10 ms. What is the…

A: Given data: The cell capacitance is: 100 fF The cell voltage is: 2.5 V The expression for the power…

Q: Use the Karnaugh diagram to find the minimized SDP of each expression: а) АВС + АBС + АВС + АВС b)…

A:

Q: 1- Which layers are network support layers? a. Physical Layer b. session Layer 2-What are the…

A: The solution is given below

Q: For Arduino ZERO, using 2.23 V built in reference, what is the input code if the default bit…

A: Default bit is 10 for Arduino ZERO.

Q: Q4: The speed of a file transfer from a university server to a student personal computer is normally…

A: It is given that: Mean=μ=600Standard Deviation=σ=50 Formula Used: For a Normal…

Q: 5. A circuit-switch TDM-link uses 512-bit frames with 24 slots. a) How many circuits' are allocated…

A:

Q: Question 2 Answer the questions given in Table 2. Q. no. 2 (a) Table 2: Question 2 Question If an…

A:

Q: By using array named STD. Write a program in C++ LANGUAGE to calculate student appreciation based on…

A: #include <iostream>using namespace std;int main(){   //lets assume that marks will be…

Q: Discuss if the above LTI systemsin questions  -- with memory -- causal -- stable

A: In this question we need to find the given system have memory , is causal and stable system or not.

Q: 3) Electronic component pinout dimensions, are taken from Actuator options dimensions PCB layout…

A: It is asked to choose the correct option for taking electronic component pinout dimensions.

Q: Problem-5. Suppose that the spectrum of a channel is between 12 MHz and 18 MHz, and an intended…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Q.4/ Which CMOS gates (G1, G2,and G3) in following network can operate at highest frequency? Why? Ao…

A:

Q: A 700 Mbyte CD is used to store PCM voice data. Suppose that a CT voice signal is sampled at 10 kHz,…

A: Given: Sampling frequency fs=10 kHz, Number of bits/sample n=8, Total data stored in CD = 700…

Q: Explain with truth table, symbols and practical applications XOR, NOT, AND gates and also form OR,…

A: (1) X-OR gate Truth-table for 2 input X-OR gate is  A B Y=A⊕B 0 0 0 0 1 1 1 0 1 1 1 0…

Q: Are there possible risks and/or limitations to consider before implementing electronic communication…

A: Given: Electronic communication

Q: Over the RS232 communication channel, an 8 bit data (0010010) is being sent. -20V is used to…

A: The expected data at the receiver end is:-The situation where the evidence provided by the recipient…

Q: What is the simplest equation to describe F(A,B,C,D), where F=1 when the binary value of the inputs…

A:

Q: 20. Label the following volt levels as HIGH, LOW or IND (intermediate) for TTL circuits. 2.3 volts…

A: Given: Few voltage level of TTL circuit. According to question: A TTL input signal is defined as…

Q: Draw the electrical circuit of CMOS NAND gate? Vdd Output Inputa Inputg

A: We need to draw CMOS nand gate

Q: Compare a wireless radio system with a fiber-optic communication system for digitaldata…

A: Difference between wireless communication and fiber-optic communication system - Specification…

Q: Suppose that the spectrum of a channel is between 12 MHz and 18 MHz, and an intended capacity of 10…

A: Given data: Suppose that the spectrum of a channel is between 12 MHz and 18 MHz, and an intended…

Q: Suppose you have a file of size 2 megabyte which contains 32 different 8-bit chars of the same…

A: According to the question we have to find size of the compressed file in megabyte with the help of…

Q: Discuss if the above LTI systemsin questions 2 and 3 are -- with memory -- causal -- stable

A: In this question we need to check the given system is Causal , have memory and stability of the…

Q: O Why the Ip-VD is not linear at low VD regime? Is this an intrinsic or extrinsic property? Is…

A: Solution- ID -VD  is not linear at low VD regime because of intrinstic property of semiconductor ,…

Q: Simplify the following Boolean function F, together with the don't care conditions d, and implement…

A:

Q: 5 Question 6 Given the following SOP: F= E1.3,5,67) %3D Implement the SOP using the 74138 decoder…

A:

Q: Q1. Binary data are transmitted through an AWGN channel with SNR = 5 dB and bandwidth of B Hz.…

A:

Q: Consider an IT organisation. There are two units in the organisation- Application Development and…

A: - For any association, consumer loyalty is a significant factor. Just the client fulfils with the…

Q: Q3) Assume that 5 people want to make a voice call given a link with bandwidth of 20 KHz ranging…

A: Given, Number of voice channels (n) = number of people= n = 5 Bandwidth of link = 20KHz Range of…

Q: Comparison of time switching between ECL, TTL, DTL ? 1.

A:

Q: An RS232 signal has a baud rate of 96000. The capacitance of the line cause a transition period, (…

A: an RS232 signal has a baud rate of 96000. the capacitance of the line cause a transition period (10%…

Q: Design the CMOS diagram for the following Table: (A, B & C are the inputs and Y is the output in the…

A: We have to design the cmos diagram

Q: Build CMOS circuit using Truth-table method: a) F = a + b + c b) F = abc

A:

Q: Givean example of biomedical sensor that uses MEMS technology. Briefly describe the sensor, its…

A:

Q: Give an example of an interface module used in a communications system, then explain its basic…

A: Interface module- Interface module is a hardware device which is used for the transferring of data…

Q: Q = (A+ B)(B+ A) + AB + A+B +B. Sketch a realization of this expression (after simplifying!) using…

A: STANDARD SUM OF PRODUCT FORM: In standard SOP form, the function is the sum of a number of product…

Q: Discuss the method and process in digital communication that said  Analog information sources can be…

A: According to the question we have to discuss the method and process in digital communication that…

Q: III) Explain briefly about requirements of LTE. Also describe the challenges of OFDM-MIMO in LTE.…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…