แสดงวิธีทำให้ดูหน่อยครับ Sample Problem 3/1530 000A satellite of mass m is put into an elliptical orbit around the earth. At pointA, its distance from the earth is h₁ = 500 km and it has a velocity v₁km/h. Determine the velocity u₂ of the satellite as it reaches point B, a distanceh₂ = 1200 km from the earth.50V₂=9h₂ - 1200 KM0°R²1Ah1= 500km| V₁ = 30000 Km/h

Introduction In this problem, we will calculate the velocity of the satellite as it reaches point B…

Sample Problem 3/15 - 30 000 A satellite of mass m is put into an elliptical orbit around the earth. At point - 500 km and it has a velocity U₁ A, its distance from the earth is hi km/h. Determine the velocity 12 of the satellite as it reaches point B, a distance h₂ 1200 km from the earth. V₂=9 h2₂ - 1200km R 47 h1= 500km V₁ = 30000 Km/h

Sample Problem 3/15 - 30 000 A satellite of mass m is put into an elliptical orbit around the earth. At point - 500 km and it has a velocity U₁ A, its distance from the earth is hi km/h. Determine the velocity 12 of the satellite as it reaches point B, a distance h₂ 1200 km from the earth. V₂=9 h2₂ - 1200km R 47 h1= 500km V₁ = 30000 Km/h

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2/13 In the final stages of a moon landing, the lunar mod- ule descends under retrothrust of its descent engine to within h = 5 m of the lunar surface where it has a downward velocity of 2 m/s. If the descent engine is cut off abruptly at this point, compute the impact velocity of the landing gear with the moon. Lunar gravity is of the earth's gravity. h Ans. v = 4.51 m/s
5. Cart A had a mass of 250g, and it rolled down an incline before it caught up to cart B which had a mass of 350g. Cart A started from rest, 1.00m vertically above the level of cart B. Cart B was moving at 1.50m/s [right] before cart A collided with it. Cart B has a compression-spring connected to its rear side so that Cart A compresses the spring as it collides with Cart B. The spring constant of the compression spring was 200.0N/m. a. Determine the maximum compression of the spring as the carts collide b. Determine the velocities of each of the carts once the spring has completely recoiled
I Suppose an autonomous surface vessel (ASV) traveling with velocity TvG/O= vi₁ begins to make a turn by adjusting the thrust of its left and right thrusters, TA and TB, respectively. The center of mass of the ASV is located at G and the ASV is symmetric about its vertical axis. The ASV also experiences a drag force that is proportional to its speed and opposes its velocity. At the instant shown, the drag force is D = -kvi₁ where k is a drag coefficient. 1. To model the mass moment of inertia, approximate the ASV as consisting of three rigid bodies: a flat plate as a center body of mass 6m and two slender rods housing the propulsion assemblies, each of mass m, at the outboard sides of the vehicle. Determine the mass moment of inertia, IG, about the vertical axis passing through the center of mass G. (Hint: Use the parallel axis theorem.) 2. At the instant shown, determine the inertial acceleration vector ac/o = axi₁ + ayi2 of the center of mass and the angular acceleration a of the…
The 0.5-lb projectile A is subjected to a drag force of magnitude kv2, where the constant k = 0.0003 lb-sec²/ft2. This drag force always opposes the velocity v. At the instant depicted, v = 210 ft/sec, 0 = 41°, and r = 495 ft. Determine the corresponding values of r and 0. y | ku² Answers: i M. 0 = i 0 T A V 170 --x ft/sec² rad/sec²
A torpedo was fired at a target ship by a submarine. The torpedo monitor of the target ship detects that 10 seconds pass between the moments when the explosion noise emitted by the water and air is heard. The torpedo travels in a linear orbit in the water. The propagation speed of sound in air is known as 340 m/s and the propagation velocity in water is 1430 m/s. Calculate the distance between the target ship and the torpedo accordingly.
Q1 [Type B]: The 20-lb crate A rests on a smooth surface. If the crate starts from rest and P = (t² + 1.5t) lb where t is in seconds, determine the speed of the crate A at t = 2 s using the method of linear impulse and momentum. Not using the required method would result in a 0 for this question. A Shaobo Huang P 30⁰
Problem 7 The automobile is originally at rest at s = 0. If it then starts to increase its speed at dv/dt = br², determine the magnitudes of its velocity and acceleration at s = s1. Given: d = 90 m p = 72 m b = 0.015 s1 = 165 m Solution:
2/90 A team of engineering students is designing a cata- pult to launch a small ball at A so that it lands in the box. If it is known that the initial velocity vector makes a 30° angle with the horizontal, determine the range of launch speeds vo for which the ball will land inside the box. A 30° 12" 12 Problem 2/90
Body U with mass 5m is stacked on the top body W with mass m, and released. The bodies are in contact along the frictionless interface at 45° to the vertical. The body U is in contact with the frictionless vertical wall. Body W lies on the floor with coefficient of friction u. Relevant dimensions are shown in the figure. Express the results in terms of given quantities: m, g, h and µ (except when µ is given numerically). You need not evaluate sin 45° = cos 45° = 2/2. h U: 5m C 45 D W: m 3h
Ꮎ B A 40 kg ladder is falling from rest. Assume, for simplicity, that the ground and wall are frictionless surfaces (but still exert normal forces!). Find the angular acceleration of the ladder as well as the normal force reactions at A and B at this instant. The ladder has a length of 6 m and is currently at an angle of 70° with the horizontal. απ NA rad/s = N NB = N
A rocket runs out of fuel in the position shown and continues in unpowered flight above the atmosphere. If its velocity in this position was 594 mi/hr, calculate the maximum additional altitude h acquired and the corresponding time t to reach it. The gravitational acceleration during this phase of its flight is 29.7 ft/sec². v = 594 mi/hr Vertical 139 Answers: h = i t= i mi sec
When the 19-lb plunger is released from rest in its vertical guide at 0 = 0, each spring of stiffness k = 34 lb/in. is uncompressed. The links are free to slide through their pivoted collars and compress their springs. Calculate the velocity v of the plunger when the position 0 = 29° is passed. www Answer: v= 4.02 0 9" 19 lb 0 9" ft/sec AAAAI k