Set V1= +15v and V2 = -15v then connect V+ to V1 And V- to V2. Then simulate the schematic. Transient stop time: 10 ms Use dc opt to simulate then screen shot the result.

Q: Q4. The series RL circuit of Figure Q4 is subject to a unit step voltage input of height 5 volts at…

A: The laplace transform converts the time domain into frequency domain.  The impedance for inductor is…

Q: Draw the roots-ground curve of the system given in the figure (K>0)

A: Given: The system is given as: To find: Draw the root locus for K>0.

Q: Q-2: For the circuit of the given figure, Ipss = 8 mA, Vp = -4 V, by using mathematical approach,…

A:

Q: Find the voltage and current across R,L,C Include phasor diagrams and impedance triangle

A: In parallel circuit, the voltage is same across the components. In pure inductive circuit the…

Q: Consider the system in the figure: Graph the geometric places of the roots as the k-value varies…

A: We need to sketch the position of the roots with variations of the value of k from zero to infinity.…

Q: -3: A- By using graphical approach, find Ipg and Vasą for the figure shown, where VDD = 9V, Rp =…

A: In the given figure we note that  VDD  = 9 v RD   = 3KΩRF  = 11MΩID (on ) = 7mAVGS (on)    = 4.5VT…

Q: Solve for voltage, Vx, in the picture.  Please use nodal analysis and only nodal analysis (do not…

A:

Q: By using graphical approach, find Ipo and VcsQ for the figure shown, where VDp = 9V, Rp = 3KN, Rp =…

A: Given circuit: VDD=9 VRD=3 kΩRF=11 MΩIDon=7 mAVGSon=4.5 VVT=3.5 V To find: By using a graphical…

Q: Write down the differential equations describing the loop currents of the given circuit. Assume…

A:

Q: a) Find the current I and voltage VR, VL and Vc in phasor form. b) Draw the phasor diagram of the…

A:

Q: A Wheatstone Bridge is shown in Figure Q5. Determine R3 so that the Bridge circuit is in balanced…

A: aIn Wheatstone Bridge at the point of balance i.e. VAB=Vo=0 V.Both legs have equal voltage…

Q: Q2. For a unit step RL series connection circuit find: 1- Time response. 2- Time constant. 3- Rise…

A: According to given question diagram will be:

Q: Are Vs and R3 in parallel or in series

A:

Q: Then Kirchhoff's loop rule states V-IR-IR2 - IR3 = 0. 26 1. Use the loop equation to find the…

A: As the current through each circuit is same and the voltage drop is different that's why all of the…

Q: D. Pole is s = -6a ± jou. Express in formula what form the natural response is. And aw natural…

A:

Q: a series rc with r = 66-ω and c =7-f connected across a 100 vdc source for a long time, how much…

A:

Q: The circuit in figure 3 is operating in the sinusoidal steady state with w=4k rad/s. Use node…

A:

Q: R-12 R=22 R 32 + C Vc v=Bi e 00000

A: The state equation of the following diagram is as follows:   State variable are il and VCApply…

Q: A- By using graphical approach, find Ipo and Vcsą for the figure shown, where VDp = 9V, Rp = 3KN, Rp…

A: vgs=4.5v vg-vs=4.5 vs=0v vg=4.5v

Q: In the following figure, find we(s) w(s) w(s) and

A:

Q: NOTE: Solve this as soon as possible, I need this urgently. C = 0, D=3 Determine the currents i, iz…

A: Nodal Analysis - It is used to find node voltage using Kirchhoff's current law. Kirchhoff's current…

Q: The voltage across a 4 N resistor of an RC circuit in Figure Q8(b) is given by VR (t) = 2e-6tu(t)V.…

A: Solve as below

Q: In the Circuit below, the switch isinitially ofen(Sushere is no Current), he close the swriten at…

A: Given E =6VR1 =1.8ΏR2 =2.3ΏR3 =1.4Ώ R4 =5.2ΏL =2.1 H

Q: The voltage across a 4 N resistor of an RC circuit in Figure Q8(b) is given by VR(t) = 2e-6tu(t)V.…

A: Solve as below

Q: Three batteries and three resistors are connected together, as shown below. Use Kirchhoff's Rules to…

A: Given circuit,

Q: P 5.4-6 Find the Thévenin equivalent circuit for the circuit shown in Figure P 5.4-6. )3A Figure P…

A: To find thevenin equivalent circuit. 1. Vth  2. Isc  3. Rth

Q: (a) Find the phasor voltage Vo in the circuit shown, and the corresponding voltage waveform o(t)…

A:

Q: Analyze the circuit in Figure 4 which have two voltage sources operating at different frequencies.…

A:

Q: Create five Kirchhoff's Current Law (KCL) problem with figure and solve it(Show complete solution)

A:

Q: Design an inverting linear summer circuit to perform function as Vo = -4V1 -10V2 + 5 V3 + 15 V4. Do…

A:

Q: Q-2: For the circuit of the given figure, Ipss = 8 mA, Vp = -4 V, by using mathematical approach,…

A: 0For the given circuit and IDSS = 8m A  and Vp =-4 V…

Q: 10121 9. D) Fuid V,,Vz- 24 IV/ 40 1.21 ن یي

A: We will apply the nodal analysis technique to solve the question. We assume the voltage at node c to…

Q: A coil and a capacitor have been connected in parallel to a Open at t-o 12 V DC source for a long…

A:

Q: A high voltage engineer cascades having 6 stages Each in the circut . each stages capacitance is 15…

A: Given: Input voltage V=100 kV=105 V Frequency f=100Hz Load current I=1 mA=10-3 A

Q: circuit shown in figure: (Rth may be -ve due to the presence of the dependent source) Kli, R1 +, ww-…

A:

Q: o 9V=Vcc 1002 potentiometer in series with a 3002 resistor 10KΩ Vb a a + Vp- 10KO 3502 strain gage…

A:

Q: ,A two-element series circuit has voltage V 200 /0 V. and circuit - 10 /- 30° A. Determine the…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance . The…

Q: The circuit is composed of resistors with  a voltage sources. Solve  for  the branch currents (I1 to…

A:

Q: I need help with this supernode problem. I do the KCL at the supernode, but then get two equations,…

A: your two equations are correct and third equation which can be written is given below:…

Q: What’s the difference between Moore and Mealy machines (FSM)? Design an FSM for the following…

A:

Q: draw the thevenin equilvalent circuit and determine the load impedance for maximum power transfer.…

A:

Q: In the synchronous two-switch circuit below, switch1 is in the 'a' position while switch2 is in the…

A:

Q: A series R-C-L circuit with R = 502, L = 1H and C = 500µF. When V = 10Va determine the: dc > a. Time…

A:

Q: (a) A potential divider is formed from two elements with impedances, Z₁ and Z₂. Sketch the layout…

A: Voltage across parallel circuit and current in series circuit remain same Voltage in series circuit…

Q: In the circuit shown V = 100 V, C1 =1µ F, R1=29.9 Kohm and %3D R2=100 Kohm. Find value of Vci at…

A:

Q: 9. Show that In an a.c. olrcult maximum power is transferred to a load whose Impedance is equal to…

A: MAXIMUM POWER TRANSFER THEOREM:-To get the maximum average power transfer in the case of an ac…

Q: Write the state equations for the circuit given in Figure. R-12 R=22 R32 i C Vc v=BVc e 00000

A:

Q: Does the system y(t) = x² (t) + 5 have the scaling and additive properties?

A: Scaling and additivity properties

Q: Design the power supply circuit so that v = 3v,when R - 600 2. Assume input voltage is 180 V. Which…

A: The given circuit is shown below, Given, R2=2RRL23R2-RL2 We need to design the power supply circuit…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.