Simplify the following complex numbers. (Write your answers in rectangular form a. i257 + i388 + i4 b. (2+j3)(2cjs 60)+3i^2 (2+3i) (3(90)

Q: In a CE configuration, the output voltage is with the input voltage. O a. in-phase O b. out-of-phase…

A: Answer: b.out-of-phase by 180 degrees.

Q: 2) The amplitude of the emf in the below circuit is 150V, while the angular frequency is 60x. The…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered  at a time,…

Q: O Question 6 L1 1H R L3 500mH 1kQ L2 600mH Not coupled coils 120VRMS 140 Hz The current of this…

A: We analysis the given circuit in phasor domain

Q: (TCO 1) If the gain in decibels of an amplifier is 76.9, what is the straight gain? 6998 6578 6745…

A: Given, Gain of an amplifier in decibel is 76.9

Q: (a) The following circuits made of universal gates could be replaced with just one single gate for…

A:

Q: FIND THE INVERSE LAPLACE OF : s+4 F(s) = - 48 + (s+4)²+9 (s-3)°

A:

Q: Q3) Use Karnaugh map to minimize the following expression to minimum SOP form. ABCD + ACD + BCD +…

A:

Q: In a Common Base (CB) configuration, the output impedance is almost equal to _____? a.re b.ro c.Rc…

A:

Q: Ehe output voltage in V when R1-9 kohm, R3=7 kohm, R5=15 k-ohm, R7=138 ohms, Reference Voltage of…

A: The given circuit is an standard circuit of instrumentation amplifier.  In this circuit R1 & R2…

Q: Q1 Analyse the circuit shown in Figure Q1, (a) Name the function of each Op-Amp, A1, A2, A3, and A4…

A:

Q: Solve for: A. VB = V; V: B. VE = mA; C. IE = D. VCE = V;

A: The required parameters can be calculated by using DC and AC analysis of the amplifier circuit

Q: 2) The amplitude of the emf in the below circuit is 150V, while the angular frequency is 60x. The…

A:

Q: c) The waveform shown in Figure 1c is passed into an Ideal Low Pass Filter (ILPF) which has a…

A:

Q: The armature of a 6-pole D.C. machine has a diameter of 350mm and is wave wound with 800 conductors…

A: Given data, Pole (P) = 6 , Diameter = 350mm effective length = 200mm magnetic flux density (B) =…

Q: b) i) Calculate the mean value in the signal (shown in red) over the period as shown (-1/4 → 1 secs)…

A: Calculation of mean value of the given signal over the period as shown -14→1 secs . Mean value/…

Q: FIND THE INVERSE LAPLACE OF : 2-5s F(s) (s-6)(s°+11) 2

A:

Q: The -- model has the advantage that the parameters are defined by the actual operating conditions. O…

A: Option c  re model

Q: Tough cookie for one point! :-) L1 R 1H || 1kQ L2 600mH Not coupled coils 120VRMS 140 Hz What value…

A:

Q: a) i) Consider the AM signal s(t) = 10cos(3900Tt) + 40cos(4000Tt) + 10cos(4100Tt). Calculate the…

A: We need to find out the modulating frequency and modulation index for modulated signal

Q: i 1ha cireuitshown. 4A V.

A: In superposition theorm, only one source remain active at a time and all other sources are…

Q: (TCO 1) If the gain in decibels of an amplifier is 76.9, what is the straight gain? 6998 6578 6745…

A:

Q: E2 Problem No. 2 (P2) A BJT amplifier with in a voltage divider bias configuration has the following…

A:

Q: In time the use of the important parameter of the equivalent circuit was determined by the actual…

A:

Q: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal should…

A:

Q: Question A voltage-driven, source-degenerated MOS gain stage is shown below. You may assume that…

A:

Q: 3.4 A single-phase 100-kVA, 2400/240-volt, 60-Hz distribution transformer is used as a step-down…

A: As per guidelines given to us we can only provide the solution of one question in multiple type of…

Q: Assume that the R2/R1 ratio of a feedback amplifier with voltage supply of +/- 10 V  is 3.4 and that…

A: Assume that the R2/R1 ratio of a feedback amplifier with voltage supply of +/- 10 V is 3.4 and that…

Q: If the DC Supply of an amplifier is set to Zero, the output AC power will be_ a. Negative O b.…

A:

Q: Q2)calculate 12 by using super possession law ? 30 R1 15 R3 500 R2 10 V1

A:

Q: D Question 1 C1 C2 680µF 220µF R1 C3 147KO 450µF A (Total capacitance) CAB = [ Select] uF (time…

A: Given data From the above figure we have C1 = 680μF , C2 = 220μF , C3  = 450μF , R1 = 147kΩ    For…

Q: first step in determining the AC equivalent model for a transistor is setting all dc sources to ____…

A: We need to select correct option for given statement

Q: 2.)For the p-type semiconductor doped with Na = 101°cm-3 at T = 300K, no light was applied before t…

A:

Q: H.W. 13: Switch S, in Fig. is closed at t = 0, and switch Sz is closed a i(t) for all t. Find i(1)…

A:

Q: (i) For the circuit below, draw the output waveforms for both the given input wave- forms. (ii) How…

A:

Q: ded system is determined by the _________ of the gains of each stage. a.product b.difference c.sum…

A:

Q: (c) The following figure shows a transformer. (i) Work out the output at Vs and explain how this…

A:

Q: You are given a report that shows 2 different designs of a quadruple stage impulse generator…

A: Design "A" is more suitable for creating impulsive voltage waveforms than Design "B."

Q: If voltage v = 10 cos(100f + 30°) is applied to a 50 µF capacitor, cal- culate the current through…

A: In this question we need to find a current through capacitor

Q: Suppose that for such a continuous channel with added white Gaussian noise, the ratio of signal…

A: We have to use the Shannon's channel capacity formula to solve this question  C=B×log2[1+(SNR)]…

Q: In a Common Emitter (CE) Fixed Bias (FB) configuration, the output impedance is almost equal to…

A: DC conditions are represented via transistor biassing. Transistor biassing is defined as the proper…

Q: Find g(t) given that 60 G(s) (s + 1)(s + 4s + 13)

A:

Q: Difference between Lumen and Candela?

A: Bartleby has policy to solve only first question.  Kindly upload one question at a time.

Q: 1. A series AC circuit consisting of R = 200 2 and L = 320 mH are connected across V = 20 VL0°, 100…

A: 1) For a series AC circuit consisting of R and L  Determine the following :  Inductive reactance,…

Q: lsing the superpotitien theorem, find tha ualre of the au4 el taga V, n the cireuitshown. 4A CA

A: According to superposition theorem, total output across the load is equal to the summation of…

Q: Sz 22040 メ 10.52 R2 R, O.07H 122 C, o. 2mF 30L0° R3 152 To f = Gohz Load Impedance ZL=R3 Find the in…

A:

Q: Difference between technical ang operational definitions

A: Technical definition means a list of description that how the device is designed to work and what…

Q: Find the Fourier Transform of the triangular pulse -t for – 1 <t < 0 | x(t) = (1+t for 0 <t <1

A: In this question,   We need to determine the Fourier transform of the given signals.

Q: A series circuit consists of a reactor of 0.1 henry inductance and 5 ohms resistance and a capacitor…

A: In this question,   We need to determine the resonance frequency and percentage change in the…

Q: Shown in the figure below from 0 <t< 20 ms is an analog signal za (t) sampled at a rate F, to get æ…

A: We need to find out sampling frequency and time period of sampled signal

Q: For tha cirenits ahown, calenlab rhe currout hrongh the 9 A resiator as ing za emperposition…

A: