SITUATION. An object having a specific gravity of 0.60 floats in a liquid having a specific gravity of 0.80 What is the percentage of the volume below the liquid surface to the total volume of the body? 33% 50% 75% 65% SITUATION. An object having a specific gravity of 0.60 floats in a liquid havinga specific gravity of 0.80 If the volume above the liquid surface is 0.024 m3, what is the weight of the object? 505 N

SITUATION. An object having a specific gravity of 0.60 floats in a liquid having a specific gravity of 0.80 What is the percentage of the volume below the liquid surface to the total volume of the body? 33% 50% 75% 65% SITUATION. An object having a specific gravity of 0.60 floats in a liquid havinga specific gravity of 0.80 If the volume above the liquid surface is 0.024 m3, what is the weight of the object? 505 N

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2. A cube of material is 4 in. on a side and floats at the interface between kerosene (SG=0.82) and water, as shown. a. Find the specific gravity of the material. b. How much weight is required to fully submerge the cube under water? (SG=0.973) (0.063 Ib) Kerosene b/3 Water 2b/3
Check my w A solid block, of specific gravity 0.93, floats such that 75% of its volume is in water and 25% of its volume is in fluid X, which is layered above the water. What is the specific gravity of fluid X?
"The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific gravity of the slurry depends on the concentration of the solid particles. Show that the specific gravity of a water-based slurry can be expressed in terms of the specific gravity of the solid SGs and the mass concentration of the suspended solid particles Cs, mass asSGm=1/(1 +Csmass(1/SGs− 1))"
2. A cube of material is 4 in. on a side and floats at the interface between kerosene (SG=0.82) and water, as shown. a. Find the specific gravity of the material. b. How much weight is required to fully submerge the cube under water? (SG=0.973) (0.063 lb) Kerosene b/3 Water 2b/3 PIE
What fraction of the volume of a solid object (SG = 7.3) floats above the surface of a container of mercury?a. 1.863 b. 0.863 c. 0.537 d. 0.463
An object having a specific gravity of 0.60 floats in a liquid having specific gravity of 0.80. Determine the following: (a) percentage of the volume below the liquid surface to the total volume of the body (b) If the volume above the liquid surface is 0.024 m, what is the weight of the object? (c) The load that will cause the object to be fully submerged
2. A cube of material is 4 in. on a side and floats at the interface between kerosene and water, as shown. a. Find the specific gravity of the material. b. How much weight is required to fully submerge the cube under water? Kerosene b/3 Water 2b/3 SAPIL
y 30 kPa el. 30 m alcohol From the figure shown, the alcohol surface is subjected to pressure a Compute the pressure p = 774 m3 of 30 kPa. at the elevations given below: 1. 6 m 2. 12 m el.16 m oll 3.3 m p = 890 el.8 m water el.5 m glycerin k9/m p = 1235 el. 0 m
Q3: A U-tube containing mercury is used to measure the pressure of an oil of specific gravity 0.82 as in figure 2. Determine (1) Calculate the pressure of the oil, if the difference of mercury level be 400mm What was the application of pascal's law and hydrostatic law for this problem? (ii) ¼ 300 mm Water Water -oil Figure 2 200 mm. 400 mm 400 mm -X -Mercury
A cube is fully filled with a liquid whose specific gravity is 1.16. Determine the sides of the cube if the liquid has a mass of 800 kg. A 0.690 m B) 0.764 m 0.884 m D 0.830 m E) No answer among the choices
If the density of the solid shown is 5 slug/ft3, determine the mass moment of inertia about the y axis.
a.) If the specific weight of a liquid is 55 lb/ft3, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft3/slug, what is its specific weight in lb/ft³?