Solve for total flux use Gauss law D = 4xy ax + 2(x² + 2² Jay + 4yzaz with limits 0≤x≤2 0 ≤ y ≤ 3 0≤Ź=5 MABR

Q: 1. Vs ∞ 452 + = 1/80F Чл ½80F The Circuit above has no peaks between 0+ ({> Y√z). Solve for the…

A: VS - input voltage  VO - output voltage

Q: Find the Fourier representation of 31 2 콘

A:

Q: Let v (t) = 15 cos (300πt +20°). What is this signal's RMS value?

A: Signal is given as, vt=15cos300πt+200.

Q: 1. A machine has initial cost of P50,000 and a salvage value of P10,000 after 10years. What is the…

A:

Q: f= 3GHz G = Gr (Pr ) min = luw Pr PE . (P+)... Use the Friis radio equation: 10 log₁0 (7) = G+ + G₂…

A:

Q: Assume piecewise linear function with one segment one is used, and the cost function of each of…

A:

Q: An analog signal, which is band limited to 10 KHz, is sampled at a rate of fs and the samples are…

A: An analog signal- Band limited to 10 KHz, 32-level PCM system, Roll-off factor = 0.60 and…

Q: Consider is = 1 mA and vs = 2 V. Calculate vL and it for the circuit shown. (You must provide an…

A: We need to find out the current and voltage across inductor in the given circuit.

Q: In the circuit shown, the switch was initially closed between A and B. The switch is opened at = 0.…

A:

Q: A single-phase bridge rectifier has an AC source of 170 V (peak) with frequency of 60Hz. An R-L load…

A: Given data Supply voltage; Vpeak=170 V Resistance;  R=18-X=18-5=13 Ω Inductance; L=35+YX=35+54=89 mH…

Q: Discuss briefly any mismatches between the human hearing and speech systems. Explain why a person…

A: Dear student, Since you have posted a question with multiple sub parts, we will provide the solution…

Q: (i) Write down the fundamental definition for the quality factor Q of a circuit at any radian…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: 3. For the circuit below, use node-voltage analysis to find the current I. 5/0° A 20/-90° V 292 ww…

A:

Q: Discuss the design of modern transmission fibres with respect to effective area and chromatic…

A: It is asked to discuss the design of modern transmission fibers with respect to effective area and…

Q: Figure 35 ΚΩ ●+ {20 ΚΩ Vx >60 kn {90 ΚΩ 1 of 1 ▼ Part B Find u as a function of V. Express your…

A:

Q: Required information Oscilloscope measurements indicate that the peak voltage across a load and the…

A:

Q: How do you clear a new EPROM?

A: We need to tell about how do we clear a new EPROM.

Q: +* lola 4 lokn loka + 17/01 lokn 5 кг 5 ki 50kn 5 + Vo

A: We need to find out output voltage for given operational amplifier circuit.

Q: A different circuit has the transfer function H(s) = 1/ 3s +13 8² +38+2 where I, is the forced…

A: The transfer function of a circuit is H~s=If~Vs~=3s+13s2+3s+2.   The input to the circuit is…

Q: Using Routh's stability criterion, determine the value of K at which the root loci cross the…

A: A system whose characteristic equation is given as:- s4+3s3+12s2+K-16s+K=0

Q: Find io(t) if vs (t) = 300 sin 2500t V. Suppose that io(t) = Io cos(wt + p), where -180° < p ≤ 180°.…

A: Given data vst=300 sin 2500t iot=Iotcosωt+ϕ -180°&lt;ϕ≤180° To find out We have to determine the…

Q: (a) Design a Lead-Lag Compensator whose general expression is given below for the parameters of y =…

A: The transfer function of a lead-lag compensator is  Gs=Ks+1T1s+γT1s+1T2s+1γT2, its parameters are…

Q: S=a_+a_x³y=["") a₂ a₂ = ±₁ Q1 Show that if with w is not Lorentz invariant but and Wy" are…

A: Show that if S=a++a-γ0γ1=a+a-σ1a-σ1a+ with a±=±12γ±1 and γ=11-ν2c2, ψ2 is not Lorentz but ψ¯ψ and…

Q: Integrately design a 5-stage Voltmeter and 3-stage Ammeter using a galvanometer.

A: Integrately design a 5-stage Voltmeter and 3-stage Ammeter using a galvanometer.

Q: For the given circuit and input waveform determine the output waveform. a. b. C. Vi 20 15 d. -10 -5…

A: In this question,  We need to choose the correct options Assume forward bias voltage drop of si type…

Q: R(s) G6 G₁ G₂ H₁ H₂ G3 G5 G4 C(=

A: Given Data: A block diagram model of a system having, Input =Rs Output =Cs To Find: Block diagram…

Q: Question 4: What should be the value of R in ohms if I is to be maintained at 105 mA under changing…

A: EB = 0.7 V, VECsat = 0.2 V. Assume ẞ=∞ VREF= 1.7 volts. Need to find the value of R and load.

Q: What is wrong with this diode? XMM1 Open Short 1 Not enough data Nothing 2 IDEAL_DIODE…

A: When the diode is in forward bias then it has negligible resistance and when it is in reverse bias…

Q: Determine the mesh equations of the following circuit

A: Given: A network, To do: We have to write mesh equations for the given circuit.

Q: Assuming (W/L)₁ = 6, (W/L)2 = 2, (W/L)3 = 3, and (W/L)4 = 27, a reference current Iref= Ο Ο Ο Ο Ο 1…

A:

Q: solve with complete solution

A: Given: A block diagram,  To find: a) System function and zero state step response for a=0.5, b)…

Q: 37. A coil of resistance 12 and inductance 0.12 uH is connected in parallel with a capacitor of 60 f…

A: coil resistance R= 12 ohms        inductance L = 0.12 μH      capacitance C = 60 F input voltage V =…

Q: PROBLEM: Find the range of gain, K, for the system of Figure 6.10 that will cause the system to be…

A:

Q: A 230 V DC shunt machine has an armature resistance of 0.5 22. and a field resistance of 115 92.…

A: 230 V DC shunt machine- Armature resistance Ra=0.5 ohm, Field resistance Rf=115 ohm, Line current=50…

Q: a ii. 7.454 02 www m 5.004 2 V b Hence or otherwise www i=3.5-j2.5 3Q 15 Q2 4602 m 12 Q2 ww C m 16…

A:

Q: What is the current through the zener diode? + V₁ 13 V R₁ 1 ΚΩ express answer in mA 2 4 1 6V Vout

A:

Q: The voltage Vo across the capacitor is: 152 www 10/0° V O 520° V O 7.071245° V O 7.0712-45° V O…

A: We need to find out the voltage across capacitor in the given circuit.

Q: The dimensions of a hollow X-band (8-12 GHz) rectangular waveguide are a = 22.9 mm and b = 10.2 mm.…

A: According to the question, the dimensions of a hollow X-band (8-12 GHz) rectangular waveguide are a…

Q: (a) Determine the impedance Z for maximum average power transfer and the value of the maximum…

A: In this question,  We need to determine the load impedance ZL  and maximum power transfer to the…

Q: Deduce using the properties, the Fourier Transform of the following signals: 1- 5♫(t) 2- II (2t)…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: d) Using the tabular format, determine the output y(n) for n = 0, 1, 2 and 3, if the input x(n)=…

A:

Q: Find the Thevenin equivalent circuit for the network external to the resistor R and draw the…

A: Need to calculate the thevenin's equivalent circuit for the given circuit and also need to calculate…

Q: An instrumentation amplifier is a type of differential amplifier that is particularly useful in…

A:

Q: K-map the Boolean function below? F(X,Y,Z)=TT(0,1,2,4) Sum product Boolean function supplied.

A:

Q: Required information. NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: Draw the output waveform Vo against the input signal. (diode is ideal)..

A: In the given questions we need to find the output voltage waveform.

Q: The maximum load current that can be drawn is 30 V 1.4 mA 2.5 mA 1.8 mA 2.3 mA 15 kQ2 ww V₂=9V R₂=0…

A: We need to find out the current through load and diode for given circuit .

Q: Your customer's 50 Ah battery has a usable storage capacity of 70% of its fully charged storage…

A: The fact that the battery has been discharging at 8A for the last 4 hours does not indicate that it…

Q: 6. Obtain the bode plot of the system given by the transfer function. Define phase and gain margin.…

A:

Q: What is the attenuation limited link length for the system parameters shown below? Launched power =…

A: Launched power=10 mW. Fiber attenuation=-0.4 dB/km. Fiber dispersion=2 ps/km.nm. Joint loss and…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.