Spillway 12.9 m. long releases flood run off from a reservoir 5 hectares in area. If the reservoir level drops from elevation 55 m to 54 m. in 2520 sec. Find the elevation of the crest of the spillway in meters. Use Francis formula. Assume constant reservoir surface area. a. 71.5 m b. 53.5 m c. 24.8 m d. 63.2 m

Spillway 12.9 m. long releases flood run off from a reservoir 5 hectares in area. If the reservoir level drops from elevation 55 m to 54 m. in 2520 sec. Find the elevation of the crest of the spillway in meters. Use Francis formula. Assume constant reservoir surface area. a. 71.5 m b. 53.5 m c. 24.8 m d. 63.2 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

7. A rectangular channel, 20 feet wide, carries a discharge of 200 cfs. Compute the critical depth and velocity.
Water is flowing in a rectangular channel with a bed slope of 0.0005 ft/ft. The channel width is 10 ft amd the discharge is 300 cfs. Now supose that the depth at a given place in the channel is observed to be 6 ft, and the septh observed at a spot 1000 ft downstream is observed to be 4.5 ft. Estimate the manning n cofficient of this channel.
521.. A channel width is 0.312 m. A venture flume having a throat of 5.6 inch was set in the channel. After setting the venture flume, Rota Meter gives the discharge 620 LPM. If the co-efficient of discharge becomes 0.77, what would be the theoretical discharge of the channel?
1. Find the discharge, Q, through a rectangular orifice 4 inches by 6 inches with square edges discharging submerged. The water surface elevation of the impoundment is 220.0, and the elevation of the water surface of the discharge water is 215.0. The elevation of the center of the orifice is 200.0.
A spillway 38.9 ft long releases flood run-off from a reservoir 46,000 m² in area. The initial head is at elevation 65.5 m and the permanent crest is at elevation 64.0 m. If the water releases in 0.7 hrs, what is the final elevation of water surface? a. 64.5 mb. 65.0 mc. 65.5 md. 66.0 m
Specific energyA horizontal rectangular channel is 12 feet wide and carries a flow rate of 60 cfs. A hump that is 0.5 feet high is placed in the flow path. a. If the normal depth of flow is 1.5 feet, what is the depth of flow over the hump? b. If the normal depth of flow is 0.5 feet, what is the depth of flow over the hump?
Find the normal depth for a discharge of 350cfs in a rectangular channel with a bottom widith of 20 ft. The channel is concrete lined (n=0.013) with a slope of 0.75%. Use mannings equation
-1/3 The discharge in a channel with bottom width 3 m is 12 m³ s¹. If Manning's n is 0.013 m and the streamwise slope is 1 in 200, find the normal depth if: a) the channel has vertical sides (i.e. rectangular channel); b) the channel in tranenoidal with sid 200 2H. 1 V
P1) The engineer need to construct a Parshall Flume into 1.5m in wide rectangular channel to a specific discharge. The crest height of the flume must be at 0.25 above the bed of channel and the tailwater must not exceed 0.85m above the bed of channel at D/S. Give a suitable size of the flume to achieve the above hydraulic and geometric conditions and indicate the situation of flow through the flume.
A right-angled triangular channel carries a flow of 16,000 l/s. The Manning's n = 0.020 and the slope is 2 m/3000 m. (a) Determine the critical depth [m] for this flow. (b) Determine Froude number for the flow when the depth of flow is 0.6 m. Determine the normal depth of flow [m]. Show your work fully.
1. Three reservoir A, B, and C are connected by pipelines 1, 2, 3 respectively which merges at a junction X. the elevation of reservoir A is 300 m and that of B is 285 m. The rate of flow from reservoir A is 1.4m³/s A) Compute the rate of flow in reservoir B B) Compute the rate of flow in reservoir C C) Compute the elevation of reservoir C EL 300 m Qb = 0.189 m³/s (receiver) Qc =1.211 m/s ELC = 148.93 m EL 285 m. VEL? Pipe 1 2 3 f 0.0157 0.0162 0.0177 diameter (mm) 800 600 450 Length (m ) 1500 450 1200
குUடும் UTM Water is flowing in a 250 cm w cm width rectangular channel with a unit discharge of 2.4 1/1000 and 0.012 s/m¹/³, The channel bed slope and respectively. If broad Manning's n are a b crested weir is constructed in the channel, determine the height of weir which will create backwater and the flow depth at just upstream of the weir should not exceed 5% of the normal depth. I flow depths above, upstream UTM & UTM 00m³/s.m. Calculate and downstream of the constructed weir. Sketch the flow profiles in the channel and the e the expecte UTM specific energy curve which describes this problem. UTMUTSC &UTM & UTM &UTM