Subnetting in a network is important because it allows a large network to be divided into a smaller network that is easier to manage and maintain. Determine the subnet of class C network address for 101.101.101.0 using the subnet mask as follows. a) Determine subnet mask of 255.255.255.128. b) Determine hosts per subnet. c) Determine the valid subnet.

Subnetting in a network is important because it allows a large network to be divided into a smaller network that is easier to manage and maintain. Determine the subnet of class C network address for 101.101.101.0 using the subnet mask as follows. a) Determine subnet mask of 255.255.255.128. b) Determine hosts per subnet. c) Determine the valid subnet.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter14: System Administration

Section: Chapter Questions

Problem 5VE

See similar textbooks

Similar questions

Subnetting Complete the given tables below: # of Subnets # of hosts per subnet Network Address of the first subnet Network Address of the last subnet Subnet Mask 1. 101.138.121.114 /22 --> /25 2. 221.17.27.41 /24 ---> /26 3. 65.120.65.162 /18 ---> 20 #hosts Subnet Mask in Binary Subnet Mask in Decimal Prefix 35 1289 130
Complete the given tables below: # of Subnets # of hosts per subnet Network Address of the first subnet Network Address of the last subnet Subnet Mask 1. 101.138.121.114 /22 --> /25 2. 221.17.27.41 /24 ---> /26 3. 65.120.65.162 /18 ---> 20 #hosts Subnet Mask in Binary Subnet Mask in Decimal Prefix 35 1289 130
2. Subnetting a subnet or using variable-length subnet mask (VLSM) was designed to maximize addressing efficiency. You are required to subnet, based on the number of hosts, including router interface and WAN interface and WAN connections for the following scenario: •Toronto: 60 host addresses •Montreal: 28 host addresses •Ottawa: 12 host addresses •Vancouver: 12 host addresses •WAN1: 2 host addresses •WAN2: 2 host addresses •WAN3: 2 host addresses Using the given address block of 192.168.15.0/24, you can design an address scheme for the network to meet its requirements and save potential addresses. The data for Toronto is given to help you to fill the remaining all other columns. Name Toronto Montreal Ottawa Vancouver WAN1 WAN2 WAN3 Required no of addresses 60 28 12 12 ~~ 2 2 2 Subnet Address 192.168.15.0 Address Range .1 - .62 Broadcast Address .63 Network/ Prefix 192.168.15.0 /26 19
NAT translation table LAN side addr WAN side addr 135.122.200.215 10.0.1.15 10,0.1.13 address 135.122.200.215 S: 10,0,1.27 2 D: 1 D: S: S: D: S: 10,0.1.15 D: 135.122,200,215 10.०.1.22
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most signi cant bits are used as a network ID, and the 16 least signi cant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
SUBNET ADDRESSING Consider the router and the two attached subnets below (A and B). The number of hosts is also shown below. The subnets share the 23 high-order bits of the address space: 144.145.110.0/23 175 hosts QUESTION 3 OF 10 A Answer What is the subnet address of subnet A? (CIDR notation) 144,145.110.0/23 Assign subnet addresses to each of the subnets (A and B) so that the amount of address space assigned is minimal, and at the same time leaving the largest possible contiguous address space available for assignment if a new subnet were to be added. Then answer the questions below. B 84 hosts
SUBNET ADDRESSING Consider the router and the two attached subnets below (A and B). The number of hosts is also shown below. The subnets share the 23 high-order bits of the address space: 144.145.110.0/23 : A 175 hosts QUESTION 2 OF 10 Answer How many hosts can there be in this address space? 144.145.110.0/23 B Assign subnet addresses to each of the subnets (A and B) so that the amount of address space assigned is minimal, and at the same time leaving the largest possible contiguous address space available for assignment if a new subnet were to be added. Then answer the questions below. 84 hosts
A router interconnects a subnet, where all the interfaces of the subnets must have the prefix 164.132.62/24. suppose that the Subnet is required to support up to 60 interfaces, provide a network address that satisfies the above.
2. The following illustration shows a transmission from Host A to Host B using Network Address Translation (NAT). Host A is located inside a Local Area Network (LAN) with an IP address of 192.168.1.2. The LAN is connected to the Wide Area Network (WAN), i.e. the Internet, through a router R1 that conducts NAT. R1 has two interfaces with an internal LAN IP address (192.168.1.1) and and external WAN IP address (127.45.10.35). Host B is located outside the LAN and is a well-known server, e.g., Google's server. Host B has an IP address of 130.160.23.45. Port numbers for the application components running at both hosts are provided in the figure. For a single message M1 being sent from Host A to Host B, please fill in the blanks in the illustration below with the source IP address and Port number at Host A and at the Router R1. Any information not provided may be assumed, however, please state your assumption clearly. Host A Local Area Network (LAN) IP: 192.168.1.2 Port: 5252 Source IP…
1. Consider the network depicted in Figure 1. Here, we have a sender, a receiver, and four routers. In this figure, capital letters specify the physical addresses of the devices and numbers specify the logical addresses of the devices. For example, the device marked as sender has a physical address A and logical address 5. Sender B/20 C/35 D/40 A/5 E/50 Receiver F/60 J/95 I/90 H/82 G/70, Figure 1: Network topology Similarly, the router connected to the sender has physical address B and logical address 20 for the interface that is connected to the sender. Now, consider that process Pi of the sending computer wants to send some data to process P2 of the receiving computer. Port addresses of process Pi and P2 are Px and Py, respectively. Show the contents of the segments, packets and frames for transport, network, and data link layers at the sender side of three hops with appropriate figures.
1. A router receives a packet with destination address (222.186.114.16) Show how it finds the network and the subnetwork address to route the packet. Assume the number of subnetwork required is four
Consider a TCP segment originating on a host running a Google Chrome Browser destined for the TU Dublin Webserver: (1) Separately identify how the port numbers are assigned for the client and server applications and, identify the range from which these port numbers are allocated. (ii) Identify the byte order used to represent these addresses within the segment header. (iii) If a port number contained in the segment header is passed to the Application layer, identify the function used to convert it to the correct byte order within the application.