The Assmann psychrometer’s dry thermometer shows 22оС, wet thermometer - 14оС. The atmospheric pressure is 745 Hg mm. Calculate the absolute, maximum and relative air humidity, humidity deficit, physiological humidity deficit, find the dew point.

The Assmann psychrometer’s dry thermometer shows 22оС, wet thermometer - 14оС. The atmospheric pressure is 745 Hg mm. Calculate the absolute, maximum and relative air humidity, humidity deficit, physiological humidity deficit, find the dew point.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 1RQ: The standard design conditions for air-conditioning systems established by the Air-Conditioning,...

See similar textbooks

Related questions

Q: Air flows in a pipe under fully developed conditions with an average velocity of 1.25 m/s and a…

Q: There is a 50 cm high vertical pure aluminum plate with a uniform surface temperature of 220 °C…

A: Given: L=0.5m Ts=220oC T∞=20oC To find: h

Q: An air conditioning unit operates on the simple refrigeration cycle using R-134a as the working…

A: Given:Refrigerant=R134aEvaporator pressure, Pe=550 kPaCondenser pressure, Pc=1200 kPaHome inside…

Q: 9-26. Locate the centroid of the area. 9-27. Locate the centroid y of the area. 4 ft || - 4 ft 2 X

Q: Write a generic version of the Reynold’s number equation. What type of flow is associated with a…

Q: 14.43 Steel is carburized in a high-temperature process that depends on the transfer of carbon by…

Q: A straight pin fin has diameter of 4 mm and length of 2 cm. It is made of an alloy with thermal…

Q: Calculate the moment (positive if counterclockwise, negative if clockwise) of the 350-N force on the…

Q: (5) 25 in L = A 30° CA B (a) the angular acceleration (6) the acceleration a A 450 LBC = 18 in Bc…

A: (a) Write the given data. LAB=25 inLBC=18 inαBC=4.2 rad/s2

Q: The truss shown is supported by a hinge at A and a roller at G. Determine all bar forces of the…

Q: -20 m FIG. P3.28 30 kN/m B -10 m- Hinge -10 m- C

Q: pushed at a speed of 400mm/s through a bearing sleeve 70.2-mm in diameter and 250mm long. The…

Q: 3-49 The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

A: Density of water =1000 kg/m3 Density of mercury = 13500 kg/m3 Density of Glycerine = 1260 kg/m3…

Q: Required information Each of the five struts shown consists of a solid steel rod with E= 200 GPa.…

Q: A three-point transverse bending test is conducted on a cylindrical specimen of a ceramic material…

A: Introduction Using the flexural strength, we will compute the maximum load that may be applied…

Q: Required information The helium-filled balloon in the image is tethered at 20°C and 1 atm with a…

A: Given Temperature T= 20 0c String is negligible mass and drag diameter of the balloon d =58 cm =0.58…

Q: Which of the following is NOT an impact of IP infringement? O O O O Loss of market share O damage to…

A: Due to IP infringement there will be loss of market share because same products manufactured by…

Q: Prove the equations below

Q: 19 Under the assumption of very small motions and neglecting friction, determine the natural…

Q: A geothermal well produces 65 kg/s of saturated liquid water at 230°C. The water is used in a…

Q: Calculate the total thermal resistance between hot water and the surrounding ambient air for the…

Q: 1. Locate the centroid of the following figures. a) 90 mm 90 mm 120 mm A = A1-A2 Ax=A1 x1 - A2 x2…

A: The stepwise procedure to solve this problem is shown in the following attached image:

Q: Outdoor air conditions are: 28°C db, 19.5°C wb Return air conditions are: 22°C db, 50% RH. The…

A: Note: As per policy, we can solve the first three subparts. Please resubmit the remaining parts.…

Q: Determine the force in each member of the truss using the "placeholder" method and state if the…

A: Draw the free-body diagram of DCGH. Apply moment equilibrium about G. 2.6731.5-T23=0T2=4 kN Apply…

Q: Question 4 942 Which statement is correct? O Annealing destroy the gra Annealing can idecrease

A: Annealing is a heat treatment process in which the metal is heated to a specific temperature where…

Q: Given all dimensions are in inches, find the x- and y-location of the centroid for the shape below.…

Q: On the basis of ionic charge and ionic radii given in Table 12.3, predict the crystal structure for…

A: (1) To find: The cation to anion radius ratio. Given: The radius of Cs+ is rCs+=0.170 nm. The radius…

Q: Gasoline (sg0.67) is flowing at 0.11 m³/s in the fabri- cated tube shown in Fig. 6.19. If the…

A: Given:Outer diameter of the larger pipe, D=160 mmThickness of the larger pipe, t1=5.5 mmOuter…

Q: A rectangular column is made of a grade of sawn wood that has an adjusted allowable stress for…

A: Write the given data. σC=8.3 MPaE=11.1 GPaP=105 kNe=0.025 mb=0.180 md=0.240 m

Q: C1.3 If a = 120°, B = 45°, y = 60°, and F = 400 direction angles of the resultant force acting on…

Q: A velocity of a vehicle is required to be controlled and maintained constant even if there are…

A: Given situation is

Q: в A с

Q: A carpenter holds a 17-lb 2-in. by 4-in. board as shown. If he exerts vertical forces on the board,…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: Given data:- Weight of the door (F)=400 lb static friction at A =0.15 static friction at B= 0.25 To…

Q: A fluid at 20C flows at 850 cm3/s through an 8 cm diameter pipe. Determine the entrance length if…

Q: A Diesel cycle has a compression ratio of 22 and begins its compression at 87 kPa and 15°C. The…

A: Given data: Compression ratio = R = V1V2= 22 Pressure before compression = P1 = 87 kPa Temperature…

Q: A continuous and aligned fiber-reinforced composite is to be produced consisting of 33 vol% aramid…

Q: An oil pipeline has a 12 inch diameter, and the oil in it flows at an average velocity of 4.0 ft/s.…

A: Introduction The Reynold number determines whether a fluid flow is laminar or turbulent. If the…

Q: Two systems shown in fig. 3, a mass of 1 kg and the springs each with stiffness k = 20 kN/m. Under…

Q: Calculate the number of vacancies per cubic meter in gold (Au) at 900°C. The energy for vacancy…

Q: A 5-m-wide, 4-m-high, and 40-m-long kiln used to cure concrete pipes is made of 20-cm-thick concrete…

Q: Water at 20◦C flows in a 9 cm diameter pipe under fully developed conditions. Since the velocity in…

A: As per guideline i have to answer only three subpart of your question .

Q: Required information A four-cylinder, four-stroke, spark-ignition engine operates on the ideal Otto…

Q: n centimeters. The specific weight of water is 9790 N/m³ and the specific weight of mercury is…

Q: To test the heat transfer for the famous Goodyear blimp, a small-scale prototype is being tested in…

A: Given Data: Cylinder Diameter D = 1.2 m Cylinder Length L = 6 m Wind Velocity V = 6 miles/hr Wind…

Q: Water flows through a cast steel pipe with k = 53 W/m-K with an outer diameter of 110 mm and 3.5 mm…

A: Given:Thermal conductivity of steel pipe, ksteel=53 W/m.KOuter diameter of pipe, do=110 mm=0.110…

Q: O 0.3 m ER B 1.2 m 45% 0.3 m

A: Given system,

Q: Fatigue test are carried out

A: Fatigue test or Rotating beam is carried to know the fatigue stress, in which the beam is rotating…

Q: Compute the moments of inertia with respect to the X-X and Y-Y centroidal axes for the following…

Q: Exercise 4.1.1 Consider a mass m acted on by two springs and dashpots as shown in Figure 4.5. Assume…

Question

4.3. The Assmann psychrometer’s dry thermometer shows 22оС, wet thermometer
- 14оС. The atmospheric pressure is 745 Hg mm. Calculate the absolute, maximum and relative air humidity, humidity deficit, physiological humidity deficit, find the dew point.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. A sample of gas A evaporates over water in a dosed system. What Is the pressure of gas A in kg/m2 if the total pressure Is 780 torr and water vapor pressure Is 1 atm?
Provide the complete solution and diagram for this problem. The humidity ratio of air is 0.055. If barometric pressure is 100 kpa, find the partial pressure ofwater vapor. A. 4.23 kpa B. 7.34 kpa C. 8.12 kpa D. 5.21 kpa
A dry bulb thermometer reads 30 degrees of celsius and wet bulb thermometer reads 24 degree of celsius. What is the relative humidity?
Find the relative humidity in a room at a temperature of 20 C. The wet bulb temperature is 15.5 C.[Ans.: 63%].
Q10/ Calculate specific volumes for Nitrogen: 120 K, 60% quality *
HVAC UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS. PLEASE ANSWER ALL THE SUBQUESTON WITH USING THE PSYCHOMETRIC CHART. SHOW THE DRAWING/DIAGRAM. 3. Air at 22°C db & SATURATED Determine the following: a. RH (Relative Humidity) b. DPT (Due Point Temperature) c. V (Specific Volume) d. h (Enthalpy) e. HR (Humidity Ratio)
2. The absolute humidity at atmospheric pressure at 40 ° C is 0.011 kg air / kg dry air. Specify: A. Air vapor partial pressure. = AnswerkPa. b. Relative humidity = Answer% c. Dew point temperature. = Answer (° C)
HVAC UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS. PLEASE ANSWER ALL THE SUBQUESTON WITH USING THE PSYCHOMETRIC CHART. SHOW THE DRAWING/DIAGRAM. 2. Air at 26°C db & 20°C WB Determine the following: a. RH (Relative Humidity) b. DPT (Due Point Temperature) c. V (Specific Volume) d. h (Enthalpy) e. HR (Humidity Ratio)
Saturated water decrease to increase the volume by lo %% Keeping the temperature constant. To what pressure Should be expands. vapour at 60c has its pressure [18.91cpa]
the barometer shows a value of 760 mm Hg; dry bulb temperature is 30 ° C; wet bulb temperature is 22 ° C. Specify: a. Relative humidity (RH) = ...% b. Absolute humidity = ... (kg water / kg air) c. Dew point temperature = ... (° C)
5. Two kilogram of certain gas with R = 0.218 kJ/kg-Kundergoes a process and results to the following changes: AH= 2190 kJ, AU = 1460 kl. D. What is the change in termperature?
HELP ME ASAP PLS Consider: Relative Humidity at 1500m, in % Round to one (1) decimal place 6. Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude.