The charge (0.075 yC) stored in a component in your calculator is released and flows through a resistor in 1 millionth of a second (1 x 10^-6s) . Calculate the current that flows through the resistor and use it to calculate the resistance of the resistor. The calculator is powered by 4 AAA batteries in series, each 1.5 V, so the total voltage across the resistor is 6 V. Round your answer to the nearest tenth of an Ohm.

The charge (0.075 yC) stored in a component in your calculator is released and flows through a resistor in 1 millionth of a second (1 x 10^-6s) . Calculate the current that flows through the resistor and use it to calculate the resistance of the resistor. The calculator is powered by 4 AAA batteries in series, each 1.5 V, so the total voltage across the resistor is 6 V. Round your answer to the nearest tenth of an Ohm.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 70AP: A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the...

See similar textbooks

Similar questions

A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the weight if the wire was made of copper? (b) What is the weight of a 10.00-meter-long wire of the same gauge made of aluminum? (c)What is the resistance of the aluminum wire? The density of copper is 8960 kg/m3 and the density of aluminum is 2760 kg/m3.
An aluminum wire 1.628 mm in diameter (14-gauge) carries a current of 3.00 amps, (a) What is the absolute value of the charge density in the wire? (b) What is the drift velocity of the electrons? (c) What would be the drift velocity if the same gauge copper were used instead of aluminum? The density of copper is 8.96 g/cm3 and thedensity of aluminum is 2.70 g/cm3. The molar mass ofaluminum is 26.98 g/mol and the molar mass of copper is 63.5 g/mol. Assume each atom of metal contributes one free electron.
An electric device draws 6.10 AA at 240 VV. If the voltage drops by 25 %, what will be current, assuming nothing else changes? Express your answer to two significant figures and include the appropriate units. I final= If the resistance of the device were reduced by 25 %, what current would be drawn at 240 VV? Express your answer to two significant figures and include the appropriate units. I final=
In the circuit shown in the diagram below, two thick wires connect a 1.5 volt battery to a Nichrome (NiCr) wire. Each thick connecting wire is 17 cm long, and has a radius of 11 mm. The thick wires are made of copper, which has 8.36e+28 mobile electrons per cubic meter, and an electron mobility of 0.00434 (m/s)/(V/m). The Nichrome wire is 8 cm long, and has a radius of 5 mm. Nichrome has 9e+28 mobile electrons per cubic meter, and an electron mobility of 7e-05 (m/s)/(V/m). Copper Copper Nichrome What is the magnitude of the electric field in the thick copper wire? V/m What is the magnitude of the electric field in the thin Nichrome wire? V/m
A 2.0 cm long tungsten filament in a florescent light bulb has a radius of 0.3 mm. Assume constant 20 degree Celsius temperature during operation of the light bulb. Given that the light bulb is connected to a 6.0 volt battery, calculate the current through the wire. A 10 Ohm resistor is now connected in parallel with the light bulb in the circuit with the same battery. What is the new current in the circuit? What happens to the circuit if the temperature goes beyond 20 degrees?
Three resistors, R1= 30 Ω, R2= 77 Ω, and R3=R, are connected in parallel with a 12 V battery. A) The total current flowing through the battery is 0.88 A. Find the value of resistance R. Express your answer using two significant figures. B) Find the current through each resistor. Enter your answers numerically separated by commas. Express your answers using two significant figures.
In the circuit shown in the diagram below, two thick wires connect a 1.7 volt battery to a Nichrome (NiCr) wire. Each thick connecting wire is 17 cm long, and has a radius of 11 mm. The thick wires are made of copper, which has 8.36e+28 mobile electrons per cubic meter, and an electron mobility of 0.00434 (m/s)/(V/m). The Nichrome wire is 8 cm long, and has a radius of 2 mm. Nichrome has 9e+28 mobile electrons per cubic meter, and an electron mobility of 7e-05 (m/s)/(V/m). [Copper What is the magnitude of the electric field in the thick copper wire? ]V/m What is the magnitude of the electric field in the thin Nichrome wire? v/m Nichrome Copper
An electric device draws 7.50 A at 240 V. Part A If the voltage drops by 11 % , what will be the current, assuming nothing else changes? Express your answer using two significant figures. ΑΣφ ? I = A Submit Request Answer Part B If the resistance of the device were reduced by 11 % , what current would be drawn at 240 V? Express your answer using two significant figures. ΑΣφ ? I = A Submit Request Answer Drovid.
A conducting cylinder has length 36 mm and radius 17 mm. The conductor is then reshaped into a smaller cylinder, a quarter of the original length, and half that of the original diameter. The conductivity of the material is 6x107/Ω.m. Enter your answer in scientific notation with 2 significant figures. Please calculate the resistance for the reshaped conductor
Two copper wires (call them A and B) both have length 19.0 m but wire A has a radius 7.045 mm and wire B has a radius 2.668 mm. What is the ratio of the resistances of the two wires? The resistivity of copper is 1.68x10-8 Ω/m. Report your answer to three decimal places.
V 1 , V 2 , V 3 , and I1 , I2 , I3 apply to the respective resisters. V C and Q refer to the capacitor's voltage and charge. U C refers to the capacitor's stored energy (electric potential energy). If VC = 6 volts, calculate Q in μ C.
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV₁ = 1.2 V, the middle resistor has a resistance of R = 64, and the last resistor has a voltage drop AV₂ = 1 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. AV, ww 3.0 V 4.5 V ww ΔV, ww R