Answered: The current is in the 30 mH inductor is…

The current is in the 30 mH inductor is 10cos (10 000t +30°) m A. Calculate; a) The inductive reactance b) The impedance of the inductor

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: 5 Q4. Determine the value of collector current and collector-to- emitter voltage for the voltage…

Q: 1.88 V 2.13 V the approximate value of VGs of Figure 56. 32K 750 KG 1-9 V 4-8 mA DI KO 0.68 k Figure…

Q: 21 Write the voltage v,(t) = 4 cos 2t in phasor form. Write the impedance of ¾ H inductor and a…

A: We convert the given circuit into phasor domain to find v(t) .

Q: 3- Implement f(a,b,c,d) = m(0,1,5,6,7,9,10,15) by using 4 multiplexer and a,b as a select line.

Q: 3. Calculate the following: a) voltage drop across Rs; b) current flow through Rs; and c) power…

A: Circuit diagram is given as,

Q: Example For the system shown in the fig below find the output C(s) R1(s) G1(s) Fon R2(s) G2(s) Fcn2…

A: To find the output C(s) for the given system

Q: need now thanks

A: In this question we need to find a current in the given circuit at t = 1 second

Q: 3. Find Thevenin's equivalent circuit for the circuit shov 3 b www 100 V +ıllıl+ www 12

Q: An Amplitude Modulation (AM DSBFC) radio broadcasting station with its carrier frequency of 750 kHz…

Q: Problem # 2 A solenoid that is 100.0 cm long has a cross-sectional area of 10.0 cm². There are 500…

A: Given: A solenoid with Length, L=100.0 cm Cross sectional area, A=10.0 cm2 Turns, N=500 Current,…

Q: 1. MOV SI,DI is example of - 2. MOV AL, 'G' is an example of ---- -addressing mode. -----addressing…

A: 1. Answer: Direct addressing mode. Explanation: Here the data prsesnt in DI register is directly…

Q: Q1/ For the following network: (a) write the mesh equations. (b) find the current Is through the…

Q: For a nonlinear amplifier and the following parameter, determine: a) Input SNR(dB) b) Output SNR(dB)…

Q: Find the current i 30 cos 3t v. the circuit using nodal analysis. V₁ V2 m 0.5H 2012 0.5H in 1. < TI…

Q: A carrier wave is AM modulated by 3 sine waves of modulation indices of 0.3, 0.4 and 0.5…

A: Given, Modulation indices m1=0.3m2=0.4m3=0.5 Total power, PT=70 W

Q: gure 1 illustrates a BJT amplifier with voltage gain of -115. a) Identify the capacitors in Figure…

A: BJT as Amplifier : The three fundamental BJT amplifier designs are known as common emitter,…

Q: Q2) The switch in following circuit has been closed for a long time, and it opens at t = 0. Find…

A: We need to find out the voltage across capacitor in given circuit

Q: Q3: 500 kVA is given an open circuit test from which the iron loss is found to be 3.5k W. A short…

Q: Multiple choice questions: 1- A voltages of 50Hz transformer are 1500 V on primary and 600 V on the…

Q: semi-log paper.

A: As per guidelines, allowed to answer first question and post the remaining in the next submission.

Q: 1- Construct 8 x 1 multiplexer by using 2 x 1 multiplexer 2

Q: 1- The efficiency of a 6600/384V, 200kVA, 1-phase transformer is 98% at full load 0.8 power factor…

Q: B. The vector q =(4,-2, 1) ends at the point P=(7,-7,2). At what point does the vector start?

Q: Example2/ Draw the vand is as a function of time when the switch on at t=0 ww R3 S2 Vs Ro Rr=00 ✓ -E

A: In this question we need to draw the voltage Vs and current is as a function of time.

Q: te of charge to 67% state of charge. The cell has a constant internal resistance of 0.01 and…

A: The formula is given as, Current: I=dqdt Heat: H = I2Rt

Q: 1- Hi, we -------- Muna and Nuha. What is your name? a- are b- is c-am

Q: Using superposition, determine the current through the inductance X for each network of Fig. 18.109.…

Q: Classify the power semiconductor devices based on its number of terminals and types of carrier…

A: Semiconductor devices are a part and parcel of the electronics industry. These devices also known as…

Q: Determine the approximate value of source voltage (Vs) of the given circuit below. VDD 1MQ 20V 1.8kQ…

Q: Lightbulb A was found out to give 30.0W of power, producing the same brightness as lightbulb B…

A: Given,For lightbulb A-Power, PA=30 WLifetime, TA=9000 hoursCost, CA=229.0 phpFor lightbulb B-Power,…

Q: Question 4 An AC Voltage v(t) = 250 cos (100nt) is applied to the given circuit. ~ V (1) sine…

A: Brief description: For the given sinusoidal voltage function we need to derive peak, peak to peak ,…

Q: Convert the given the closed loop forward transfer function in figure 2 to state-space…

Q: - previous 4- If V1 = 400V and the wattmeter read 800W at no load test then the value of Ro is…

A: given V1 = 400 V and wattmeter read is 800 W at no load test.here we have to find the value of R0.

Q: Q.1(c) A system with an input signal, M() is shown in Figure Q.1(c). A low pass filter (LPF) with a…

A: The system is shown below, Where, The cut-off frequency of the low pss filter(LPF) is 10rad/sec.…

Q: R = 15 kΩ R₁ = 1 k www In Fig. 1 Rb www In 20 ΚΩ 18 ΚΩ + + €33.3 ΚΩ 30 ΚΩ ww *, 547 ΚΩ 20 ΚΩ ww d De…

Q: otball now. Goodbye

A: To choose the correct form as,

Q: 1. A source voltage of an AC series RLC circuit is 120 V. The circuit consists of the ff.…

A: 1. A source voltage of an AC series RLC circuit is : Vs=120 VoltR=20 ΩXL=40 Ω so, ZL=jXL=j40…

Q: In the given circuit below, determine the total resistance. 24V A) 1.60 ohms B) 2.06 ohms 3.23 ohms…

Q: 2. A half-circle wave has a maximum value of 100 volts. Determine its rms effective voltage.

A: NOTE:- As per our company policy, experts are allowed to answer only 1 Question at a time, so only…

Q: 21 Write the voltage v,(t) = 4 cos 2t in phasor form. Write the impedance of ¾ H inductor and a…

A: In this question we need to a impedance of inductor and capacitor and voltage v(t)

Q: Q1/ Draw the bode plot below on the semi-log paper and find GM and PM for G(s)H(s) = 1…

A: The bode plot can be used to analyse the stability of the system in frequency domain.

Q: Consider three electrical loads of equal resistance 30 Ohms connected in parallel to an electrical…

Q: Electrical Engineering assume a switch connects 24 stations. assume each link operates a rate of 20…

A: Given: A switch connects 24 stations. Each link operates at a rate of 20 Mbps except for one station…

Q: How can you improve the spectrum resolution?

A: Given We need to enumerate how can we improve spectral resolution. Please find the below…

Q: a. r'e b. Rin Base c. Rin Total d. A (The ac voltage gain) 10 µF V₂0H M 22 V 56 ΚΩ 8.2 ΚΩ 1.5 ΚΩ…

Q: 6) The voltage across a 3 uF capacitor is shown below. Plot and determine the current waveform. v(t)…

Q: 1. An inductive coil having a 30 om resistance and unknown inductance is connected in parallel with…

Q: 3- Implement f(a,b,c,d) =Em(0,1,5,6,7,9,10,15) by using 4 multiplexer and a,b as a select line.

Q: Simplify the following using K-map: a) Y = W'XYZ + WX'YZ + WYZ+X'YZ

A: In this question we use k map to simplify the given Boolean expression

Q: Q3: For the circuit shown in figure (3). Find v, and to ?

Question

The current is in the 30 mH inductor is 10cos (10 000t +30°) m A. Calculate;
a) The inductive reactance
b) The impedance of the inductor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
List the five capacitor replacement rules.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor is connected in parallel with a load of S= 6000 VA, and pf-0.8 lag. The load is operating at 180 V and a frequency of 60 Hz. Calculate the capacitance value that will correct the power factor to pf%3D1. Select one: O a. None of them O b.0.47 mf O c.0.295 mf O d. 0.354 mf