The experimental values of the partial molar volume of a salt in water are found to fit the expression vB = 5.117 + 19.121x1/2, where vB = VB/(cm3 mol−1) and x is the numerical value of the molality of B (x = b/b⦵). Use the Gibbs–Duhem equation to derive an equation for the molar volume of water in the solution. The molar volume of pure water at the same temperature is 18.079 cm3 mol−1.

Q: The excess Gibbs energy of a certain binary mixture is equal to gRTx(1 − x) where g is a constant…

A: n

Q: At 90 °C the vapour pressure of toluene (methylbenzene) is 53 kPa and that of o-xylene…

A: Given : total pressure = 0.5 atm  Vapour pressure of pure toluene = 53 KPa and vapour pressure of…

Q: The solubility of an ionic solid in water is quantified by this expression:   Ksp   Kc   Keq   Ka…

A:

Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 0.50 mol C6H14 (hexane) is mixed…

A: The mole fraction of hexane and heptane is calculated as shown below. The mole fraction of hexane is…

Q: Based on the student's observation, calculate the dissolution enthalpy of BaCl,(s) in kJ/mol.

A:

Q: Explain the origin of osmosis in terms of the thermodynamic and molecular properties of a mixture.

A: ANSWER IS DISCUSSED BELOW :

Q: The vapour pressure of 2-propanol is 50.00 kPa at 338.8 °C, but it fell to 49.62 kPa when 8.69 g of…

A:

Q: The vapour pressure of water and propanol are 71.9 and 74.0 torr respectively. The vapor pressures…

A:

Q: Predict the ideal solubility of lead in bismuth at 280 °C given that its melting point is 327 °C and…

A:

Q: The excess Gibbs energy of solutions of methylcyclohexane (MCH) and tetrahydrofuran (THF) at 303.15…

A:

Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 1.00 mol C6H14 (hexane) is mixed…

A: The formula used to calculate the Gibbs free energy of mixing is: ∆Gmix = nRT×(XA × ln XA + XB × ln…

Q: 1. The vapor pressure of pure benzene is 12.8 kPa and the vapor pressure of benzene with toluene at…

A:

Q: A solution is prepared by dissolving 2.33 g of C60 (buckminsterfullerene)in 100.0 g of toluene…

A:

Q: The vapour pressure of dichloromethane at 24.1 °C is 53.3 kPa and its enthalpy of vaporization is…

A:

Q: An excess amount of Ba(NO3)2 was added to 2 liters of water at 25 oC until the solution is…

A:

Q: Two liquids A and B mix to form an ideal solution. Consider A to be the solvent (majority component)…

A: The Gibbs free energy is a thermodynamic quantity which is used to calculate the maximum amount of…

Q: The standard molar entropies of water ice, liquid, and vapour at 298 K are 37.99, 69.91, and 188.83…

A: Given, The standard molar entropies of water ice, liquid, and vapour at 298 K are 37.99, 69.91 and…

Q: 5B.11(a) The vapour pressure of pure liquid A at 300K is 76.7kPa and that of pure liquid B is…

A:

Q: The enthalpy of fusion of anthracene is 28.8 kJ mol−1 and its melting point is 217 °C. Calculate its…

A: Introduction: Solubility: It is defined as the maximum amount of solute that can be dissolved in the…

Q: Benzene and toluene are almost ideal solutions. The boiling point of pure benzene is 80. 10c…

A:

Q: Calculate the solubility of 1,4-dibromobenzene in benzene at 25.000C and at 45.000 assuming that…

A: Given that, The enthalpy of fusion of 1,4-dibromobenzene is 20.39 kJ/mol and its melting point is…

Q: Explain the origin of colligative properties.

A: To study the colligative properties

Q: The vapour pressure of benzene is 53.3 kPa at 60.6 °C, but it fell to 51.5 kPa when 19.0 g of a…

A: From the given data, at 60.6 °C, the vapour pressure (po) of pure benzene is 53.3 kPa. On adding the…

Q: The molar conductivities of 0.01 M solution of sodium chloride, potassium chloride and potassium…

A: Molar conductivity of NaCl, KCl, K2SO4 from which molar conductivity of Na2SO4 is to be determined.

Q: What are the most important differences between the phase diagram of a pure solvent and the phase…

A: Given statement, Important differences between the phase diagram of a pure solvent and the phase…

Q: relative to the unmixed gases of a) a mixture of 10 mol of A and 10 mol of B; b) a mixture of 10 mol…

A: Given details: The temperature of pure gas A and B = 25°C  Pressure…

Q: Estimate the vapour pressure of sea water at 20 °C given that the vapour pressure of pure water is…

A:

Q: 3. The experimental values of the partial molar volume of salt B at 298 K are found to fit the…

A:

Q: Explain the concept of partial molar volume, and justify the remark that for a binary solution, the…

A: We need to explain the concept of partial molar volume, and justify the remark that for a binary…

Q: The vapour pressure of water in a saturated solution of calcium nitrate at 20 °C is 1.381 kPa. The…

A: Given: The vapor pressure of the saturation solution of calcium nitrate=1.381 kPa The vapor pressure…

Q: Determine the (i) Gibbs energy, (ii) entropy, and (iii) enthalpy of mixing when 2.5 mol toluene is…

A: Ideal mixing of solution is defined as, when solute- solute and solvent-solvent interaction has the…

Q: The osmotic pressure of an aqueous solution at 300 K is 120 kPa. Estimate the freezing point of the…

A: Given data, The osmotic pressure of the aqueous solution = 120 kPa Temperature = 300 K The freezing…

Q: The vapour pressures of benzene and methylbenzene at 20 °C are 75 Torr and 21 Torr, respectively.…

A: Given data: Vapour pressure of benzene (POA) = 75 torr Vapour pressure of methyl benzene (POB) = 21…

Q: Formulate the relationship between elevation of boiling point and lowering of vapour pressure and…

A:

Q: Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A…

A: The lever rule can be defined as a rule which is used for the determination of the mole fraction of…

Q: Suppose that 2.0 mol N, at 2.0 atm and 25°C and 4.0 mol H, at 3.0 atm and 25°C are mixed at constant…

A: Gibbs free energy calculated as given below.

Q: A and B form ideal solution. If mole fraction of A in the solution is xĄ, what will be its mole…

A: Raoult's law: The partial vapor pressure of component in vapor phase is equal to the multiplication…

Q: 25.124 g of a non-volatile solute is dissolved in 355.0 g of water.The solute does not react with…

A: The main difference between the two parts is the nature of solute. In first case, solute is non…

Q: What is the vapor pressure of benzene when .75 mol of naphthalene is mixed with 1.00 kg of benzene?…

A: MC6H6= 78 g/mol nnapththalene  = 0.75 mol. W C6H6 = 1 Kg = 1000 g nC6H6 = W C6H6/MC6H6= 1000g/(78…

Q: The following temperature-composition data were obtained for a mixture of octane (O) and…

A: In the given question,  temperature-composition data  for a mixture of octane (O) and methylbenzene…

Q: Consider the following two temperature vs composition phase diagrams of two ideal binary mixtures -…

A: The phase diagram is the graphical representation of the liquid, vapour, and solid phases that…

Q: The enthalpy of fusion of anthracene is 28.8 kJ mol−1 and its melting point is 217°C. Calculate its…

A: The ideal solubility in terms of mole fraction is,Given,The enthalpy of fusion of Anthracene is 28.8…

Q: The enthalpy change accompanying the dissolution of a solute B in 1000 g water is dependent on the…

A: Given - Delta H = 40n + 30n2 were, n= moles of B Delta H = enthalpy change for dissolution of B in…