The heat capacity of air at room temperature and pressure is approximately 21 J×mol-1×K-1. a) How much energy is required to raise the temperature of a room dimensions 5.5 m x 6.5 m x 3.0 m by 10°C from room temperature (298.15 K) assuming ideal behavior? b) How long will it take a heater rated at 1.5 kW to achieve that increase if 1 W = 1 J×s-1 (assuming no loss)?

The heat capacity of air at room temperature and pressure is approximately 21 J×mol-1×K-1. a) How much energy is required to raise the temperature of a room dimensions 5.5 m x 6.5 m x 3.0 m by 10°C from room temperature (298.15 K) assuming ideal behavior? b) How long will it take a heater rated at 1.5 kW to achieve that increase if 1 W = 1 J×s-1 (assuming no loss)?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 95P: (a) What is the rate of heat conduction through the 3.00-cm-thick fur of a large animal having a I...

See similar textbooks

Similar questions

A baking dish is removed from a hot oven and placed on a cooling rack. As the dish cools down to 31.0°C from 189°C, its net radiant power decreases to 13.0 W. What was the net radiant power of the baking dish when it was first removed from the oven? Assume that the temperature in the kitchen remains at 24.0°C as the dish cools.
A classroom has dimensions 8.00 m x 10.00 m x 3.00 m. A 1000 W electric space heater is being used to warm the room from 5.00°C to 20.00°C on a cold morning. If the density of air is 1.29 kg/m°, and the specific heat capacity of air is 1004 J/(kg-K), how long will it take to heat the room? Assume no loss of thermal energy to the surroundings. A) 1.30 minutes B) 241 minutes C) 45.3 minutes O D) 77.7 minutes
Consider the thermodynamic process, A->B->C->A shown above. The heat absorbed during A->B is 591J. If the change in internal energy during B->C is 4146J, What is the change in internal energy in SI units during C->A? Express only the number of your answer with 4 significant figures.
m = 0.593 kg of methanol in atmospheric pressure is heated with an electric heater from T₁ = 30.2 °C to its boiling point. After the heating my methanol is vaporized. Heating and vaporizing takes t = 450.41 s with n=0.59 heater's efficiency. What is the volume of methanol? V = What is the energy required for heating? E₁ = 1 kJ m³ Your last answer was interpreted as follows: 1 What is the energy required for vaporizing? Ev = 1 kJ Your last answer was interpreted as follows: 1 What is the power of the heater? P = 1 с Your last answer was interpreted as follows: 1 Your last answer was interpreted as follows: 1 What is the electr. energy needed for heating and vaporizing? Eε = 1 kJ Your last answer was interpreted as follows: 1 h Do not leave any fields blank. If you don't know the answer, insert 1 for example. Insert the answer with 3 significant digits without rounding the answer. Constant P Tb Value Unit 2.53 1165 786.3 64.7 °C umges Quantity heat capacity kg K kJ kW kg kg LAN Symbol h…
At a certain location, the solar power per unit area reaching Earth's surface is 200 W/ m^2, averaged over a 24-hour day. If the average power requirement in your home is 3 kW and you can convert solar power to electric power with 10 % efficiency, how large a collector area will you need to meet all your household energy requirements from solar energy? (Will a collector fit in your yard or on your roof? ).
A 2.0 m2 solar panel is fully illuminated by sunlight. Assume the sunlight has a power density of 0.10 J/cm2 -s. a) If the efficiency of the solar panel is 16%, how much electrical energy will it deliver in one hour? b) If this energy is stored in a battery, how long will it keep a 100 W incandescent lightbulb burning if the bulb has an efficiency of 2.6%. (Efficiency of the lightbulb is the light out - - 100 W - to the electrical power in.)
A 361-W heat pump operates between the ground, whose temperature is 6.2, and the interior of a house at 20.1. What is the theoretical maximum amount of heat per hour that the heat pump can supply to the house? Express your answer in MJ, to at least one digit after the decimal point.
No heat losses exist in this task. Hampus is concerned about the expensive electricity price. Stingy as he is, he tells his daughter that she is not allowed to bathe in the bathtub. Assume that the water temperature entering the house is 5.0°C. For the bath to be pleasant, the bath water must be 38°C. a) How much energy is needed to heat the water to 38°C in a bathtub of size 0.150 m³? b) How long does it take for the water heater to heat 0.150 m³ of water from 5.0°C to 38°C if it has an output of 1.0kW and an efficiency of n = 0.80 ? c) How much does a bath cost if the electricity price for 1 kWh is $5? Hampu's daughter does not care about the electricity price, so she pours a bath when Hampu is not at home. Unfortunately, the bath water is 45°C, so she adds cold water until the water is 38°C. d) How much 5°C cold water does she need to fill in the bathtub for the mixture to become 38°C? What does the third law of thermodynamics sound like?
A typical coal-fired power plant burns 340 metric tons of coal every hour to generate 2.5 × 106 MJ of energy. One metric ton has a mass of 1000 kg and a metric ton of coal has a volume of 1.5 m^3. The heat of combustion is 28 MJ/kg. What is the power plant’s efficiency?
250 students sit in an auditorium listening to a physics lecture. Because they are thinking hard, each is using 125 W of metabolic power, slightly more than they would use at rest. An air conditioner with a COP of 5.0 is being used to keep the room at a constant temperature. What minimum electric powermust be used to operate the air conditioner?
How much heat per second (H = Q/ΔT) is lost from the house due to heat conduction? The answer in watt must be rounded to the nearest 10 W.
A certain coal-fired power plant has a rated power capacity of P = 950 MW. The output of this plant is W = 0.25QH, where QH is the energy input as heat from the hot reservoir. a)Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant. b)If the power plant operates for a full day at its rated capacity, how much energy QH in MJ is needed? c)If, on average, one ton of coal contains Q = 25 GJ of energy, how many tons nH of coal would the plant need to operate for a day at its rated capacity?