The ratio of stagnation temperature at the exit and entry of a combustion chamber is 3.75. If the pressure, temperature and flow Mach number at the exit are 2.5 bar, 1000°C and 0.9 respectively, determine (i) Mach number, pressure and temperature of the gas at entry, (ii) total heat supplied per kg of gas, and (iii) the maximum heat that can be supplied. Take y= 1.4 and = 1.2 kJ/kg K.

The ratio of stagnation temperature at the exit and entry of a combustion chamber is 3.75. If the pressure, temperature and flow Mach number at the exit are 2.5 bar, 1000°C and 0.9 respectively, determine (i) Mach number, pressure and temperature of the gas at entry, (ii) total heat supplied per kg of gas, and (iii) the maximum heat that can be supplied. Take y= 1.4 and = 1.2 kJ/kg K.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Saturated steam enters a converging–diverging nozzle at 1.75 MPa, 10 percent moisture, and negligible velocity, and it exits at 1.2 MPa. The nozzle exit area is 28 cm2. i) Determine the throat area, exit velocity, mass flow rate, and exit Mach number if the nozzle is isentropic. ii) Determine the throat area, exit velocity, mass flow rate, and exit Mach number if the nozzle is isentropic and has an efficiency of 92 percent.
For an ideal gas obtain an expression for the ratio of the speed of sound where Ma = 1 to the speed of sound based on the stagnation temperature, c*/c0.
Consider gas flow through a converging–diverging nozzle. Of the five following statements, select the one that is incorrect: (a) The fluid velocity at the throat can never exceed the speed of sound. (b) If the fluid velocity at the throat is below the speed of sound, the diversion section will act like a diffuser. (c) If the fluid enters the diverging section with a Mach number greater than one, the flow at the nozzle exit will be supersonic. (d ) There will be no flow through the nozzle if the back pressure equals the stagnation pressure. (e) The fluid velocity decreases, the entropy increases, and stagnation enthalpy remains constant during flow through a normal shock.
Which of the following statement is FALSE? A During fluid flow through many devices such as nozzles, diffusers, and turbine blade passages, flow quantities vary primarily in the flow direction only B) For an ideal gas, temperature decreases with increase in velocity. (C) Mach number depends on the speed ofsound, which depends on the state of the fluid. (D) In a converging nozzle, the velocity of the gas stream will never exceed the sonic velocity, though in a converging- diverging nozzle supersonic velocities may be obtained in the diverging section (E) In adiabatic compressible flow in a conduit of constant crosssection, the Mach number can exceed 1.0
3. Consider a vehicle moving at a velocity of 1,000 mps through air and hydrogen. The specific gas constant of hydrogen is 4,157 ???−?⁄. Assume T = 300 K. a. Calculate the Mach number of the vehicle in air. b. Calculate the Mach number of the vehicle in hydrogen.
As an airplane flying with constant velocity moves from a cold air mass into a warm air mass, how does the Mach number change? increases decreases remains the same
1- Air enters a nozzle at 0.2 MPa, 350 K, and a stagnation velocity. Assuming isentropic flow, determine the pressure and temperature of air at a location where the air velocity equals the speed of sound. What is the ratio of the area at this location to the entrance area?
Question 22 Air enters a nozzle at 200 KPa, 360 K and a velocity of 180 meter per second . Assuming isentropic or adiabatic flow, if the pressure and temperature of air at a location where the air velocity equals the speed of sound, the Mach number at the nozzle inlet is Blank 1. The properties of air are : k = 1.4; Cp = 1005 J/kg-K; R = 287 J/kg-K. ***EXPRESS YOUR ANSWER in TWO (2) DECIMAL PLACE and WITHOUT UNITS**** Blank 1 Add your answer
Consider a gas with a specific heats ratio of 1.48 at the Mach number of 6.5. Determine the strength (the pressure ratio across the shock, p2/p1) of the normal shock.
An ideal gas with k = 1.33is flowing through a nozzle such that the Mach number is 1.6 where the flow area is 45 cm2. Approximating the flow as isentropic, determine the flow area at the location where the Mach number is 0.8.
Under what circumstances does H₂O exist as superheated vapour at 18°C? (pressure < 0.02063 bar absolute)
For a problem involving mass flow for ideal gas helium, what value would you use for R, the gas constant? Show the computation required to find this value. (Textbook Moran & Shapiro - Fundamentals of engineering thermodynamics eighth edition)