The wall of a refrigerator is constructed of fiberglass insulation (k = 0.035 W/m·K) sandwiched between two layers of 1-mm-thick sheet metal (k = 15.1 W/m·K) The refrigerated space is maintained at 2°C, and the average heat transfer coefficients at the inner and outer surfaces of the wall are 4 W/m2 .K and 9 W/m2 .K, respectively. The kitchen temperature averages 24°C. It is observed that condensation occurs on the outer surfaces of the refrigerator when the temperature of the outer surface drops to 20°C. Determine the minimum thickness of fiberglass insulation that needs to be used in the wall in order to avoid condensation on the outer surfaces.

Q: There are 3 people in a hemispherical house with an inner radius of 1.8 m, designed for short-term…

A:

Q: Heat is generated in a 2.0-cm-square copper rod at the rate of 30 MW/m³. The rod is exposed to a…

A: Given data: a=2.0 cmQ˙=30 MW/m3T∞=25°Ch=5 kW/m2 Need to determine the surface temperature of the…

Q: Question 2.2 Two 3 m long and 0.4 cm thick cast iron (k= 52 W/m-K) steam pipes, of outer diameter 10…

A: Given data

Q: Consider a person standing in a breezy field at 10°C. Determine the total rate of heat transfer from…

A: In heat transfer analysis, the rate of change of state is evaluated by calculating the rate of heat…

Q: 2. Two 4-m-long and 0.4-cm-thick cast iron (k = 52 W/m·K) steam pipes of outer diameter 10 cm are…

A: givenDi=9.2cm  =0.092mDO=10cm =0.10mso Ai=πDJL =π×0.092×8 =2.312m2A0=πDOL =π×0.1×8 = 2.513m2

Q: A hot surface at 100 °C is to be cooled by attaching 3-cm-long, 0.25-cm-diameter aluminum pin fins…

A:

Q: On a multi-layered square wall, the thermal resistance of the first layer is 0.005 ° C / W, the…

A: The thermal resistance of first layer is R1=0.005°C/W. The thermal resistance of second layer is…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

A: Given Data        Ab=0.7×0.7         h =1m        Ti =6∘ c       Tal =10mm      Tpol = 30mm      hi…

Q: Clothing made of several thin layers of fabric with trapped air in between, often called ski…

A: Consider the thermal circuit shown below for the 5 layered jacket. Here, The total resistance for…

Q: A 2-m × 1.8-m section of wall of an industrial furnace burning natural gas is not insulated, and the…

A: Answer: The thickness of the insulation that needs to be used is 4.68 cm.

Q: Calculate the hourly heating load of a house in which all exterior surfaces have a thermal…

A: Given   Thermal resistance, R = 14 ft2.h.oF/Btu           Temperature, T1 = 65oF…

Q: .A journal bearing is to be used for a centrifugal pump where the shaft diameter is 50 mm and the…

A: Given that, Shaft diameter = D = 50 mm Bearing length = L = 80 mm Ambient temperature = T∞=20 °C…

Q: A wall of 25 cm thickness and 10 m2 surface area is to be constructed from a material which has an…

A:

Q: A 6.35 m of gylindrical tube whose inner surface is maintained at a temperature of T = 5°C is…

A: given data;lenth of the tube(l)=6.35minner radius(ri)=25mm=0.025mouter radius(ro)=75mm=0.075mthermal…

Q: A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1 m was…

A:

Q: A tube having a cylindrical shape of length equals to 100 m and diameter equals to 13 cm passes…

A: Length of the cylinder = 100m diameter of the cylinder =13cm surface temperature =110c room…

Q: A 3-mm-diameter and 5-m-long electric wire is tightly wrapped with a 2-mm- thick plastic cover…

A:

Q: A plane wall surface at 200°C is to be cooled with aluminum pin fins of parabolic profile with blunt…

A: Given data as per question Plane wall surface temperature = 2000c Length of fin = 25 mm Diameter =4…

Q: The room of a dwelling receives energy from the sun during the day. The roof temperature becomes too…

A: Given Data  Roof temperature, TR= 65°C Ambient temperature, Ta=20°C Length of the roof, L=5m

Q: 2. An industrial freezer is designed to operate with an internal air temperature of -15°C when the…

A:

Q: A transformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10…

A:

Q: Ql: A composite wall is made of 10 mm and 16 mm layers of materials of thermal conductivity 10 and…

A:

Q: Consider a jacket made of five layers of 0.1-mm-thick synthetic fabric (k = 0.13 W/m-°C) with…

A:

Q: Hot water is to be cooled as it flows through the tubes exposed to atmospheric air. Fins are to be…

A: The fin are used to enhance the heat transfer rate by increasing the surface area. The fin are…

Q: A refrigerator door of area 0.6 sq.m consists of 25 mm of insulation on top of a thin metal sheet.…

A: Qtotal=Qconduction+(Qconvection)in+(Qconvection)outQtotal=∆T1hAin+tkAcond+1hAoutQtotal=20-0110×0.6+0…

Q: A refrigerator door of area 0.6 sq.m consists of 25 mm of insulation on top of a thin metal sheet.…

A: given; →area(A)=0.6m2→insulation thickness(t)=25mm=0.025m→inside heat transfer coefficent…

Q: A 3-m long and 0.4-cm-thick cast iron (k= 52 W/m ·°C) steam pipes of outer diameter 10 cm are…

A: Given data

Q: Required information A 16-m x 8.5-m section of wall of an industrial furnace burning natural gas is…

A: Given data as per question Temperature of surface room=300cTemperature of outer surface of this…

Q: It is required to insulate a kitchen oven with cork board (k = 0.043 W/mK) so that the heat losses…

A: Given Data :  Thermal Conductivity k = 0.043 W/mK Heat loss Q = 400 W/m2 Inner temperature Ti = 225…

Q: A transformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10…

A:

Q: Circular fins of uniform cross section, with diameter of 10 mm and length of 50 mm, are attached to…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: = A hot surface at 100°C is to be cooled by attach- ing 3-cm-long, 0.25-cm-diameter aluminum pin…

A: Introduction: Fins are utilized in many applications to improve heat transfer from surfaces. The fin…

Q: Hot water at an average temperature of 70°C is flowing over a 15-m section of a cast iron pipe (k =…

A: Given: Hot water temperature is 70°C. Length of pipe is 15 m. Thermal conductivity of CI pipe is 52…

Q: A house is to be maintained at 21°C DBT and 50% RH, while the outdoor conditions are -30°C DBT and…

A:

Q: Consider a 1.5-m-high electric hot-water heater that has a diameter of 40 cm and maintains the hot…

A:

Q: A steam pipe 200mm in diameter passes through a large basement room. The temperature of the pipe…

A:

Q: The walls of the refrigerated storage room are 10 m long and 3 m high and constructed with 90 mm…

A: Given: The length of the wall of the refrigerated storage room is L=10 m, The height of the wall of…

Q: H.W. Q:A hot surface at 100°C is to be cooled by attach- ing 3-cm-long, 0.25-cm-diameter aluminum…

A: Given data:

Q: 16.- Consider a person standing in a breezy room at 22°C. Determine the total rate of heat transfer…

A:

Q: 2. A 15-cm X 20-cm hot surface at 85°C is to be cooled by attaching 4- cm-long aluminum ( k = 237…

A:

Q: .5 cm, respectively. The pipe is covered with 3-cm-thick glass wool insulation (k = 0.038 W/m⋅K).…

A:

Q: 2. A hot surface at 100°C is to be cooled by attaching 3-cm-long, 0.25-cm-diameter aluminium pin…

A:

Q: Q30) A 4-mm-diameter and 5-m-long electric wire is tightly wrapped with a l-mm thick plastic cover…

A: Given: Diameter of the wire D1=4mmDiameter of the wire after wrapping D2=4+2t=4+2=6mmThermal…

Q: Consider a person standing in a breezy room at 20°C. Determine the total rate of heat transfer from…

A: Given: Room temperature is 20°C. Exposed area of the person is 1.6 m2. Surface temperature of the…

Q: QUESTION 1 A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base and height 1…

A:

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.