Answered: The water tank in the attached diagram…

Name: Please Aspa The water tank in the attached diagram has an exitvelocity
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: Please Aspa The water tank in the attached diagram has an exitvelocity of 8 m/s at the tank outlet and an outletdiameter of 4 cm. What will be the tension in the cable?-D=4m-Do = 4 cm8 m/s60°Cable

Science

Physics

The water tank in the attached diagram has an exit velocity of 8 m/s at the tank outlet and an outlet diameter of 4 cm. What will be the tension in the cable? -D=4m- Do=4 cm 8 m/s 60° Cable

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter10: Motion In A Noninertial Reference Frame

Section: Chapter Questions

Problem 10.21P

See similar textbooks

Similar questions

A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
Weightless gate AB is 1.5m wide into the paper and opens to let fresh water out when the ocean tide is falling. The hinge at A is 0.6m above the freshwater level. Find h when the gate opens. Tide range 3m Sea Water S=1.025 Stop
The lamina shown is a quarter circle with radius 4 cm and mass M kg. Find the angle that AB makes with the vertical when a mass of 0.5M kg is attached to C and the lamina is freely suspended from B. В 4 cm A
1. The diameter and height of a steel cylinder are 100 mm and 200 mm, respectively. If the density of steel is 7850 kg/m?, determine the weight of the cylinder in Ibs. Ans. 27.18 Ib 2. The tension in cables AB and AC is 10 lb. Determine the magnitude of the resultant force vector acting at A due to the two cables. Ans. 14.14 Ib
The wing span of an Airbus A300 is 44.8 m.a) What area is swept out per second when the plane is in level flight at 250 m s-1?
In medicine, it is often important to monitor the blood flow in certain areas of the body. However, the movement of blood is difficult to monitor directly. Instead, some medical devices use the Hall effect, taking advantage of the fact that the blood flowing through a vein contains a considerable number of free ions. Model the vein in a patient's arm to be of rectangular cross section, as shown in the figure, with a width w=4.00 mm and height ℎ=3.35 mm. The entire section of the vein is immersed in a constant magnetic field of ?=0.0955 T, pointing horizontally and parallel to the width. A medical device constantly monitors the resulting Hall voltage. Suppose that medical precautions mandate that the speed of the blood flow for this particular component of the body should never drop below 21.40 cm/s. At what minimum Hall voltage VH, in millivolts, should the medical device be designed to trigger an alarm to the medical staff? ?H= mV
One end of a wire is attached to a ceiling, and a solid brass ball is tied to the lower end. The tension in the wire is 449 N. What is the radius of the brass ball?
A flange used to connect two pipes is shown in Figure Q3. Holes need to be drilled to fix it. Drilling should be done in two steps with each step 8 mm. Using absolute coordinate system and the parameters given in the table below, () Determine the coordinates of hole H=1
In medicine, it is often important to monitor the blood flow in certain areas of the body. However, the movement of blood is difficult to monitor directly. Instead, some medical devices use the Hall effect, taking advantage of the fact that the blood flowing through a vein contains a considerable number of free ions. В h Model the vein in a patient's arm to be of rectangular cross section, as shown in the figure, with a width w = 4.00 mm and height h = 3.65 mm. The entire section of the vein is immersed in a constant magnetic field of B = 0.0955 T, pointing horizontally and parallel to the width. A medical device constantly monitors the resulting Hall voltage. Suppose that medical precautions mandate that the speed of the blood flow for this particular component of the body should never drop below 15.80 cm/s. At what minimum Hall voltage VH, in millivolts, should the medical device be designed to trigger an alarm to the medical staff? VH = mV
How long will it take Guard A to wind in a lane? a. b. How long will it take Guard B to wind in a lane?
Question 1 Find the mass of the lamina occupying the region R={(x,y)eR²:x²+y²s 4,x< 0,y< 0} given that the mass density at each point is 6(x,y)=x². O A. 2 2n О В. З 4 T OC. 3 None of the other choices OD. O E. 4
The terminal velocity of a copper ball of radius 2.0 mm falling througha tank of oil at 20 oC is 6.5 cm s-1. Compute the viscosity of the oil at 20 oC. Density of oil is 1.5 ×103 kg m-3. density of copper is 8.9 × 103 kg m-3.