Three long, parallel conductors each carry a current of I= 1.96 A. The figure below is an end view of the conductors, with each current coming out of the page. Taking a = 1.25 cm, determine the magnitude and direction of the magnetic field at the following points. (a) point A magnitude HT direction toward the bottom of the page ✔✔ (b) point B magnitude HT direction toward the bottom of the page ✔✔✔ (c) point C magnitude direction no direction UT (

Three long, parallel conductors each carry a current of I= 1.96 A. The figure below is an end view of the conductors, with each current coming out of the page. Taking a = 1.25 cm, determine the magnitude and direction of the magnetic field at the following points. (a) point A magnitude HT direction toward the bottom of the page ✔✔ (b) point B magnitude HT direction toward the bottom of the page ✔✔✔ (c) point C magnitude direction no direction UT (

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter24: Magnetic Fields

Section: Chapter Questions

Problem 83A

See similar textbooks

Similar questions

When the current through a circular loop is 6.0 A, the magnetic field at its center is 2.0104 T. What is the radius of the loop?
A square loop whose sides are 6.0-cm long is made with copper wire of radius 1.0 mm. If a magnetic field perpendicular to the loop is changing at a rate of 5.0 mT/s, what is the current in the loop?
The magnitude of the magnetic field 50 cm from a long, thin, straight wire is 8.0T . What is the current through the long wire?
A long, straight wire of radius R caries a current I that is distributed uniformly over the cross-section of the wire. At what distance from the axis of the wire is the magnitude of the magnetic field a maximum?
The accompanying figure shows a cross-section of a long, hollow, cylindrical conductor of inner radius r1= 3.0 cm and outer radius r2= 5.0 cm. A 50-A current distributed uniformly over the cross-section flows into the page. Calculate the magnetic field at r = 2.0 cm. r = 4.0 cm. and r = 6.0 cm.
The current density in the long, cylindrical wire shown in the accompanying figure varies with distance r from the center of the wire according to J = cr. where c is a constant (a) What is the current through the wire? (b) What is the magnetic field produced by this current for r < R? For rR ?
A long, solid, cylindrical conductor of radius 3.0 cm carries a current of 50 A distributed uniformly over its cross-section. Plot the magnetic field as a function of the radial distance r from the center of the conductor.
A long, straight, horizontal wire carries a left-to-right current of 20 A. If the wire is placed in a uniform magnetic field of magnitude 4.0105 T that is directed vertically downward, what is tire resultant magnitude of the magnetic field 20 cm above the wire? 20 cm below the wire?
The magnetic field between the poles of a horseshoe electromagnet is uniform and has a cylindrical symmetry about an axis from the middle of the South Pole to the middle of the North Pole. The magnitude of the magnetic field changes as a rate of dB/dt due to the changing current through the electromagnet, Determine the electric field at a distance r from the center.
Sketch a plot of the magnitude of the magnetic field as a function of position r for a coax (Fig. P31.27).
A toroid with a square cross section 3.0cm3.0cm has an inner radius of 25.0 cm. It is wound with 500 turns of wire, and it carries a current of 2.0 A. What is the strength of the magnetic field at the center of the square cross section?
Two long coaxial copper tubes, each of length L, are connected to a battery of voltage V. The inner tube has inner radius o and outer radius b, and the outer tube has inner radius c and outer radius d. The tubes are then disconnected from the battery and rotated in the same direction at angular speed of radians per second about their common axis. Find the magnetic field (a) at a point inside the space enclosed by the inner tube r d. (Hint: Hunk of copper tubes as a capacitor and find the charge density based on the voltage applied, Q=VC, C=20LIn(c/b) .)