i need the answer quickly TUTORIAL PROBLEMS1. A3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is I-50/phaseand synchronous reactance is 30/phase. To what value will the terminal voltage rise when full-load atp.f. 0-8 lagging is switched off ?[13970 V]

TUTORIAL PROBLEMS 1. A3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The amature resistance is 1-5 /phase and synchronous reactance is 30 /phase. To what value will the terminal voltage rise when full-load at p.f. 0-8 lagging is switched off ? [13970 V]

TUTORIAL PROBLEMS 1. A3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The amature resistance is 1-5 /phase and synchronous reactance is 30 /phase. To what value will the terminal voltage rise when full-load at p.f. 0-8 lagging is switched off ? [13970 V]

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter31: Three-phase Alternators

Section: Chapter Questions

Problem 1RQ: What conditions must be met before two alternators can be paralleled together?

See similar textbooks

Related questions

Q: transfer function G(s) = X(s)/ F(s) Select one a. 5s2 b. 1/ 5s c. 1 / (5s2 ) d. 5s Which of the…

A: In this question we will write about transfer function of given system....

Q: Type of fuses and their discription

A: Solve the problem

Q: Root Draw The Complete k CS+5) GIS)H15)こ

Q: Given a model of the speed control for the electric motor in an electric powered vehicle with a…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of the Question at a time, so only Q.(a),…

Q: Consider the circuit shown in the figure, where the power received by the resistor R is 12.0 W. 5.00…

Q: Calculate the magnetic field intensity to produce a flux density of 100x10^-3 tesla at the center of…

A: We need to find out magnetic field intensity

Q: The Nyquist plot of a system is shown in figure below. The order of system is: Im Re O=0 00 = M

A: In this question, We need to choose order of the system? Nyquist system is given.

Q: 2.

Q: The Bode plot of unity feedback system is shwon in figure below O dB/dec +20 dB/dec -20 dB/dec -20…

A: In this question we will find unknown values of gain , a and b from given bode plot...

Q: 4. A 440 V three-phase three-wire system feed two balanced Y- connected loads. One load is an…

A: Since question 6 is not uploaded i solved 4 and 5

Q: 3. Determine the stability for the close-loop control system (in Fig. 1) PLANT CONTROLLER 0,5 Fig. 1…

A: In this question we need to check the given system is stable or unstable

Q: If the base line-to-line voltage of a 3-phase system is 4kv and the base 3-phase MVA is 40 MVA, then…

A: We need to find out impedance for given details

Q: Compile earthing of electrical installation system

A: The electrical transmission line is used for the transfer of electrical energy to the consumers,…

Q: A 200W, 230V, 50 Hz capacitor-start motor has the following winding constants Main winding Q7 :R =…

Q: B- D Figure 1- Boolean Circuit You are given the Boolean circuit in the figure above. 1) Convert…

Q: what is the schematic diagram of 5v dc-dc tension converter

A: 5 V DC-DC TENSION CONVERTER: All electronic circuits require a power supply. Let's say someone…

Q: Determine the value of input impedance (Z). 20 V 2.2 k2 390 k2 B= 140 I 1.2 k2 O 8.55 ohms O 10.12…

A: We need to find out input impedance for given circuit

Q: A 50HZ, 440V, 6pole, delta connected three phase induction motor, running at full load develops a…

Q: +VDD G) What is k? 3. For the circuit of figure, determine Ip, Vps and Vp. Ipon- 12 mA, Veson) = 6…

A: In this question, We need to determine the drain current, voltage VD and VDS ? We know drain…

Q: Which statements correcty describe dead time and its use in practical svitching circuits configured…

A: The switching circuits are also used for DC conversion and rectification purposes. The semiconductor…

Q: termine the overall gain, V,/V; of the circuit shown ow. What value of V; will result in V, = 150…

Q: A 0.8-H inductor is connected in series with a 7-ohm resistor. If the connection is energized from a…

Q: in electronics communication, if you choose a frequency in AM transmitter frequency, which will…

A: If we choose a frequency in AM transmitter frequency, which one will be chosen. The lower…

Q: 6. BJT is more linear than FET. Why? Explain 7. what is vas (off)? How could it effects the…

A: In this question we will write how BJT is more linear than FET... Note :- as per our guideline , I…

Q: Question 2 5Ω 2F 10 3F Figure 2.1 Consider the system shown in figure 2.1 (a) (b) (c) (d) (c) Obtain…

Q: Example 4.5 resistance of 100 2 and a full scale deflection of 10 mA into a multirange de voltmeter…

A: We need to find out resistance for given voltage range .

Q: 20 2420°v A 520 A 20 ji0 I-j10 5430°A 20 -ji0 Is e ll

A: given circuit Given circuit

Q: the amount of time these devices would need to be in operation before 1 million Coulombs of charge…

A: Given data, Charge is given Q=105 C (a) i = 0.0041 A Charge is given by, Q=i×t105=0.0041×tt=2.43×107…

Q: Using superposition, find the voltage across the 6 ohm resistor . Check the results against Vsa =…

A: Solve the problem

Q: V = 10 V= R = 470 N I la) = (a) V = R = 330 N I (b) Fig. 3-2.2 Ohm's law test circuits. (a) Given…

A: The solution is given below

Q: Example 4.5 resistance of 100 Q and a full seale deflection of 10 mA into a multirange de voltmeter…

Q: I=3, N= 300 N: 200 FIND THE FORLE - 4000 S = 40 cm ACROSS THE GAP

A: The Transformer core is given as Now the electrical equivalent circuit of the given system will…

Q: The following block diagram describes a linear, dynamic system: C(s) a2s U(s) B(s) b1 s+ b2

A: Given block diagram shown a1=2,a2=3,b1=7 and b2=8

Q: Oraw The Complete Roo! locus k CS+5) GiS)Hi5)こ (2+5) (1+S) S

A: In this question we need to draw a root locus of the given system.

Q: /cc = +10V CC Rc3 2 k2 VBB = +5V %3D OVc Rg ww 100 k2 а. Find the voltages at the base and collector…

Q: Q4: Consider th 2.5 volts. R2 is

Q: An engineer connects a resistor in parallel with an electric motor (a schematic of the circuit is…

A: The purpose of the resistor to limit the voltage across the armature coil only gets fulfilled when…

Q: Sketch or graph and then find the Fourier series for the given function f(x). Show the details of…

Q: Ex.3:-Determine the capacitances of the spherical capacitors Shown in figures (a) and (b) below ,if…

Q: constant voltage AC supply. A synchronous condenser with negligible losses is connected to the…

A: The solution is given below

Q: #1) FIND the valve of the load Rin the network that will achieve maximum power trauster and…

Q: A 25cps single-phase, 8-pole, alternator with 725 mWb flux per pole has 288 slots. The machine coil…

Q: What would be the ratings (voltages and currents) and turns ratio of a three-phase transformer to…

A: The solution is given below

Q: 1. Each of the following statements regarding stator flux of an induction motor is true EXCEPT a. it…

Q: Ex.2: Design a synchronous counter MOD-6, which follows the count sequence 000, 010, 011, 001, 100,…

A: The minimised Boolean expression can be obtained by using k-map and the same can be implemented by…

Q: A short, three-phase subtransmission line has an impedance of 1.5 + j2.4 ohms/conductor. If the line…

Q: The Bode diagram of a system with transfer function GH(s) = shown in figure below. Then, n and K…

Q: P1. 17. Given the components of vector Q, Qx-2 :Qy - -3:Qz - 1, which of the following is…

A: We need to find perpendicular vector to given vector

Q: Answer the following True or False: 1. A direct bandgap material absorbs more light in a given…

A: 1) As the direct bad gap material emits large number of photons than that of indirect band gap…

Q: Solve for the equivalent capacitance if C1 = 2 F and C2 = 7 F. C2 Cl 50 30 60

Question

i need the answer quickly

TUTORIAL PROBLEMS
1. A3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is I-50/phase
and synchronous reactance is 30/phase. To what value will the terminal voltage rise when full-load at
p.f. 0-8 lagging is switched off ?
[13970 V]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125 kVA, 3-f, 240 V, 60 Hz, 1800 rpm). The load of alternator A is 70 kW at 85% pf leading and the load of alternator B is 85 kW at 75% pf leading. Determine the pf of load.
1. A3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is I-5 S/phase and synchronous reactance is 300/phase. To what value will the terminal voltage rise when full-load at p.f. 0-8 lagging is switched off? [13970 V]
A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulation of the alternator at 100 A load at 0.8 leading power factor is ??
b) Explain the conditions of parallel connection of alternators and how these conditions are fulfilled.
A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A field current to of 30A produces full-load current of 180A on short- circit and a line to line emf of 1000V on open circit Determine(i) the power angle of the alternator when it delivers full-load at 0.8p.f(lag) (ii)the SCR of the alternator D
Please solve the problem and show the circuit diagram. Thank you. 3. A 5 MVA, 13.2 kv, 3-phase wye-connected alternator has an effective resistance of 0.8 ohm and a reactance of 15 ohms per phase. It delivers full-load current at 0.707 lagging power factor at rated voltage. What will be the terminal voltage for the same excitation and load current, if the power factor is 0.6 leading?
9.a. If a 33% load increase is suddenly applied to an alternator having a 25% reactance, the initial voltagedrop will be aboutA. 8.25%B. 13.25%C. 3.3%D. 2.5%9.b. At what speed must a four-pole alternator operate to produce a 100-cps alternating voltage?A. 3000 rpmB. 12,000 rpmC. 1500 rpmD. 6000 rpm
Two identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf lagging. The synchronous reactance of each machine is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry 125A lagging current. What is the current supplied by alternator B?
Two identical three-phase Alternators A and B share equally a load of 10 MVA at 33 KV and 80% lagging power factor. The synchronous reactance of each generator is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry a25 amperes at lagging power factor. What is the current delivered by Alternator B ?
Two identical three – phase Y – connected alternator A and B share equally a load of 10MW at 33kV and 80% lagging pf. The synchronous reactance of each machine is 4 ohms per phase and thew armature resistance is negligible. Alternator A has its filed excitation adjusted to carry 125 A lagging current, what is the current supplied by alternator B? a. 96 A b. 97 A b. 98 A d. 95 A
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
There are 160 slots in a 3-phase, 8-pole, 50 Hz., star connected alternator. There are 4 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 150° electrical and the flux per pole is 0.08 Weber sinusoidally distributed. Calculate the emf induced per phase.