Answered: Two 10 uF capacitors have been…

Two 10 uF capacitors have been connected in parallel across a 230 V 50 Hz AC supply. The current drawn from the supply will be approximately: Select one: O a. 1.44 A b. 0.36 A c. 11.5 A

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: Find the E at (0,0,5) caused by each of the following charge distributions in free space. (1) Ring:…

A: Given- Line charge distribution ρL= 5nC/m, r= 4, z= 2 Surface charge distribution, ρS=2nC/m2, 0≤r≤4,…

Q: In the following statements one of them is not true O A sequence of microinstructions is called a…

A: The microprocessor is a processor embedded on a single chip, it performs all arithmetic logical, and…

Q: A complex voltage is represented by v = (10 sin ωt + 3 sin 3ωt + 2 sin 5ωt) volts Determine for the…

Q: 1. What is the goal of circuit theory? 2. Why would we want to use circuit theory and when can we…

A: Circuit: The electrical circuit is made up of a resistor, inductor, capacitor, voltage source,…

Q: 1-) Reg 11 R₁ eiven: R₁ = 65 R₂ = 8 R3-10 R4 = 120 RE-70 Re OLLAATOR R₂= 52 A N R5 RG = 65 R₁ = 952…

Q: 2. Repeat Problem 1, but this time resistor R₁ is fixed and resistor R₂ is implemented using two…

Q: 3. Repeat Problem 1, but this time both resistors R₁ and R₂ are implemented using the three…

A: Given, Resistor R1+R2=10KΩ Voltage 1.5V≤V2≤5V Here, we have to find the range of resistor R2.

Q: A circular disk of radius a is uniformly charged with ps C/m². The disk lies on the z = 0 plane with…

Q: A 3-phase, 60 Hz induction motor has 2 poles. If the slip is 2% at a certain load, determine the…

Q: Let Y(s) be the unit-step response of a causal system, having a transfer function 3-s (S+ 1)(S+ 3)…

A: Given that: A transfer function G(s) and unit step response Y(s) are given below. Gs=3-ss+1s+3Ys=Gss…

Q: a) Find the equivalent resistance. b) Find the current supplied by the battery V = 24 V R₁ = 10 R₂ =…

A: Given, The circuit is,

Q: The stator of a 3-phase, 4-pole induction motor is connected to a 50 Hz supply. The rotor runs at…

Q: A capacitor having a Q-factor of 400 is connected in parallel with a coil having a Q-factor of 50.…

A: As per the question, it is given that Q-factor of capacitor (Qc) = 400 Q-factor of coil (QL) = 60…

Q: 1. 2. Connect 3.5-V (rms) ac source across the circuit as shown. 1 Vc = E 3.5 Vrms 500 Hz 0° lc = 2.…

A: Here: E=3.5 Vrms f=500Hz R=10 ohm C=1 micro F Current through C=? Voltage Across C=?

Q: 3-phase induction motor is wound for 8-pole and is supplied from 50 Hz system calculate (1) the…

Q: Find inverse Laplace transform of the function F(S) ==+

A: Given : F(s)=8s3+15s2+9

Q: GaAs and GaP make solid solutions that have the samecrystal structure as the parent materials, with…

A: Given: EGGaAs=1.43 eVEGGaP=2.26 Also, GaPxAs1-x exists for any value of x. Band gap varies linearly…

Q: A 3-phase, 60 Hz induction motor has 2 poles. If the slip is 2% at a certain load, determine the…

A: According to the question, it is given that Frequency of induction motor (f) = 60 Hz Number of poles…

Q: Find the center frequency andQ for the following two integrators loop topology BPF R Yo-ww <= 10 KA…

Q: A supply voltage v given by v = (240 sin 314t + 40 sin 942t + 30 sin 1570t) volts is applied to a…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: if the rate of decreasing volume charge density equals to, (4*10^6 )C/m^3*s, what is the total…

A: It is given that: dρvdt=4×106 C/m3sr=2 mm=2×10-3 m0<z<4 mm

Q: transformer has a rated output of 200 kVA at a power factor of 0.6. Determine the rated power output…

Q: Problem 3: Find voltages v1 and v2. 10v + √, + 12- 2₁0 {1+ 16

A: Given circuit:

Q: 10. What are the properties of a basic ideal circuit element?

A: Properties of a basic ideal circuit element:

Q: A ceramic capacitor is to be constructed to have a capacitance of 0.01µF and to have a steady…

A: Given: C=10 micro farad V=2.5kv E=10 meha volt per metre

Q: Q1/ To Design parallel adder that add two numbers A (5-bit) and B (7-bit) must using None of them O…

A: Given data, Parallel adder to add is of, A (5-bits) B (7-bits)

Q: Determine the total resistance and the total Tot antiocfamrent.pua 140V(+ N UNIV 2.522 rized 52 W 65…

Q: Please do the last question. Stated construct a graph of time versus current and voltage across the…

A: The series RC circuit can be analyzed based on the transient and steady-state values. The given…

Q: Q5//Answer for the following question: 1- Can we get maximum torque at start in an induction motor,…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the…

Q: A 3-phase, 220 kV, 50 Hz transmission line consists of 1-2 cm radius conductors spaced 2 m at the…

Q: 1Ω )Vi(t) 1Ω :1F 1Η + 1F= Vo(t)

A: Given network:- We have to find, Gs=VosVis We determine this value with the help of a given…

Q: 15 V 1 12 Ω Μ + Η 6Ω 2 10 Ω τω | Solve for v1 and v2 in the circuit shown in volts. 40 Ω

Q: Two series motors run at a speed of 500 r.p.m. and 550 r.p.m. respectively when taking 50 A at 500…

A: We have two series motors we have been asked to find the speed of the combination when this both…

Q: 3) Obtain the transfer function (s)/V (s) in the network in the network of Fig. 1. 152 www 192 V(s)…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the other question…

Q: 12 V Μ 4Ω Μ + 6Ω να * 2% 4V 1+

A: As per the question, we have to find the value of vo and i To solve the given problem, we will apply…

Q: The storage battery of a car has an emf of 12 V. If the internal resistance of the battery is 0.4 S,…

A: Given, Battery emf, ε=12 V. Internal resistance of battery, R=0.4 Ω.

Q: The given circuit has Vth=30V and Rth=30K Ohms. If the inductor will be short circuit and the switch…

A: Given- Inductor short circuited Switch closed To find- Value of current i =?

Q: Determine the conductance at 20°C of an Aluminum bar 0.5 inch thick, 3.5 inches wide and 10ft. long.…

Q: Determine the values of the resistance and the series-connected inductance or capacitance for each…

Q: Determine the Thevenin's equivalent circuit across points A and B by disconnecting the 75-ohm…

A: It is given that:

Q: Q6) In free space an electric dipole of Q1=2nc at (0 ,0 ,0.1), Q2=-2ne at (0 ,0 ,-0.1), find i)…

A: A dipole is formed by placing two charge of opposite polarity is seperated by small distance.…

Q: . Determine the total resistance. 16kn W 8 ΚΩ MAPUstand DO BOTTRIBUT nort unauthorized distro…

Q: The core of a three phase, 50 Hz, 11000/550 V delta/star, 300 kVA, core-type transformer operates…

A: Given: 3-phase, f=50Hz ,11000/550V delta /star, 300kVA , Flux, ϕ=0.05Wb

Q: 2. Determine the Thevenin's equivalent circuit across points A and B by disconnecting the 1-k…

A: Given: Required: Thevenin's equivalent.

Q: What is the quantum theory of dispersion of light? Am I correct that it is that a more massive…

A: ANSWER QUANTUM THEORY OF DISPERSION QUANTUM theory of dispersion…

Q: Which mode of propagation is used by short wave broadcast services having frequency range from a few…

A: A wave of propagation: A wave of propagation is defined as the wave to reach from one medium to…

Q: An inductive coil draws 20 A current and consumes 2 kW power from a 200 V, 50 Hz ac supply.…

Q: erform the following operations in 8-bit signed binary numbers using 1's complement umber…

A: "Since you have asked multipart questions, we will solve the first three question for you. If you…

Q: A 100 µF capacitor is connected in series with a 500 V DC voltmeter across a 400 V DC supply. The…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Two 10 uF capacitors have been connected in parallel across a 230 V 50 Hz AC supply. The current drawn from the
supply will be approximately:
Select one:
a. 1.44 A
b. 0.36 A
c. 11.5 A
O d. 23.0 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
With V1, voltage peak to peak is 10 volts, R1=200 Ohm, R2=1000 Ohm and C1= 300 nF. Find Vx, voltage across the the capacitor, C1 and R2 when the frequency is 1000 Hz and 10000 Hz
Find the reactance voltage when current is changed from -2A to 2A in 4 sec and self inductance is 1H?
A resistor R and a capacitor C are connected in series across a 400 V variable ac supply. When the frequency is 40 Hz, it draws 10 A current, and when the frequency is 50 Hz, it draws 15 A current. Find R and C.
Problem: 25 mH m Find Leq In below figure. 10 mH m 60 mH m 20 mH m 30 mH m -o b L 0000
At DC operating point, a capacitor behaves like an open a wire O a resistor
an alternating voltage of 10 V and frequency 50 Hz is applied to an inductor of 2H what is the r.m.s current ?
Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore contains .harmonics a. Sinusoidal O b. Triangular c. Pulsating O d. Repetitive O
a resistor and and capacitor are connected in parallel to a 277 v 60 hz power source. the resistor has a value of 50 ohms and the capacitor has a value of 40 uf what is the circuit power factor.
Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mH