Two identical plates are connected by two 25-mm diameter rivets as shown. Consider the following dimensions: B = 110 mm t = 25 mm x = 18 mm The allowable stresses of the plate are the following: Normal stress = 15.5 MPa Bearing stress = 4.25 MPa Shearing stress = 6.5 MPa Determine the maximum force P: A. Considering the normal stress: P = B. Considering the bearing stress: P = C. Considering the shearing stress: P = KN KN kN

Two identical plates are connected by two 25-mm diameter rivets as shown. Consider the following dimensions: B = 110 mm t = 25 mm x = 18 mm The allowable stresses of the plate are the following: Normal stress = 15.5 MPa Bearing stress = 4.25 MPa Shearing stress = 6.5 MPa Determine the maximum force P: A. Considering the normal stress: P = B. Considering the bearing stress: P = C. Considering the shearing stress: P = KN KN kN

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

PROBLEM 14-23
For a 10 H7/p6 fit
need help with problem 4-22 please
L21. Figure P4-21 shows an anvil for an impact hammer held in a fixture by a circular pin. If the force is to be 500 lb, specify a suitable diameter for the steel pin if it is to be made from SAE 1040 WQT 900. 4-21
Q-3 Three blocks A, B, and C and a grooved block D have dimensions a, b, c, and d as follows: a = 40.500 0.025 mm b = 52.000 0.075 mm c = 73.000 0.015 mm d = 165.900 0.250 mm Parts A, B, and C are standard parts supplied by vendors from the market, but we are to machine part D according to the the width that you are asked to specify. (a) Determine the mean gap w0 of w and its tolerance. (b) Determine the mean size of d (d0) that will assure that w ≥ 0.050 mm.
can you help me solve problem 9-7
MM Diameter = ? Pin Anvil FIGURE P4-21 Impact hammer for Problem 4-21, 4-21. Figure P4-21 shows an anvil for an impact hammer held in a fixture by a circular pin. If the force is to be 500 lb, specify a suitable diameter for the steel pin if it is to be made from SAE 1040 WQT 900.
plz provide answer for part f asap
Problem 12-78 can you give the calculation that I can understand
A wheel rest at the corner of the block as the figure. It F is a minimum force required to raise the wheel onto the block, What is the force at Point A ? The block is fixed
Problem 8-7 (Thin Cylinder)
Whoop-301b P=?