Answered: What would be the phase-to-neutral…

What would be the phase-to-neutral voltage from a 3-phase, wye-connected system if the line-to-line voltage is 34,500Volts. a. 29,918.584V b. 19,918.584V C. 28.918.584V d. 18,918.584V

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7MCQ

See similar textbooks

Related questions

Q: In three phase power measurement using one watt-meter method, if the load is unbalanced then the…

A: In the case of a balanced load (an equal load and power factor on each phase) Ptotal = 3PA = 3PB =…

Q: In a three-phase, three-wire circuit, find the phasor line currents to a balanced Y load in which…

A: Given data: ZY=20∠30 Ω VAN=120∠20 V ABC phase sequence

Q: An unbalanced three-phase wye-connected and grounded load is connected to a balanced three- phase…

A: It is given that an unbalanced three-phase wye-connected and grounded load is connected to a…

Q: A. Phase-to-neutral voltage at source. B. Line-to-line voltage. C. Phase-to-neutral voltage at load.…

Q: A balanced three-phase source with grounded neutral has line-to-neutral voltages of 132.7906 volts…

A: The circuit can be drawn as

Q: 2. For the 3-phase, 3 wire system below. Compute for the line currents, total real power, total…

A: The given circuit diagram is shown below: It is given that: Vab=200 ∠0° VVbc=200 ∠240° VVca=200…

Q: Two wattmeter's are connected to measur the input power of a balanced three phase load by two…

A: Watt-merter reading W1 = 8800w W2 = 3500 W

Q: Z4 Ceee A bo Celee B eee For the circuit shown above, Vab = 20020°, Vbc = 2004120° and Vca = 200240°…

A: The given circuit diagram is shown below: It is given that: Vab=200∠0° VVbc=200∠120° VVca=200∠240°…

Q: b + Vpa +Van - + Vac C Assume that the given three phase system is perfectly balanced, with a…

Q: The phase voltage of a three – phase, four – wire system are: VRN = (200 + j0) V, VYN = (0 – j200)…

Q: A certain generating plant in manila has 40kV, three phase transmission line to supply a 12MVA load…

Q: Given the symmetrical components to be VO = 10<0 V , V1 = 80<30 V , V2 = 40<-30 V determine the…

A: Symmetrical components: A system of three unbalanced phasors can be resolved in the following three…

Q: The one-line diagram of a three-phase power system is shown in the above figure. The line impedances…

A: Bus admittance matrix calculated using line impedance as Ydiagonal=sum of all admittance connected…

Q: Given the symmetrical components to be V0 = 10<0 V , V1 = 80<30 V , V2 = 40<-30 V determine…

A: ( ) Va = V0 + V1 + V2. Vb = V0 + (a^2)V1+(a)V2. Vc = V0 + (a)V1+(a^2)V2. Here, \(a = e^{i2\pi/3}\)…

Q: For the balanced positive-sequence three-phase circuit below, given that Van=100410° V and Za=15455°…

Q: Zy Is Zy S Zy IT

Q: . Calculate the line currents for phase a, b and c. 2. Calculate the line-to-neutral voltages at the…

A: From the given circuit Van = 120 ∠0 V V bn = 120∠-120 V V cn = 120 ∠-240 V R a=R b=R c=…

Q: A load of 135 MW at a power factor of 0.85 lagging can be delivered by a 3-phase transmission line.…

Q: The three-phase power and line-line ratings of the electric power system shown in Figure-1 are given…

A: Given: G1:82 MVA 30 kV X=10% T1:72MVA 30/300 kV X=11% T2:72MVA 300/30 kV X=11% M:62MVA 25 kV X=9%…

Q: A load of 135 MW at a power factor of 0.65 lagging can be delivered by a 3-phase transmission line.…

A: Below are the answers calculated for the above given data

Q: 2.21 The three-phase source line-to-neutral voltages are given by E= 10/0, E = 10/+240, and E =…

Q: Q2 Two single-phase voltage sources, V1 and V2 are connected by parallel line impedance of Z11 = 1+…

A: In this question we will find current supplied and recieved by voltage sources and real and…

Q: Convert the wye-connected load to its delta equivalent. What is the per phase impedance of the delta…

A: Given

Q: Draw an impedance diagram for the electric power system shown in the figure attached, showing all…

A: We can obtain the impedance diagram by using below steps: -The base voltage VBG1 on the LV side of…

Q: Q4 Calculate the three-phase voltage drop if the ac resistance is 3 Q/2km and an ac reactance of…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: Q1 (a) An industrial unit operating at rated power can be represented by a balanc- delta connected…

A: In this question we will write about line voltage phase.....

Q: Q9-b) Sketch the connection of 3-phase source to 3-phase load using 3–phase 4 wire complete with…

Q: Q2 (a) Two single-phase voltage sources, Vị and V2 are connected by parallel line impedance of Z11 =…

A: In this question, We need to determine the power supplied by V2 and power loss in the line We know…

Q: For the 3-phase, 3 wire system below. Compute for the line currents, total real power, total…

A: Given: Consider the given circuit:

Q: EXAMPLE : Estimate the distance over which a load of 15000 KW at p.f=0.8 lagging can be delivered by…

A: The solution can be achieved as follows.

Q: Given the symmetrical components to be VO = 10<0 V , V1 = 80<30 V , V2 = 40<-30 V %D determine the…

A: Unbalance components can be converted in symmetrical components for analysis of faults in three…

Q: low voltage systems In the circuit given below, single-phase powers connected to the single-phase…

A: V= 220 at angle 0° Load 1 is capacitor and load 2 is inductor Then

Q: In a balanced three-phase system, Vbn = 277≮30º. If you could measure the magnitude and angle of…

A: Given, a balanced three phase system. Vbn = 277 < 30° To find the magnitude and angle of line Vac…

Q: State the relation between line and phase values of voltage and current for 3-phase STAR connected…

A: Relation between line and phase voltages and currents of star connected system; The current flowing…

Q: Consider the balanced three-phase circuit is given below. The voltage values indicated are rms…

Q: A balanced three-phase source with grounded neutral has line-to-line voltages of 208 volts with…

Q: Q2 (a) Based on the relationship between the line and phase value of currents and voltage, show that…

A: By using three phase circuit and two wattmeter methods

Q: The sensitivity of a node to real power changes is 100 MW/kV of line voltage and that to reactive…

Q: Consider the system shown in below fig. phase 'b'is open due to conductor break.Calculate the…

A: To find the symmetrical components of currents and also find the neutral current . Note: Given…

Q: A set of balanced three-phase transmission lines with line-to-line voltages of 13 kV is connected to…

A: Given: For balanced 3-phase star-connected load, per-phase impedance Z=8+3j Ω=8.544∠20.55° Ω,…

Q: 1. For the circuit shown below, the values are Vab = 20020°, Vbc = 2002120° and Vea = 2004240° V, Z4…

A: The circuit diagram is shown below, Where,Z4=Z5=Z6=25∠30°ΩZ1=Z2=Z3=50∠-60°ΩandVab=200∠0°…

Q: The three-phase power and line-line ratings of the electric power system is shown in the figure…

Q: Find the line current, power factor, a

Q: Two wattmeter's are connected to measure the input power of a balanced three phase load by two…

A: i have explained in detail

Q: power

A: In this question, we have to answer about reactive power..

Q: A three-phase transmission line and a telephone line are supported on the same towers a shown in the…

A: Given, frequency = f= 60 Hz Current per phase= I = 200 A Da1=Dc2=42+3.6-0.62 =…

Q: The three phase power and line-line ratings of the below electric power system is given below: T Vm…

A: The given system is, For generator: For motor: And

Q: In a balanced 3-phase wye-connected system with positive-sequence source, the line-to-line voltages…

A: Consider the formula for the line to line voltage in the three phase circuit. VLL=3VLN

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

What would be the phase-to-neutral voltage from a 3-phase, wye-connected system if the line-to-line voltage is
34,500Volts.
a. 29,918.584V
b. 19,918.584V
C. 28.918.584V
d. 18,918.584V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-phase balanced load of 15A per phase is supplied by a steel wire armoured cable with a c.s.a. of 2.5mm². The voltage drop for this cable is 15mv/A/m and the circuit is 40m long. Calculate the voltage drop in the cable.
Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower 3-phase voltages. Highlight the advantages and disadvantages of each. Include the connection diagrams.
2. A single-phase are distributor AB is fed from end A and has a total impedance of (0.3-0.3) ohm. At the far end, the voltage V-240V and the current is 100A at a p.f. of 0, 8 lagging. At the mid-point M. a current of 100 A is tapped at a p... of 0.6 lagging with reference to the voltage V_{M} at the midi-point. Calculate the supply voltage V Lambda j sending current I_{N} and the phase angle between V_{A} and V_{E}
Q4/For the three-phase power network shown in Figure. the various components are: GI: 100 MVA, 0.30 pu reactance. G2: 60 MVA, 0.18 pu reactance. Transformers (cach): 50 MVA, 0.10 pu reactance. Inductive reactor X: 0.20 pu on a base of 100 MVA. Lines (each): 80 ohms (reactive); neglect resistance. with the network initially unloaded and a line voltage of 110 kV, a symmetrical short circuit occurs at midpoint E of line 2. Calculate the short circuit MVA to be interrupted by the circuit breakers A and B at the ends of the line. T3 38 L1 L2 G2 Bas 12 T4 Bus
A 20 Ohm resistor is in series with a 30 Ohm Inductive reactance. If they are connected to a 40 Volt a.c. source, what is the phase angle between the voltage across the Inductive reactance, and the supply voltage (in degrees)? **Only give the magnitude. If you believe the current is lagging OR leading, give a positive value for the angle " I
Give your background about the AC systems from single phase and three phase systems to their connections including their currents and voltages laws with the suitable diagrams.
The three-phase source line-to-neutral voltages are given by Ean=100,Ebh=10+240, and Ecn=10240volts. Is the source balanced? (a) Yes (b) No
For the single-phase circuit shown in Figure 2.22, I5 10/08A. (a) Compute the phasors I1, I2, and V. (b) Draw a phasor diagram showing I, I1 I2, and V
2. A single-phase a.c. distributor AB is fed from end A and has a total impedance of (0-2 +j03) ohm. At the far end, the voltage VR = 240 V and the current is 100 A at a p.f. of 0-8 lagging. At the mid-point M, a current of 100 A is tapped at a p.f. of 0-6 lagging with reference to the voltage Vy at the mid-point. Calculate the supply voltage V and phase angle between V and Vg- [292 V, 2-6°] T 40 A
36. If the resistor R1 and R2 terminals are connected across each other. If theRory is 10 and R1 is twice the value of R2 what is R1?a. 15 ohmsC.3,33 ohmsb. 30 ohmsd. 6.67 ohms
Give a full math analysis for the 3-phase circuit shown in the figure.
Describe the concept of three-phase power in electrical systems and its advantages over single-phase power.