You are provided a horizontal tube with one entrance and one exit. Air (Cp = 1.005 kJ/(kg-K)) is passing through  the pipe and is assumed ideal. The inlet conditions are 102 psia, 101 degrees Fahrenheit and velocity 9 feet/second. Determine the outlet velocity (ft/s) and outlet temperature (degrees Fahrenheit) if the exit  conditions a

Q: A constant-area duct that is 20 cm in length by 2 cm in diameter is connected to a reservoir through…

A: Now the mass flow rate is givenm˙=ρAV2Now we have bernoullis equation ash1+V122=h2+V222We…

Q: Water at 910 kPa, 25°C enters a 1-m-diameter horizontal pipe with a steady velocity of 13 m/s At the…

A: P1 = 910 kPa P2 = 870 kPa Velocity = 13 m/s Diameter = 1 m

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: What is the difference between Inlet velocity and superficial velocity?

A: given: What is the difference between Inlet velocity and superficial velocity?

Q: In a duct of uniform cross section only static pressure remain constant the total pressure decrease…

A: 1. First we will talk about static and dynamic pressure In bernoulli's  equation you have two…

Q: A 5-stage compressor compress 30,000 cfm of air from 15to 45 psia. If each stage operated…

A: Given: The number of stages, n = 5 The volume flow rate, V = 30,000 cfm The inlet pressure, P1 = 15…

Q: A compressor blade will stall when: The mass air flow and speed relationship is constant. O The…

A: A compressor blade will stall when, The compressor pressure ratio exceeds 10to1

Q: If the Darcy Weisbach friction factor for a fluid flow through a pipeline is calculated as0 016, the…

A: When a fluid flows from one section to another section, there occurs a reduction in its total energy…

Q: Helium is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of…

A:

Q: r is following at Q=18000CFM in a duct by the means of a centrifugal fan of efficiency 0.82. if the…

A: The solution to the above question can be obtained using the Steady Flow Energy Equation which whose…

Q: General Electric J79-GE-15 turbojet engine is one of two propelling a McDonnell F4C airplane is…

A:

Q: Electronic components inside a CPU are cooled using a fan through which air enters at 293 K at…

A: Write the given data. P1=100 kPaT1=293 Kv1=0v2=1.30 m/sT3=305 K

Q: Water at 910 kPa, 25°C enters a 1-m-diameter horizontal pipe with a steady velocity of 13 m/s At the…

A:

Q: A steam turbine operates with inlet conditions of 500 C and 2 MPa, and exit conditions of 10 kPa and…

A: given that, P1=2MPa T1=500C P2=10kPa x=0.95 W=900KJ/kg from the steam table , at inlet, h1=3468.09…

Q: Standard atmospheric air [TO = 288 K, p0 =101 kPa(abs)] is drawn steadily into an adiabatic,…

A:

Q: Determine the expected Fanning friction factor for water at 28 degrees Celsius, flowing through a…

A: Give data as per the question The internal diameter of the tube =15 mm = 0.015 m velocity =0.3 m/s…

Q: Nitrogen enters a diffuser at 200 m/s with a pressure of 80 kPa and a temperature of -20 C. It…

A:

Q: An axial compressor with a mean diameter of 0.8 m is being designed to run at 3000 rpm. The whirl…

A:

Q: Question 3 Air enters a gas turbine steadily at pressure 10 kPa, volumetric flowrate 1,200 m²/s, and…

A:

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: If the Darcy Weisbach friction factor for a fluid flow through a pipeline is calculated as 0.016,…

A: Given data, Fd = 0.016 Find Ff = ?

Q: 17. A fully inflated tire has a volume of 15 ft3. The pressure and temperature of the air in the…

A: In a spout or other narrowing, the release coefficient (otherwise called coefficient of release or…

Q: QUESTION 1 (a) Air at 105 kPa and 37°C flows upward through a 6-cm-diameter inclined duct at a rate…

A:

Q: A liquid with a density of 0.8 [g/ml] flows through a tube with an inner diameter of 50 [mm].  There…

A: Given: Orifice coefficient, Co = 0.61  Orifice diameter, Do = 25.4 mm Diameter, D = 50 mm Find: Flow…

Q: Air fl ows adiabatically in a 3-cm-diameter duct, withf 5 0.018. At the entrance, T1 = 323 K, p1…

A: Given data:  Air flows adiabatically Duct diameter (D) = 3 cm = 0.003 m Friction factor (f)  = 0.018…

Q: 10- Át the discharge of an air-conditioning duct, it is desirable to reduce the cross-sectional area…

A:

Q: 0.540 kPa of Nitrogen gas is contained in a certain vessel. It is fed into the unit at 1 kPa by a…

A:

Q: Dry saturated steam at a pressure of 8 bar enters a convergent divergent  nozzle and leaves it at a…

A: Given data as per question p1=8 barp2= throat pressurep3=1.5…

Q: A conical tube of length 3.0 m is fixed vertically with its smaller end upwards. The velocity of…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The friction factor for a 25 mm diameter 11,5 m long pipe is 0.004. The conditions of air at entry…

A: Given: Diameter of the pipe (D)=0.025mLength of the pipe (L)=11.5mFriction factor (f)=0.004Inlet…

Q: AQ2) Air (y = 1.4) flows into a constant-area insulated duct with a Mach number of 0.20. For a duct…

A:

Q: Oil whose temperature is constant at 20 ° C (ρ = 886 kg / m3, μ = 0.805 kg / m / s) It flows…

A: GivenT=20°Cρ=886kg/m3μ=0.805kg/m/sPi=720KpaL=40mP0=101Kpa

Q: Air flows steadily and isentroplcally into an aircraft inlet at a rnass flow rate of 100 kgs·1• At a…

A: Given data: The mass flow rate is m˙=100 kg/s The area at the inlet is A1=0.5 m2 The inlet…

Q: Water at 940 kPakPa , 25∘C∘C enters a 1-mm-diameter horizontal pipe with a steady velocity of 19…

A: Given Data:- Pressure =940kPa Temperature=25degreeC Diameter = 1-mm Velocity=19m/s Exit…

Q: 1- Nitrogen is stored in a large chamber under conditions of 450 K and 1.5 x 105 N/m. The gas leaves…

A:

Q: 1- Air enters a compressor for a mass flow rate of 0.04 kg/s. at a stagnation temperature 358 K.…

A: Given:P1=100 KPaP2=900 KPaT1=358 Km=0.04 Kg/s

Q: Assuming the clearance is negligible for a single stage compressor with the following data.…

A:

Q: D. An open system with variable imaginary boundary E. Turbulent flow through a pipe with velocity…

A:

Q: - Air at 105 kPa and 37°C flows upward through a 6-cm-diameter inclined duct at a rate of Q (L/s).…

A:

Q: Q4. Water from a reservoir is conveyed via a pipeline of constant diameter and 1000m length to a…

A:

Q: Calculate the heat rejected by 1 Kg for a perfect gas has a molecular weight of 26 and a value of…

A:

Q: The static and stagnation pressures of a fluid in a pipe are measured by a piezometer and a pitot…

A:

Q: ive hundred kilograms per hour of steam moves a turbine. The steam enters the turbine at 44 atm and…

A: Solution :- Given data :- mass flow rate m˙ =500 kg/hr                                   =5003600…

Q: Q . It is proposed to pump 8,000 kg/h of toluene at 114 oC and 1.1 atm abs pressure from the…

A: Write the given data:

Q: Question Two A constant-area duct, 25 cm in length by 1.3 cm in diameter, is connected to an air…

A:

Q: You are provided a horizontal tube with one entrance and one exit. Air (Cp = 1.005 kJ/(kg-K)) is…

A:

Q: Q3- Air flows from a reservoir and enters a uniform pipe with a diameter of 0.05 m and length of 10…

A:

Q: 3- A gas initially at a subsonic velocity enters an adiabatic diverging duct. Discuss how this…

A: (a) For a subsonic velocity, the Mach number is less than 1, and the velocity is inversely…