Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 12.1, Problem 1aT
For each layer, draw a free-body diagram in the space provided. Be sure to indicate on your diagram the surface on which each contact force is applied. (This is usually done by placingthe tip of the arrow that represents the force at that surface.)
The label for each force should indicate:
• the type of force.
• the object on which the force is exerted, and
• the object exerting the force.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Using the definition of the static friction and the first condition of equilibrium,show that the coefficient of static friction in method A is the ratio of the weight ofthe pan plus its contents to the weight of the carrier of the pan plus its contentsto the weight of the carrier plus its content. Note: Show your free body diagrams.
Suppose your car was mired deeply in the mud and youwanted to use the method illustrated to pull itout. (a) What force would you have to exert perpendicular tothe center of the rope to produce a force of 12,000 N on thecar if the angle is 2.00°? In this part, explicitly show how youfollow the steps in the Problem-Solving Strategy for Newton’slaws of motion. (b) Real ropes stretch under such forces.What force would be exerted on the car if the angle increasesto 7.00° and you still apply the force found in part (a) to itscenter?
Draw the free-body diagram of the block. Using this diagram and your knowledge about Newton’s laws of motion, explain why is it that with 0.5 coefficient of friction, the minimum force required to move a 0.8kg-block is 3.8 N?
Chapter 12 Solutions
Tutorials in Introductory Physics
Ch. 12.1 - For each layer, draw a free-body diagram in the...Ch. 12.1 - Imagine that a small hole is opened in the...Ch. 12.1 - Prob. 2aTCh. 12.1 - Suppose you wanted to determine the pressure at...Ch. 12.1 - Prob. 2cTCh. 12.1 - Prob. 2dTCh. 12.1 - Draw a freebody diagram for the small voulme of...Ch. 12.1 - Prob. 3bTCh. 12.1 - Use your answer to part B to compare the pressures...Ch. 12.1 - Prob. 3dT
Ch. 12.1 - Consider the following student dialogue: Student...Ch. 12.1 - Prob. 4aTCh. 12.1 - The right end of the tube is now scaled with a...Ch. 12.1 - A syringe is used to remove some water from the...Ch. 12.2 - A cubical block is observed to float in a beaker...Ch. 12.2 - Prob. 1bTCh. 12.2 - Imagine that you were to release the block from...Ch. 12.2 - In general, does the buoyant force on an object...Ch. 12.2 - By how much does the volume reading increase when...Ch. 12.2 - Does the volume of water displaced by a completely...Ch. 12.2 - Consider the following statement made by a...Ch. 12.2 - A rectangular block, A, is released from rest at...Ch. 12.2 - A second block, B,of the same size and shape as A...Ch. 12.2 - A third block, C, of the same size and shape as A...
Additional Science Textbook Solutions
Find more solutions based on key concepts
The pV-diagram of the Carnot cycle.
Sears And Zemansky's University Physics With Modern Physics
Consider a grey squirrel falling out of a tree to the ground. (a) If we ignore air resistance in this case (onl...
College Physics
11.64 A uniform metal bar that is 8.00 m long and has mass 30.0 kg is attached at one end to the side of a buil...
University Physics with Modern Physics (14th Edition)
If the refrigerator door is left what happens to the temperature of the kitchen?
University Physics Volume 2
A radio waves electric field is given by the expression E = E sin (kz t) ( + ). (a) Find the peak electric fi...
Essential University Physics (3rd Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- If two tugboats pull on a disabled vessel, as shown here in an overhead view, the disabled vessel will be pulled along the direction indicated by the result of the exerted forces. (a) Draw a free-body diagram for the vessel. Assume no friction or drag forces affect the vessel. (b) Did you include all forces in the overhead view in your free-body diagram? Why or why not?arrow_forwardHey 1. May you please help me to draw a labelled free-body diagram of a stationary object of mass M on a rough surface inclined at an angle, (theta) 2. Lastly help me find different expressions for the magnitude of the Normal force using both x and y direction of the chosen set of axes from the situation above.arrow_forwardWrite out Newton’s Second Law for each mass, showing the sum of forces from the free-body diagrams from step 1. Assume up is the positive for both diagrams. Show your work here.arrow_forward
- An object moves on a flat surface with an acceleration of constant magnitude. If the acceleration is always perpendicular plane and measures the angle at which the block begins to slide. He reports that the coefficient of static friction was 0.25 in his experiments. At what angle did Leonardo’s blocks begin to slide? Show your work and explain.arrow_forward***THERE IS NO DIAGRAM NEEDED** please clearly state what i is and what j is for each one. Block 1 (20 kg) is pulled by a rope from left to right up a ramp which is inclined 50 degrees from the horizontal. The rope pulls on block 1 with a force of 300 N parallel to the surface of the inclined plane. The coefficient of kinetic friction between the block and the surface equals 0.3.On a sheet of paper, draw the free body diagram for block 1 using the two-subscript notation from class. Assume that the x-axis is parallel to the incline and positive in the direction up the incline. After completing the free body diagram, enter below each force and its x & y-components.FORCES on BLOCK 1Weight force on block 1 by EarthW1E = i + j NTension force on block 1 by RopeT1R = i + j NNormal force on block 1 by SurfaceN1S = i + j NFrictional force on block 1 by Surfacef1S = i + j N What is the acceleration a of block 1?a = i + j m/s2arrow_forwardPlease ,don't provide handwritten solution ..... the coefficient of static and kinetic friction between a 6 kg box and a horizontal desktop are .5 and .2 respectively. what is the force of friction on the box when a 10N horizontal push is applied to the box? Please explainarrow_forward
- The three diagrams below show a block of mass m being pulled or pushed at constant acceleration along a table with a force F. The coefficient of kinetic friction is ?k. What is the magnitude of the friction force in each case? Give your answer in terms of the pushing force F, m, ?k, and the angle ?.arrow_forwardSOLVE THE FOLLOWING PROBLEM AND SHOW YOUR COMPLETE SOLUTIONS. EXPLAIN YOUR ANSWER FOR BETTER UNDERSTANDING. IF APPLICABLE ILLUSTRATE A FREE BODY DIAGRAM.arrow_forwardWhat would the FBD of the basketball at point 1, 2, and 3 look like? Draw 3 seperate FBD for each point. Label the forces and direction. Use a dynamics approach.arrow_forward
- A contestant in a winter sporting event pulls an m kg block of ice across a frozen lake by applying a force F at an angle θ above the horizontal as shown. Assume that the coefficient of static friction for ice on ice is 0.0300, and the coefficient of kinetic friction for the same is 0.0100. Let to the right be the positive x direction and up be the positive y direction for your equations. Please use the interactive area below to draw a free body diagram to represent the situation where the contestant is pulling, but the block has not yet started to move. Use Fs for the force of static friction and Fk for the force of kinetic friction if they are needed for your free body diagram. 17% Part (b) Select the correct expression for the net force in the horizontal direction, ΣFx. 17% Part (c) Select the correct expression for the net force in the vertical direction, ΣFy. 17% Part (d) Obtain a numeric value, in newtons, for the magnitude of the maximum applied force, F, consistent…arrow_forwardBased on the image provided, which picture shows contact force? How about non-contact force? Differentiate contact from the non-contact force? What specific kind of force is present in picture 1? How about in picture 2? Please answer the questions above and encode your answersarrow_forwardPlease illustrate the Free Body Diagram of each blocks. Show me the derivation of the equations(Summation X and Y) Thanks in advance Keep Safe!arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University
Newton's Third Law of Motion: Action and Reaction; Author: Professor Dave explains;https://www.youtube.com/watch?v=y61_VPKH2B4;License: Standard YouTube License, CC-BY