3. Relative to the values given below, predict whether the concentrations of O2, CO2, and pH would be higher or lower than in the control aquarium. Assume the numbers of plants and fish are constant among treatments. If you think there will be no difference in dissolved gases, use "=". If you think it will be higher, use a "+"-lower, use a "-". Note: data in the table below are "made up." As a result, they may not accurately reflect the data that you collect in lab. Plain (control) Heated Aerated Plants with light Fish Plants & fish (light) Plants & fish (dark) O₂ (ppm) 12 16 CO₂ (ppm) 8 3 pH 7.0 7.1 8.5 619 8.5 72 he aquarium containing only plants was placed in the dark for 8 hours, ect oxygen and carbon dioxide concentrations to change? VI

3. Relative to the values given below, predict whether the concentrations of O2, CO2, and pH would be higher or lower than in the control aquarium. Assume the numbers of plants and fish are constant among treatments. If you think there will be no difference in dissolved gases, use "=". If you think it will be higher, use a "+"-lower, use a "-". Note: data in the table below are "made up." As a result, they may not accurately reflect the data that you collect in lab. Plain (control) Heated Aerated Plants with light Fish Plants & fish (light) Plants & fish (dark) O₂ (ppm) 12 16 CO₂ (ppm) 8 3 pH 7.0 7.1 8.5 619 8.5 72 he aquarium containing only plants was placed in the dark for 8 hours, ect oxygen and carbon dioxide concentrations to change? VI

Biochemistry

6th Edition

ISBN:9781305577206

Author:Reginald H. Garrett, Charles M. Grisham

Publisher:Reginald H. Garrett, Charles M. Grisham

Chapter21: Photosynthesis

Section: Chapter Questions

Problem 20P

See similar textbooks

Similar questions

1. Food irradiation processing delivers doses as high as 5 kGy to eradicate microorganisms from a variety of foods such as fruits, vegetables and meats. Sketch a survival plot assuming that these microorganisms can be described with D, = 4.8 Gy and D, = 1.6 Gy. What is the surviving fraction following a dose of 6.5 Gy? Show the equation you used to construct the plot
Select which of the following standard enthalpy of formation values is not zero at 25 C: Check all that apply. Ca(s), 03(g), NO(g), Mg(s), HCl(g)
N. benthamiana will be infiltrated with a solution containing OD600=0.3 of each experimental Agro containing construct and OD600=0.1 of p19. Calculate the volume of cultures (V construct; V p19) needed according to the formulas: V construct = V final × 0.3/OD600; V p19 = V final × 0.1/OD600. One mL of infiltrate is often enough to complete a small experiment. How to plan your final volume accordingly?
. Lineweaver-Burk plot is the most used linearization method of the MichaelisMenten equation, but the main drawback is a/an:a. overemphasis to low substrate concentration and less emphasis to high substrate concentration.b. overemphasis to high substrate concentration and less emphasis to low substrate concentration.c. exaggeration to both ends of the reciprocal of the substrate concentration.d. lack of independent variables to x- and y- coordinates.Kinetic data were gathered for Enzyme X, its substrate, and a known competitive inhibitor Z. Upon plotting the linearized kinetic data, one could surmise that the plot of the inhibited enzyme would have:a. a slope and y-intercept both lower in magnitude than the plot of the uninhibited enzyme using Eadie-Hofstee method.b. a constant slope and y-intercept that is lower in magnitude with the plot of the uninhibited enzyme using Eadie-Hofstee method.c. a slope and y-intercept greater in magnitude than the plot of the uninhibited enzyme using…
For scenario 2, below write the following 1.the process that the sets of measurements represent. 2.suitable equations of the process. 3.the calculated rates and 4.the resulting units for the process as expressed by your calculation. Scenario 2 Time,0 minutes:7.13mg/L O2 Time,20 minutes:13.39mg/L O2 Algal biomass:2.3g fresh mass
Rate in U [S] in mM No Inhibitor 0.5 1.0 2.0 4.0 8.0 16.0 32.0 64.0 0.22 0.41 0.73 1.12 1.57 2.01 2.3 2.5 3.0 mM Inhibitor Copy and paste the above data into Excel. Create an Eadie-Hofstee plot of the given dataset. 0.08 0.15 0.29 0.52 0.85 1.3 1.78 2.16 Calculate the Vmax, and Vmax/ Km parameters for both the uninhibited and inhibited trials (Inhibited parameters are marked with an apostrophe (')). Finally, determine the mechanism of inhibition. Note: give all parameters to two decimal places, and do not include the units. For the method of inhibition, state competitive, uncompetitive, or mixed as your answer. U. Vmax/Km- A U. Vmax/Km= Vmax 1. Vmax= U-mM-1. Mechanism of inhibition = inhibition A/ A/ A/ U.mM A
Consider the sterilization of a sodium gluconate production medium in the holding section of a continuous sterilizer. Assuming constant temperature, the specific death rate constant of the contaminant is 20 s-1 . If the average residence time in the holding section is 10 seconds, calculate the Del factor for the following and explain the results. i. For Pe = 400 ii. For Pe = 400, assuming plug flow iii. For Pe = 100 iv. For Pe = 100, assuming plug flow
5. a) Thin layer chromatography (TLC) and high performance liquid chromatography (HPLC) can be used asexamples to explain difference between adsorption and partition. For each of these chromatographic techniques,identify:+ the stationary and mobile phase+ how the mobile phase movesb) How is the Rf value for a spot on a TLC plate calculated? What can the Rf value be used for? In order toachieve the best separation of several components of different polarity in a mixture spotted on a TLC plate,what guideline should one follow regarding the choice of a developing solvent? (i.e. polar, non-polar, etc.)
1. What is the independent variable for figure 2? 2. What is the dependent variable for figure 2? 3. Was this graph generated using data collected in the field, laboratory, or was it simulated? Why is this important to consider? 4. Explain what Tp and Tf are. 5. At the E1 threshold, HF and HF-P individuals achieve the same net energy take. Which group reached the threshold slower and why?
) Describe the changes seen in the RuBP levels over the time of the experiment, VWhy does the RUBP level remain low at high carbon dioxide? ii) Why does the level of GP change in relation to the RUBP level at low carbon dioxide? (
As a public health engieer you have been tasked wiyh designing a plug flow reactor for the disinfection of Giardia lamblia using either free chlorine and monochloramine. The objective is a three log reduction in the concentration of Giardia lamblia. The kinetics of chlorine decay can be described by a first order coefficient of 0.1 d-1. It is also given that the appropriate contact time, t10, equals the hydrualic residence time (HRT or td) of the plug flow reactor. Question: At a temperature of 5oC and a pH of 7.0, what is the volume of the PFR if the flowrate of the water to be disinfected is 1000 L/d for chlorine and monochloramine Disinfection data in the table below can be used.
a. For an exponentially growing population, calculate μmax (units?) based on the data belowb. Calculate the specific growth rate (μ) of the population above growing at a substrate concentration of 25 mg/L according to Monod kinetics with a ks of 50 mg/L.c. Consider two genetically engineered organisms intended for use in the cleanup of hydrocarbon spills into the ocean. Bacterium alpha has a μmax of 1 d-1 and a ks of 0.1 mg/L. Bacterium beta has a μmax of 5 d-1 and a ks of 5 mg/L. If the hydrocarbon concentration is initially 1000 mg/L and the desired objective is to reduce concentrations below 0.1 mg/L what order of addition of the bacterial species is desired?