Consider an ideal gas inside a cylinder with a piston and weights at 200 kPa occupying a volume of 0.04 m³. Heat is added to the gas while slowly removing weights from the piston to keep the temperature constant. Find the work (in kJ) done by the gas if the final volume is 0.1 m³. Remember the sign convention for work! Gas

Consider an ideal gas inside a cylinder with a piston and weights at 200 kPa occupying a volume of 0.04 m³. Heat is added to the gas while slowly removing weights from the piston to keep the temperature constant. Find the work (in kJ) done by the gas if the final volume is 0.1 m³. Remember the sign convention for work! Gas

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 6RQ: One British thermal unit will raise the temperature of _____ 1b of water _____F.

See similar textbooks

Similar questions

The height of a cylindrical tank, containing 20 lb of gas at 70 psia and 140 deg. F is 2.5 times its diameter; the gas constant R = 45 ft-lb/lb-R. Find the tank diameter in ft.
1.63 Ib of gas is stored in a tank of 2ft3. If the internal energy decreases by 27.4 BTU as temperature drops from 200F to 100F, find the specific heat at constant volume for this gas
Find the radius of a closed cylinder filled with a 500 g liquid that has a bottom pressure measured to be 1.23 kg/m3.
The height of a cylindrical tank, containing 15 lb of gas at 70psia and 115°F, is triple its diameter; the constant R=45ft-lb/lb°R,Find the tank dimensions in feet.
Q3) A perfectly insulated cylinder fitted with a leakproof frictionless piston with a mass of 30.0 kg and a face area of 400.0 cm? contains 7.0 kg of liquid water and a 3.0-kg bar of aluminum. The aluminum bar has an electrical coil imbedded in it, so that known amounts of heat can be trans- ferred to it. Aluminum has a specific gravity of 2.70 and a specific internal energy given by the formula Ú(kJ/kg) be taken to be that of the saturated liquid at that temperature. Negligible heat is transferred to the cylinder wall. Atmospheric pressure is 1.00 atm. The cylinder and its contents are initially at 20°C. 0.94T( C). The internal energy of liquid water at any temperature may m- 30 kg A=400 cm- H2Olv) 7 kg HOn HOn Iro000 3 kg Al- Suppose that 3310 kJ is transferred to the bar from the heating coil and the contents of the cylinder are then allowed to equilibrate. (a) Calculate the pressure of the cylinder contents throughout the process. Then determine whether the amount of heat…
A piston-cylinder set up contains 0.015kg of an ideal gas at a volume of 1 liter, a temperature of 5.5 degrees celsius and a pressure of 685 kPaa. The gas is heated at constant pressure to 1.75 liters. If the total heat input for the process was 2.78 kJ, find the specific heat at constant volume (in kJ/kg-K) for the gas
Q1) A vessel contains 1 kg of steam at a pressure of 6 bar. Find the amount of heat, which must be rejected, so as to reduce the quality of steam in the vessel to be balance (the quantities of water and steam area equal).
Thermodynamics (Ideal Gas) In a certain non-flow process, the internal energy decreases 20 Btu/lb and 77800 ft-lb/lb of work done on the substance. Find the heat added or abstracted in Btu/lb
A 300 L rigid tank contains Methane gas at 35 °C and 350 kPa. Some methane is allowed to enter the tank tell the until the density in the tank becomes 5.5 kg/m and the temperature at this point is 36 C. 3 What is the amount of gas that has entered the tank (kg)? Select one: a. 1.071 b. 1.131 c. 0.992 d. 0.922 e. None of the above
A rectangular tank that is 9 feet long, 4 feet wide and 12 feet deep is filled with a heavy liquid that weighs 60 pounds per cubic foot. In each part below, assume that the tank is initially full. Your answers must include the correct units. ?ou may enter lbf or lb't for ft-lb.) (a) How much work is done pumping all of the liquid out over the top of the tank? (b) How much work is done pumping all of the liquid out of a spout 4 feet above the top of the tank? (c) How much work is done pumping two-thirds of the liquid out over the top of the tank? (d) How much work is done pumping two-thirds of the liquid out of a spout 4 feet above the top of the tank?
A liter of argon at 0 °C and 1 bar is to be cooled by 50 °C without changing the pressure. What is the final volume? The result is given in liters
A 1 m3 container is filled with 400 kg of granite, 200 kg of dry sand, and 0.2 m3 of liquid 25 °C water. Use properties from Tables A.3 and A.4. Find the average specific volume and density of the masses when you exclude air mass and volume.