Determine the capacitor voltage in Volts (V), power in milliwatts (mW), and stored energy in microjoule (µJ) at t = 5 ms in the circuit below. 1mA ( ↑) v(1) 10 μF t = 0

Q: total impedance [ZT] in polar form,

A: Given-E= 100∠0o VR= 8 ohmXL=6 ohm

Q: The response of an LTI system to ü[n+2] appears to be the following sequence. Do we have enough info...

A: A linear time-invariant (LTI) system can be represented by its impulse response  As the name sugges...

Q: The transistor (β = 100) as shown in the circuit is operating in

A:

Q: R1 3002 V1 |120Vrms C1 60HZ 8.84uF 0°

A:

Q: The voltage applied to a coil having R = 200 ohms, L= 638 mH is represented by e= 20 sin 100 pi × t....

A:

Q: The value of transformation ratio (K) for the step up transformer is a) equal to 0 b) less than 1 c)...

A: Answer: greater than 1   Explanation: a)  It is not a valid option. If k=0 then the secondary turns ...

Q: An LRT train is scheduled to travel from KJ10 station to KJ11 station within 4 minutes (including st...

A: given D=3 km retardation, β =0.8 km/hr/sec maximum speed, Vm=80 km/hr total run time, T=(4×60)-30 =2...

Q: 1.) Explain, in full detail, the principle of operation of an oscilloscope, i.e. how does a represen...

A: The oscilloscope is a very useful and versatile laboratory instrument used for the display, measurem...

Q: how to solve v1  node voltage

A: The node equation is in rectangular form and the node voltage V1 can be obtained by simplifying the ...

Q: e. 6. The integral / (t+2)8(4- 2t)dt has the value -0- a. 2 b 4 с. 8 d. none of these e, zero

A:

Q: Question 2: The system described by the input-output relationship y(t) = r(t – 5) – (3 – t) for all ...

A:

Q: A 400-amp circuit breaker protects a feeder that's installed in a nonmetallic raceway that requires ...

A: Circuit Breaker- It is used as switch which works as a safety device for the circuit and circuit ele...

Q: Given the operation of sinusoids. 20 sin 400f + 10 cos(400f+ 60•) – 5 sin(4001 – 20º) C. Express you...

A: In this question,  Sinusoidal signals is given.  Find the Resultant in the exponential form?  And ti...

Q: With an AC voltage source of 5.4V and an f = 32000Hz. a) Calculate the Voltage and Current 1,7mH. ...

A:

Q: Suppose, R= 75 ohm . So, calculate the value of P and i.

A: In this question, We need to calculate the value of P and i. We know power P= V2 /R Current I = V/R ...

Q: 50 Hz, 250 V single phase power line has the following loads placed across it in parallel; 4 kW at a...

A: Using power triangle relations find  active and reactive power of each load then add them to get tot...

Q: 2) A partially filled truth table is given in the table for a seven-segment display. Complete the fo...

A:

Q: If the stator flux density (Bs) of a machine is 0.5490°T and the rotor flux density (Br) is 0.34-80°...

A:

Q: Question 12: The output y of a system is related to the input r by Ji r20 y = 0 r<0 The system is A:...

A: It is constant function  It means non linear

Q: V1-Vs 4 V1 V1 = 0 Z3+Z4+Z5 Z1 Z2 V½-0.77 -j1.0067 V1 V1 1.5 x 103 -j4.9274+j128.1770+830

A:

Q: is he Fourier transform of z(t) a. e"u(-w) b. none of these ewu(-w) d. e"u(w) e. eu(w)

A: In this question we will find Fourier transform of given signal....

Q: Question 19: The signal r(t) = cost +3 cos 2t is A: none of these B: periodic, energy with period 27...

A:

Q: An inductive reactance of 10 W is connected in parallel with a capacitive reactance of 30 W. If the ...

A:

Q: 19. Which of the following is bonded to the grounding electrode system of the supply system by being...

A: Equipment bonding jumper is basically used to provide a connection between the equipment grounding c...

Q: Q1. (a) Describe the working principle and characteristics of the following special machines: (i) Un...

A: Working principle :- If the single phase AC is given to dc series motor, it will run normally but ma...

Q: What is the funchion of eth able an input multiplexer chip 2 apply Vec connect ground To (2) To 3) T...

A: The solution is given below  The answer is option 3. To active the entire chip 

Q: PROBLEMS: 1.What are the colors of the band of a 10%, 5.6 ohm resistor? 2.What are the color of the ...

A: Note: As per the policy we can solve only 1 question, please re-upload the remaining questions as a ...

Q: A- Using Kirchhoff's current law, determine the unknown currents for the below network. 5 mA 3.5 mA ...

A: Given, We have a network. We have to find the unknown Currents. Please find the below attachments fo...

Q: 1. Assume that the registers are 8-bit wide. Consider the following code: MOV R1, #4A MOV R2, #40 AD...

A:

Q: 1 Determine the current flowing in each diode in the practical OR Ilogic circuit of Fig.12 when both...

A: To calculate the current flowing through each diode

Q: Hello expert I need help in designing I have active filter pand pass sallen key how can I design if ...

A: Given: A Sallen key active bandpass filter having 6 poles. To find: Design the above filter circuit.

Q: 1. One of the complicated parts of solving for the input impedance is the hyperbolic tangent of the ...

A:

Q: Does the reverse saturation current of the diode change significantly in magnitude for the reverse-b...

A: Given: Diode reverse saturation current

Q: impedance of (10 + j 15) ohms is connected in parallel with an impedance of (6 – j8) ohms. The total...

A:

Q: Question 1. A periodic signal r(t) has the Fourier series represntation 12nt 5+ jn r(t) 1+ The input...

A: Given: A periodic signal x(t) has the Fourier series representation: xt=1+∑n=-∞∞15+jnej2nt The input...

Q: 1.2K 22K 100K 12V 100K 10K 18K 9V o- 12K 2.2K 47K 33K 1.5K -5V

A:

Q: 6. Which of the following is a condition that a liquidtight flexible metal conduit must meet in orde...

A: Given :few mcqs on flexible metal conduit  

Q: 16. If X(w) = 35(w-2), then r(t) is %3D 3.

A:

Q: d) This addressing mode is always used to access memory, shown here as the source operand of this in...

A: LDR R1, [R0]; Load into R0 the contents of the memory location pointed to by R3 This is Register ind...

Q: energy of the signal z(t) = 2u(t +2) - 2u(t-2) is equal a. Eco = 00 (b. Eo 16 %D c. none of these d....

A:

Q: An analogue indicating instrument with a scale range of 0-5A shows a current of 2.4A. A current has ...

A:

Q: • Sketch the output voltage of the given circuit assuming that the diode is silicon. Indicate the ma...

A: We need to find out the output voltage and we need to draw it .

Q: 2. Use superposition to find vo.

A:

Q: Find the power dissipated by 1-ohm resistor. Find the power in 6 V source.  Find the current throu...

A:

Q: Determine the value of vi if Vs=0V and Is=3mA Vs 6k2

A: SOLUTION- If  Vs = 0 V   and    Is = 3mA 6 kohm &amp; 3 kohm are in parallel , =  6×36+3 = 2 kohm t...

Q: Design a digital logic circuit using only NAND gates for the logic expression given by: F=A.(B +C)

A:

Q: 15. Given r[n] = 10 8[n- k] then Σ 10 %3D k=0 a.none of these

A:

Q: A 120 V shunt motor has an armature equivalent of 0.5 ohm and a field resistance of 60 ohm. At full ...

A: Given data, Armature resistance Ra=0.5 Ω Field resistance Rf=60 Ω Terminal voltage V = 120 V Load cu...

Q: A circuit takes a current of 3 A at a power factor of 0.6 lagging when connected to a 115 V, 50 Hz s...

A:

Q: (1) What is the type of channel in these MOS-C devices? (a) P-channel (b) N-channel (2) Are the C-V ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.