Which one is correct? A variable capacitor bank may be required to improve power factor, depending on the load. Power factor correction always results in a power factor greater than 0.9. Power factor correction has an impact on active power flow on the system .(i.e. MW value) A capacitor bank is always going to improve the power factor.

Which one is correct? A variable capacitor bank may be required to improve power factor, depending on the load. Power factor correction always results in a power factor greater than 0.9. Power factor correction has an impact on active power flow on the system .(i.e. MW value) A capacitor bank is always going to improve the power factor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.
What is the average Power at maximum resistance? Why? What is the effect to the voltage and current when increasing the load resistance?
WHAT IS THE POSSIBLE OBSERVATION AND CONCLUSION ABOUT SERIES–PARALLEL CIRCUIT AND DELTA WYE CONVERSION?
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Does the input power factor of convertors depend on the load power factor? why?
What will be the value of the twiddle factor: W42
3. Two circuit elements in series consume 60 VAR when connected to a 120 – V, 60 – Hz source. If the reactive factor is 0.6, what are the two components and what are their values?
PLEASE RESOLVE! THE FINAL ANSWER MUST BE IN THE CHOICES. DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158 volts, 50 Hz supplies the combination. Determine the following: a. Circulating current b. Voltage across the resistor c. Voltage across the capacitor
Q2) Consider the circuit in Figure (3), and answer 3 branch only. a) What type of circuit is this? b) What is the total peak secondary voltage? c) Find the peak voltage across each half of the secondary. d) Sketch the voltage waveform across RL. 4:1 120 V rms RL 1.0 k2 D2 eelee