Concept explainers
How does the National Electrical Code specify that the high leg of a four-wire delta connection be marked?
The method specified by the National Electrical Code for the marking of the high leg of a four-wire delta connection.
Explanation of Solution
High delta leg is a type of electrical service connection which is also termed as wild leg, stinger leg, orange leg or red leg delta.
Whenever there is a need of power supply of both three phases and single phase power from a three phase transformer, high delta leg comes into use. The high delta leg voltage is
The specification for the marking of the high delta leg for a four wire delta connection is provided by National Electrical Code. As per this specification, the high delta leg must be connected to an orange wire or tagged at any point where a connection is made.
Thus, the National Electrical Code specifies that the high leg of a four-wire delta connection be marked by connecting it to an orange wire or by tagging it any point where a connection is made.
Want to see more full solutions like this?
Chapter 9 Solutions
Electrical Transformers and Rotating Machines
- Power-consuming devices are wired in _____(series orparallel).arrow_forwardHow many transformers are needed to make an open-delta connection?arrow_forwardAn 11-pin control relay contains three sets of single-pole double throw contacts. List the pin numbers by pairs that can be used as normally open contacts.arrow_forward
- A 480-volt three-phase load is rated at 34.5 kVA. It is to be supplied with variable three-phase voltage. Because the load is continuous, the transformers ratings are to be increased by 1.25% of the rated load. Three variable autotransformers are used to supply this load. Refer to Table 4-2 and determine the standard size of each transformer that should be used to make this connection.arrow_forwardName three factors that determine the amount of induced voltage.arrow_forwardWhat size conductor should be used to connect the primary of the transformer described in question #6? Assume the conductor to be copper with type THW insulation.arrow_forward
- If the load in question 7 is connected in a wye, what would be the line voltage and line current supplying the load?arrow_forwarddescribe the wiring diagram as shown above in detail.( for the description name each component in the wiring diagram and their function)arrow_forwardWhat is the peak voltage of an AC circuit which has an RMS voltage of 115V?arrow_forward
- al Three coils each having resistance of 29 N are connected in star across 422 V, 50 Hz supply. Then the total power consumed is O 211.77 W O 3545.51 W O 730.95 W O 6140.83 Warrow_forwardTwo transformers rated at 100 kVA each are connected in an open-delta connection. What is the total output power that can be supplied by this bank?arrow_forwardWhat are some application of the bimetal strip?arrow_forward
- Electrical Transformers and Rotating MachinesMechanical EngineeringISBN:9781305494817Author:Stephen L. HermanPublisher:Cengage LearningUnderstanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage LearningRefrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning