10. Given the following information and figure determine Qr.Oc = 3 daysV= 100,000 m3X (MLVSS in bioreactor)= 2500 g/m3Xr = 8,000 g/m3Q = 100,000 m³/dXe = 30 g/m3QQ.

Answered: Image /qna-images/answer/1c7d684d-32c1-48e1-8469-06fd4fcd5afd.jpg

Answered: 10. Given the following information and…

10. Given the following information and figure determine Qr. O. = 3 days V= 100,000 m³ X (MLVSS in bioreactor)= 2500 g/m3 Xr = 8,000 g/m³ Q = 100,000 m³/d Xe = 30 g/m3 Q

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The Proctor test is used to determine the relationship between ---------- and -------- of a soil for…

A: The Proctor test is used to determine the relationship between ---------- and -------- of a soil for…

Q: 1. Project points (P), which is positioned at distances of 20 mm & 10 mm away from V.P. and H.P.,…

A: Point is 20 mm away from V.P means either point is 20 mm front of V.P or 20 mm behind V.P. Point is…

Q: The most important buffer system in water is the carbon dioxide system of acid/base reactions.…

A: Alkalinity of any solution defined as the ability to neutralise the H+ ions in the solution. here…

Q: E = 207GA Poisson's 12kN/m CROSS-SEcnON OF BEAM 4okN OKN rafio:03 C 14.27KN 10. 36KN 51-37 kN O. Im

A: Given data: b=0.1 m d=0.3 m E=207 GPa

Q: Angle of internal friction for a given soil is the angle on the graph (Mohr's Circle) of the shear…

A: The correct answer is true.

Q: What is the amount of moisture to be removed from a material whose moisture content is 14% with dry…

Q: Please refer to the figure shown below. IfP is equal to 6,720 lb., and if all the rods have a…

Q: SITUATION: A rectangular channel conveying water enters a transition region. The depth of flow in…

A: Given data in question Rectangular channel Depth before and after jump To find out Minimum…

Q: In a given fluid, positive ions, each with three excess protons, move towards right at a steady rate…

Q: Two soil specimens with identical geometric dimensions were subjected to falling head permeability…

Q: The beam is constructed from four boards as shown. If it is subjected to a moment Mz = 16 kips-ft,…

A: Given Mz= 16 kips-ft Determine the stress at points A and B.

Q: A PL 38 x 6 tension member is welded to a gusset plate as shown in figure. The steel is A36. PL % ×…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: sample of dry, cohesionless soil has an angle of internal friction of 30º. If the minor principal…

A: step 1-

Q: Q 2/ classify the $tames below and determime ' bhe D,e.f A A cp=?

Q: how many sheet of plywoodwill be needed to form the decking

A: The requirement of number of plywood sheets is calculated by dividing the area to be decked by the…

Q: The hanger for each chandelier in the grand ballroom of a five – star hotel is composed of a 2 m…

A: D = Diamter of ring = 2 mw = Self weight of ring = 2.5 KN/mh = Height of ring from ceiling = 3 m

Q: 2 B 20' SITUATION 01 A 20-lb lighting fixture shown in Fig. ESS4-TE-001 is suspended from the…

Q: Two soil specimens with identical geometric dimensions were subjected to falling head permeability…

Q: A 2 m long shaft is transmitting 90 kW at 150 RPM. The allowable shear stress in the material is 60…

Q: Find the void ratio, porosity, degree of saturation, total density of soil sample has volume of 100…

A: step 1-

Q: the BOD analysis on an industrial w: so that the initial bacterial density it ired to produce a…

A: using relationNt=NoektNt=20e0.04t

Q: cite literature that discusses the use of weir in field application

A: Weir- A weir is a tiny dam that spans a body of water like a river. We utilise them to aid in the…

Q: end of compaction, the in-place void ratio was found to be 0.70. If the moisture content of the soil…

A: We will use formula of void ratio.

Q: On a two-lane signalized intersection approach that has a peak 15-minute arrival rate of 900 vph, a…

A: Traffic volume(q) = {g/c}×Traffic capacity Where g= effective green time c= cycle length…

Q: GL Sand Water table is at ground level Water content = 20% Specific gravity of solids 2.7 Unit…

Q: SITUATION: The pipe system shown in figure serves two towns Cand D. The highest building in town C…

Q: efficiency of flocculant settling if tank depth is 3 m

A: To find the efficiency of the settling tank with depth of 3m and surface loading rate of 4m/hour.…

Q: Two soil specimens with identical geometric dimensions were subjected to falling head permeability…

Q: A circular plate of 2 m diameter is submerged in an oil (poil = 820 kg/m³) with its greatest and…

Q: he flow of a river is 150 cubic feet per second at a site where a 75 feet hydrostatic head can be…

A: step 1-

Q: A footing 2 m x 3 m in size transmits a bearing pressure of 140 kN/m2 on a soil x 104 kN/m2 and u =…

Q: Q3. The following is an S-hydrograph resulting from an intensity of 0.5 cm/hr.: Time (hr) S-curve…

A: Given: S- hydrograph Intensity = 0.5 cm/hr

Q: Minimum net soil pressure in kPa. 56 39 304 152

Q: The dilution water which is to be used for the BOD analysis on an industrial waste was seeded with…

A: using relationNt=NoektNt=40e0.04t

Q: The coefficient of permeability (K value) of a soil describes how easily a liquid will move through…

A: Soil mechanics : The behavior of soils is described by soil mechanics, a part of soil physics and…

Q: pavement

A: 'Pavement rehabilitation program refers to the initiative taken by any Government or organization in…

Q: QUESTION 1 A drum mix asphalt plant is different than a batch mix asphalt plant. O True O False

A: Q1- A drum mix asphalt plant is different than a batch mix asphalt plant.

Q: 3- A 40-ft simple span beam supports a concentrated service live load of 32 kips at midspan and the…

Q: For a flow a net with Nf 5 and ND = 20, the shape factor. %3D %3D 4. 0.5 0.25

A: Given data in question Constants value To find out Shape factor

Q: 10-63. Determine the moments of inertia of the shaded area with respect to the u and v axes. Prob.…

Q: 5 D Ag Ac Wg = 2000 N Wc=2900 N Support tower L = 30,5 m SITUATION 02 Two gondolas on a ski lift are…

A: Determine the stress (MPa) in the cable BC

Q: Two soil specimens with identical geometric dimensions were subjected to falling head permeability…

Q: Which state describes soil that does not deform (choose correct state that applies). A) Plastic…

A: Correct option is D) Solid state

Q: Determine the maximum deflection of a simply supported beam. The beam is 14 ft long and has a…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: Consider a large cubic ice block floating in seawater. The specific gravities of ice and seawater…

Q: The water–cement ratio is important because it influences all of the desirable qualities of…

A: Solution-(a)The water cement ratios is calculated using voids that are not filled with asphalt.(b)…

Q: For the truss shown, assume a cross sectional area of each member is 3.2 in? a. Calculate the stress…

Q: GL 7:00 Sand Water table is at ground level Water content = 20% Specific gravity of solids 2.7 Unit…

Q: A cylindrical tank, 1.20-m diameter and 2.50m high weighs 2850 N. The tank float in water with a…

A: Diameter of cylinder, D=1.2mHeight of cylinder, H=2.5mCylindrical tank is floating with a draft of…

Q: Show an illustrative example of a case where there is conflict between written specifications and…

Concept explainers

Landfills

The landfill is a site used for the disposal of waste materials. The landfill is a solid waste facility that is often known as a dumping ground. The image below shows a landfill site in Hawaii. Landfilling is the most ancient and common method used for the disposal of waste. For the landfill, a deep trench is constructed in an isolated place away from the city. The trench for landfills is designed properly after analyzing the total population and the waste generation per capita. The waste is dumped into the trench and after every layer of waste, a layer of soil is spread on the top of it.

Question

10. Given the following information and figure determine Qr.
Oc = 3 days
V= 100,000 m3
X (MLVSS in bioreactor)= 2500 g/m3
Xr = 8,000 g/m3
Q = 100,000 m³/d
Xe = 30 g/m3
Q
Q.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Write the simplified equation for estimating TSS as a function of Q. Determine the 2 parameters associated with this relationship if TSS is 89 mg/L at Q = 8 m 3 /s and TSS is 109 mg/L at Q = 12 m 3 /s? What will be the TSS if Q is 20 m3 /s?
An engineer wanted to determine Q20 when he designed a bridge for a highway. He collected and recorded the measured discharge from a station of the river as shown in the following table. He assumed the flood frequency follows the LP3 distribution. Determine Q20. Values of z used for flood frequency analysis as given as follows ARI z 100 2.326 50 2.054 20 1.645 10 1.282 0.842 Run Q (m³/s) 1 130 430 3 130 4 180 80 380 280 8. 180 9 230 10 330 2.
10. Compute BOD5.20 if BoD1-25 = 95 mg/L for a waste water sample?
Question 4 Screenings are placed in a debris roll-off dumpster that holds 20 cubic yards of screening. How long will it take to fill the 20 cubic yard dumpster in days? Known Unknown Flow 8.0 MGD Time to fill dumpster, days Screening removed gal/day-100 gal/day Capacity of dumpster = 20 cubic yards 7.48 gallon in a cubic ft (ft3) 27 cubic ft in a cubic yard (yd3) = O 0.72 days O 100 days O 40.39 days
The water in an open channel drainage canal flows with a velocity of VA = 1.5 m/s into the drainpipe that crosses a highway embankment. Suppose that d = 750 mm A 1m 1.5 m/s 3.5 m B Part A Determine the volumetric discharge through the pipe. Neglect any head losses. Express your answer to three significant figures and include the appropriate units.
7. If the BOD5 of two wastes having k values of 0.0800 d-¹ and 0.120 d'¹ is 280.0 mg/L, what would be the ultimate BOD for each?
2.41. What conclusion can be drawn from the results given below for a BOD analysis made using three dilutions? PERCENT WASTE 1 2 3 BOD. g/m³ 200 120 80
Following observations were made on a 4% dilution of waste water: DO of aerated water used for dilution = 4 mg/It. DO of diluted sample after 5 days of incubation = 0.8 mg/lt. DO of original waste water sample = 0.5 mg/lt. What is the value of ultimate BOD? [Take Kp (at base 10) = 0.12 day
Q2: Water is delivered from a reservoir to an irrigation project through an earthen canal at a rate of flow of 5 cumecs. The seepage losses in canal were estimated to be 0.1 cumecs/km, length of canal is 10 km, area of project is 1000 donum, and the depth of water to be applied and stored in the field is 10 cm. What is the application efficiency taking into account that water is applied on the field one day for irrigation? Assume that net area equal to gross area and tg = tn.
Q2: Water is delivered from a reservoir to an irrigation project through an earthen canal at a rate of flow of 5 cumecs. The seepage losses in canal were estimated to be 0.1 cumecs/km, length of canal is 10 km, area of project is 1000 donum, and the depth of water to be applied and stored in the field is 10 cm. What is the application efficiency taking into account that water is applied on the field one day for irrigation? Assume that net area equal to gross area and t, = tn.
During a month a lake received an average inflow 6 m3/s , in the same month the outflow was 6.5 m3/s write the water budget equation and calculate the difference in storage in that month by m3
A water sample is analyzed for BOD on a daily basis for 7 days using the dilution method. Results of analysis show k-0.23d¹ and BODu = 15g/m³. Twenty day samples have also been analyzed and the BOD value is consistently 23 g/m³. What might cause the difference between estimated and measured BOD values?