2 A 4 V + 12 V Find the power absorbed or supplied by element 3 in Figure shown below. 12 V 2Vx 12 A + 4 A + 2 A 2 16 V + 3 V₂ + 4 | 20 V 2 A

Q: An LVDT is used to measure 1 mm displacement for which a voltmeter of range 0 to 2 Volt through an…

A: Given a Linear Variable-Differential Transducer with, Displacement, d = 1 mm. Voltmeter of range 0…

Q: H.W A 15nc Point charge is at the origin in Free Space calculate V₁ if Point Pi Vielf beated P,…

A: An area of space surrounding an electrically charged particle or object known as an electric field…

Q: The line input to a three-phase star connected alternator having a line input of 400V 50Hz supplies…

A:

Q: . Consider a unity-feedback control system whose open-loop transfer function is: ke-0.8s s+1 G(s): =…

A:

Q: A 4-pole d.c. shunt generator has 36 slots with 10 conductors in each slot. The flux is 0.03 wb and…

A:

Q: 3. The following waveform was derived from an oscilloscope. CH1 (Yellow) Settings Volts/Div: 50V…

A: Given: Oscilloscope functions: Waveform of the oscilloscope

Q: b) In free space a two point charges; Q1=2nc at (3,2,0) and Q2-5nc at(-1,-2,3). Find the potential…

A: Given,At 3,2,0 point charge Q1 is located.Q1=2 nC.and,At -1,-2,3 point charge Q2 is located.Q2=5…

Q: 4 Find the F.T. of the following Signals using differentiation prop. Ans FCW) - 2A (cosaw - Cosbu -…

A: We have to calculate fourier transform of following signal using differentiation property : we…

Q: Sol Axit A y(t) = x(t)h(t). = x(t) @ [s(t) = S(t+1)] - = X(t) Sit) - X(t) @ S(t+1) = X(t) = x (t+1)…

A: Given: Solution of a question. To do: We have to just explain last step.

Q: A strain gauge having a resistance of 500 ohm and a gauge factor 3.0 is bonded on a member of…

A: Given a strain gauge having, Resistance, R=500 Ω. Gauge factor, GF=3. Change in resistance, ∆R=1.5…

Q: 10. The following is part of a larger circuit. The 4 branches extending outward are not open…

A: We need to find out current and voltage for given circuit

Q: A 500 kVA, 6.6 kV star connected alternator has a synchronous reactance of 1.0 2 per phase and…

A:

Q: Calculate the values of i2, 13, V2, V3,Vc and v₁ in the network shown in Fig. at the following times…

A: We have been given an network as shown in figure, We need to determine the value of, i2 , i3 , V2 ,…

Q: (2) Convert the following voltage sources, which are shown in the following circuits, into…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: C₁ = =/2 - 3 -2 ≤n≤2 -> Up to 2nd harmonic C-HS Cn= 2-2jzn iztufont (fo== == ) X(t) = 2 Cnie n=-06…

A:

Q: Find all the prime implicants for the following Boolean functions, and determine which are…

A: It is given that: F (A, B, C, D)=Σ(2, 3, 4, 5, 6, 7, 9, 11, 12, 13)

Q: A cast steel ring has a circular cross-section of 3 cm in diameter and a mean circumference of 80…

A: We have an cast steel ring with, Cross-section  = 3 cm = 0.03 m Mean circumference (lc) = 80 cm Flux…

Q: 12 v 100 Ω B 200 Ω · A C E 300 < What is the Equivalent Resistance through A to E?

A: Given circuit:

Q: A 3-phase transmission line operating at 10 kV has a resistance of 192. The percentage resistance of…

A: Given, A 3-phase transmission line with, Rated line voltage, V = 10 kV Resistance, R=1 Ω Base kVA =…

Q: Determine whether or not each of the following signals is periodic. If a signal is periodic,…

A: Given here a function and asked to find the time period.

Q: 4 Find the F. T. of the following Signals using <<-2 2 2 t differentiation. prop. 2 Ans F(w) =…

A:

Q: Q5) A dipole with +Q-2nc at (2, 3, 4.01)m and -Q- -2nc at (2, 3, 3.99)m,in free space. find: i) the…

A: Given +Q = +2nc at P1(2,3,4.01) -Q = -2nc at P1(2,3,3.99) Find following Dipole moment Electric…

Q: 6. If the rms current through a 4.7 k resistor is 4 mA, the peak voltage drop across the resistor is…

A: We need to find out peak Voltage for given current and resistance

Q: power factor on 1100 V, 50 Hz mains.  The power factor of the system is improved from 0.6 lagging to…

A:

Q: Example 4.2: Use the the circuit 201 4.2: Use the node-voltage power dissipated рошет + shown in…

A:

Q: A 430 V shunt motor has an armature resistance of 0.6 Ω and a field resistance of 250Ω. Determine…

A:

Q: The resistance and reactance of the primary winding of a 440/110 V single phase transformer are 4.4…

A:

Q: What is the simplified algebraic expression for the logic gate shown? X xa Y OX + Y OX.Y OX.Y ΟΧΘΥ…

A: Given, The logic gate,

Q: 6 In terms of their constructional features, transformers are classified in to: Core and Shell Types…

A: A transformer is an electrical energy transfer static device that either steps up or steps down the…

Q: 1. x(t) = elalu(t) a > 0

A:

Q: The reverse recovery time of a diode is t,,= 6 us, and the rate of fall of the diode current di/dt =…

A:

Q: Given the difference equation: y(n) = 0.2y(n-1) + 0.2y(n − 2) + 0.1u(n-1) 1-Find the discrete…

A: Given the difference equation, yn=0.2yn-1+0.2yn-2+0.1un-1 To find:  1) Find the discrete transfer…

Q: QUESTION 9 What is the function of the analog-to-digital (A/D) converter circuit used in analog…

A: There are two types of converter: 1. DAC(digital to analog converter): It is used to convert digital…

Q: The RMS value of the signal shown in the figure is: f(t) 10 -10 0 1 23 4 5 6 t(sec)

A: Given waveform,

Q: The four diodes used in a bridge rectifier circuit have forward resistances which may be considered…

A: We have an Four diode bridge rectifier circuit having forward resistances which is considered…

Q: A wave wound d.c. generator has 4 poles and the armature has 756 conductors. How fast should the…

A:

Q: Two capacitors of capacitances C₁ = 0.1 µF and C₂ = 0.2 µF are connected in series across a 300 V…

A: Given: Two capacitors are connected in series. Capacitance, C1=0.1 μF. Capacitance, C2=0.2 μF.…

Q: - V₁ 7 √√3+√√₂ =0 - (20) 1₂a + (65) Fon + (7) ₁₂ = 0 20 -62 F.A 7.02 -212 +61 + 710 =0 @ + Uke…

A: Given:

Q: A transmission line section and shows an input impedance of 36 2 and 64 respectively, when short…

A: Given, A transmission line section has, Input impedance when short circuited, Zsc=36 Ω. Output…

Q: 1. Implement a simplified logic circuit for the truth table in the figure: a) By means of nor logic…

A: It is given that:

Q: What is the simplified algebraic expression for the logic gate sho Doz X C Y OX+Y OX.Y OX.Y ΟΧΘΥ…

A:

Q: Using the voltage divider rule, find the indicated voltages V₁ and V₂ in the circuit shown below. Μ…

A: The given circuit is,

Q: 9.0 V 40 Ω www www 50 Ω Find the current I in the circuit shown in (Figure 2). Express your answer…

A: Given circuit:

Q: The dead zone in a pyrometer is 0.12 percent of the span. The instrument is calibrated from 500 °C…

A: Given: Dead zone in pyrometer = 0.12 %. Instrument is calibrated from 500 oC to 2000 oC, Span = 2000…

Q: Find the F.T. of the following Signals using differentiation prop. 2 d 2 : 4 (sin² (w) - 2 Sinc…

A: According to the Fourier transform's time differentiation property, a function's differentiation in…

Q: 35. Fig. 29.17 shows the single line diagram of a 3-phase transmission line. The three phase short…

A: Given a single line diagram of 3-phase transmission line. The two fault points are F1 and F2.

Q: A symmetrical fault occurs on a power system. The percentage reactance of the system on 2500 base…

A: Given: A symmetrical fault occurs in a power system with, Base kVA = 2500 kVA. Percentage reactance,…

Q: C₁ = [0.05P2 + 20P₂ + 30]; $ hr C₂ = [0.056P2 + 15P₂ +40]; hr Here P₁ and P₂ are in MW. Each…

A:

Q: QUESTION 4 What are the advantages of using high-density modules? O It allows for the possibility of…

A: Modules: Modules are manufactured by placing cells in a particular area or in other words when cells…

Q: 1- For a system with the transfer function Y(s) 2s³ - 12 U(s) 4s5 S3 + 4s 10 The state matix is…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.