3. An open tank is filled with water. The depth of water is 12m. Assume the density of water to be 1000 kg/m³ and the atmospheric pressure is 101 KN/m². Determine: (i) the gauge pressure of water at the bottom of tank. (2 marks)

3. An open tank is filled with water. The depth of water is 12m. Assume the density of water to be 1000 kg/m³ and the atmospheric pressure is 101 KN/m². Determine: (i) the gauge pressure of water at the bottom of tank. (2 marks)

Name: 3. An open tank is filled with water. The depth of water is 12m. Assu
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 3. An open tank is filled with water. The depth of water is 12m. Assumethe density of water to be 1000 kg/m³ and the atmospheric pressure is101 KN/m². Determine:(i) the gauge pressure of water at the bottom of tank. (2 marks)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
Determine the volume of the concrete arch dam.
Determine the pressure at point B (in psia) knowing that the pressure at A is 350 psig. air A water 7 in oil 3 in (SG = 13.5) 2 in water 5 in mercury (SG = 13.5) 4 in B Answer: 364 psia
Determine the pressure difference between points C and D. Take the specific weights to be Benzene: 8640 N/m³, Mercury:133100 N/m³ Kerosene: 7885 N/m?, Water: 9790 N/m2, Air: 12 N/m³. Water Benzene Air D 50 cm 19 cm 30 cm 24 cm $18 cm Mercury Kerosine (answer) Pa
Determine the pressure difference between points C and D. Take the specific weights to be Benzene: 8640 N/m?, Mercury:133100 N/m? Kerosene: 7885 N/m³, Water: 9790 N/m², Air: 12 N/m³. Water Benzene, Air D C 50 cm 19 cm 30 cm 18 cm 24 cm ст Mercury- Kerosine (answer) Pa
A simple manometer is used to measure pressure of oil (s= 0.8) flowing in a pipe line. Its right limb is open to the atmosphere and the left limb is connected to the pipe. The cente of the pipe is 9 cm below the level of mercury (s=13.6) in the right limb. If the difference of mercury level in the two limbs is 15 cm, determine the absolute pressure of the oil in the pipe in kPa. a.25.11 b.120.58 c.278.6 d.64.74
(b) A vessel of 4 m? volume contains an oil which weighs 30.2 kN. Determine the specific gravity of the oil.
A U-tube manometer filled with mercury is attached to a gas tank. The level ofmercury on the open end of the manometer is 40 cm higher than the level at theend attached to the tank. What is the gage pressure of the gas inside the tank? a) what is the absolute pressure of the gas inside the tank? b) if the level of mercury on the open end is 60 cm lower than the level atthe end attached to the tank, what is the absolute pressure of the gas?
A simple manometer used to measure pressure of oil (sp. gr. = 0.98) flowing in a pipeline. Its right limb is open to atmosphere and left limb is connected to the pipe. Centre of the pipe is 10 cm below the level of mercury (sp. gr. =13.6) in the right limb. If difference of mercury level in the two limbs is 16 cm, Determine the pressure of oil in the pipe in N/m² with a neat diagram.
Q5 A U-tube manometer similar to that shown below is used to measure the gauge pressure of water (mass density p = 1000 kg /m3). If the density of mercury is 13.6 x 103 kg /m³, what will be the gauge pressure at A if h1 = 0.45 m and D is 0.7 m above BC. Wwater Wmercury
2. of 1.0 Two oil tanks are connected to each other through a manometer. If the difference between the mercury levels in the two arms is 32 inches, determine the pressure difference between the two tanks. The specific gravities for oil and mercury are 0.72 and 13.6, respectively. 3. A 3 rectangular gate is hinged at the top edge A and is restrained by a fixed ridge at B. Determine the hydrostatic force exerted on the gate by the 5 m high water and the location of the line of action of the force Oil P₁ 10 in 32 in 2m Oil P₂ Mercury