A coil of inductance 160 mH and resistance 25 Q is connected in series with a 60 2 resistor to a 340 sin(314t) V supply. Determine (a) the current in the circuit, (b) the complex, the apparent and reactive power (c) the power factor of the circuit (d) the potential difference across the 60 2 resistor and the potential difference across the coil. (e) Draw the circuit phasor diagram showing all voltages.

A coil of inductance 160 mH and resistance 25 Q is connected in series with a 60 2 resistor to a 340 sin(314t) V supply. Determine (a) the current in the circuit, (b) the complex, the apparent and reactive power (c) the power factor of the circuit (d) the potential difference across the 60 2 resistor and the potential difference across the coil. (e) Draw the circuit phasor diagram showing all voltages.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
AC Circuits Sine-wave generator f- 25 kHz V₁ = 3.0 V VR 888 100 mH Figure 6-Test Circuit 3. Using a two-channel oscilloscope, measure the peak-to-peak voltage VR across the resistor and the peak-to-peak voltage VL across the inductor. Measure the voltage across the inductor using the difference technique described in a previous experiment. Record the voltage readings in Table 2. VL 10 k 1 XL Table 2- Measured and Calculated Values (f = 25 kHz) ZT
3. Sketch the current waveform for the circuit in Figure below. The diac has a breakover potential of 20 V. IH = 20 mA. 25 V rms R 1.0 ΚΩ
Two 10 uF capacitors have been connected in parallel across a 230 V 50 Hz AC supply. The current drawn from the supply will be approximately: Select one: a. 1.44 A b. 0.36 A c. 11.5 A O d. 23.0 A
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
The circuit in the figure is fed by a sinusoidal alternating voltage with a frequency of 50 Hz. The circuit consists of a resistor and a capacitor with the capacitance C= 600 μ Q. The power supplied to the circuit is P=400 W and the voltage across capacitor is UC=90 V. a) Calculate the current I. b) Calculate the resistance R. c) Calculate the voltage U (amount). d) Calculate the phase angle of the circuit
From the given circuit, what is the inductive reactance for the given inductance L (pick the value that is closes to given options). V-15 Vac R-1.5k L-50mH -3.183 kHz 100 ohms 1000 ohms 100,000 ohms 1000,000 ohms