A TDMA system uses 25 MHz for the forward link, which is broken into radio channels of 200 kHz. If 8 speech channels are supported on a single radio channel, how many simultaneous users can be accommodated?

A TDMA system uses 25 MHz for the forward link, which is broken into radio channels of 200 kHz. If 8 speech channels are supported on a single radio channel, how many simultaneous users can be accommodated?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4. Consider TDMA/TDD GSM system that uses 25MHZ for uplink and downlink transmission, which is…

A: We need to find out number of user for given system

Q: With a 1-MHz carrier, if the LSB extends down to 990 kHz, then the USB will extend up to

A: With a 1-MHz carrier, if the LSB extends down to 990 kHz, then the USB will extend up to

Q: If 280 kbps is to be sent over a noiseless channel with a bandwidth of 20 kHz, then how many…

A: Given information: Required data rate is r=280 kbps=280×103 bps Channel bandwidth B=20 kHz=20×103 Hz

Q: Consider a TDMA cellular system: a) The total system bandwidth is 50 MHz; b) FĎD is used; c) Each…

A: According to the question, we need to calculate two way voice channel. Consider a TDMA cellular…

Q: A path in a digital switched network has a data rate of I Mbps. The exchange of 1,000 bits is…

Q: Consider g(x)= x3 + x + 1, with 1001 as the information sequence. Determine the transmitted…

A: The g(x) is given byg(x) =x3+x+1Data word is given by 1001 or 1+x3Now the code wordc(x)=d(x)g(x)

Q: Evaluate IFFT then FFT for the data sequence (1, 2, 3, 4, 2, 4, 1, 3).

A: Here, we have given a data sequence for which we have to find the IFFT sequence first, and then we…

Q: Q1) What are the obstacles to sending in optical fiber ?

A: The answer as given below:

Q: It takes 1 hour to transmit a file of size 50 Mbyte, find the bit rate and interval. Also, if in the…

Q: Explain operation and structure of APD in Optical communication Answer should be according to…

A: Avalanche photo diode (APD) are high sensitivity, high speed semi-conductor light sensors. Of the…

Q: A friend of yours says that he can design a system for transmitting the output of a minicomputer to…

A: Your friend says he can design the system that can transmit the output of a mini computer to a line…

Q: Question 4 ( A voice-grade telephone line with bandwidth of 4 kHz (0- 4kHz) is to be used in…

A: Given,Bandwidth is,BW=4kHzFrequency deviation is,∆f=100 Hzandd=0

Q: B. Why VSB modulation is used in TV picture transmission?

Q: Example 6 Four channels are multiplexed using TDM. If each channel sends 100 bytes/s and we…

A: Given here a TDM Based question and asked to fine the frame size, duration of the frame, frame rate,…

Q: What is the delay of sending a data file a station to a destination station? Suppose that the length…

A: Given: Length of data file i.e. packet size is 1 Mbytes Bandwidth of the channel is 200 Kbps…

Q: Consider a CDMA system where transmitter A has the code 101010 and transmitter B has the code…

A: The given CDMA system transmitter A code is 101010. The given CDMA system receiver B code is 111001…

Q: Assume a digital communication system with the following specifications: the channel Pe=0.05, and…

A: Solution : Given ; Bit error probablility Pbe=0.05 Block code can connect maximum upto 3 bitsso,…

Q: The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What…

A: ISI stands for intersymbol interference. It a distortion which takes place during data transmission…

Q: Design a 3x8 decoder by using 1x2 DEMUXes.

A: According to the question we have to design a 3x8 decoder by using 1x2 DEMUXes.

Q: In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex…

Q: Determine the efficiency of transmission for QPSK modulation scheme at a .transmission rate of 10…

A: Bandwidth efficiency is the ratio of transmission rate to the minimum bandwidth.

Q: Q- To transmit the data 1011000 to his friend using hamming code technique. If during transmission,…

A: First we will create a hamming code for the signal Given data is 1011000 ; i.e we have 7 byte data…

Q: In your own words, explain the importance of line coder in digital communication. In…

A: Line coding Line coding also known as digital baseband modulation or digital baseband transmission…

Q: Question 3 For the network 129.120.0.0/16. How many 129.120.0.0/24 subnets exist? (numeric response)…

A: Given data:

Q: Identify the types of transmission mediums used for the following examples: - [Your answer should…

A: a) Long-haul network : It is anticipated that by the year 2010 over 900 billion voice circuit ·…

Q: Please solve this question in multimedia networks quickly

A: Bit rate given by Rb = nfs n is no of bits per sample fs sampling frequency.

Q: What is the difference between power gain and insertion loss in two-port networks?

A: Power gain: Power gain in two port nework is the ratio of the output power to the input power. It is…

Q: b) Three stations share a 60 kbit/s ALOHA channel. The average bit rates transmitted from each of…

A: b. Given data is Channel bit rate is 60 kbps ALOHA Channel each station transmission time is…

Q: xplain why we can still receive monophonic FM signal with our stereophonic FM receiver by showing…

A: An stereo receiver is an amplifier and switching device used for a stereo system. The input given is…

Q: Implement the following functions by using the same decoder circuit. f(a,b,c)=E (0,2,3,7) g(a,b,c)=E…

A: In this question, Implement the given function using the decoder. Here 3 input are given and 8…

Q: Suppose two hosts A and B, are separated by 10,000 kilometers and are connected by a direct link of…

Q: 04:4 a) a data rate of 30 MBit/second through this channel. According to the channel capacity…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: a. In your own words, explain the term companding used in telecommunications the important of that…

A: According to the question, we need to explain companding and also draw the differential manchester…

Q: Suppose you have a file of size 2 megabyte which contains 32 different 8-bit chars of the same…

A: According to the question we have to find size of the compressed file in megabyte with the help of…

Q: In a telephone TDM system, a DS0 has a capacity of 64kbps and a T1 link rate is 1.544Mbps. How many…

Q: R₂1 to transmit a packet into its link (i.e., the packet transmission delay at the sender)?

A: Solution- GIVEN, Packet size = 1Mbit (106 bits) Transmission rate = 100 Mbps (100 x 106 bits per…

Q: The modulation index units in AM is measured in volts since it is amplitude based, while the…

A: Modulation index in amplitude modulation can be found by taking the ratio of amplitude of modulating…

Q: Determine the efficiency of transmission for QPSK modulation scheme at a .transmission rate of 10…

Q: (b) In a particular implementation of ADSL2+, 400 downstream subchannels are being used to achieve a…

Q: 3.0.5 Petabits per second (Pbps) is a transmission with a bit-rate of

Q: 7. A CDMA receiver gets the following chips: (-1 +1 -3 +1 -1 -3 +1+1). Assuming the chip sequences…

A: Given information: The CDMA receiver receives the following chips: -1+1-3+1-1-3+1+1

Q: If the sequence 111111 is transmitted using Differential Manchester encoding. what is the ratio of…

A: The baud rate is the rate at which information is transferred in a communication channel. The rate…

Q: 05] Assume a digital communication system with the following specifications: Pbe=0.05, (n,k) block…

A: to find The average number of errors in every transmitted codeword. (b) The number…

Q: Assume that two hosts are directly connected via a submarine optical fiber cable, which goes from…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: An optical Fibre System is to be installed between two towns that are 74 Kms apart. If the fibre has…

A: The solution is given below

Q: For a transmission medium, SNRdb is given as 30. If bandwith is selected as 9,06 MHz, which answer…

Q: In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex…

Q: 4. How much is the percentage increase in bandwidth efficiency if a broadcast system shifts from 8…

Q: Consider a packet switched network, where one packet of size 10000 bits is send from Host A to…

A: The data rate of each link is 2kbps means 2kb data is sent through it within a second, using the…

Question

A TDMA system uses 25 MHz for the forward
link, which is broken into radio channels of 200
kHz. If 8 speech channels are supported on a
single radio channel, how many simultaneous
users can be accommodated?
a) 25
b) 200
c) 1600
d) 1000

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

if a noiseless channel, if the bandwidth is 2 KHZ and there are 16 voltage levels, what is thw Data rate? a. 8kbits/sec b. 16 kbits/sec c. 8000 bits/sec d. 12 kbits/sec if the frequency is 1014 , then the wevelength a. 3x10-6 meter b. 3x10-8 meter c. 3x10-6 meter d. 3x10-5 meter
Six 100-kbps connections are multiplexed together. A unit is 1 bit. Determine the rate of the transmission link in kbps.
Modulation index for AM system is 0.35. what will be the efficiency of the AM system? Also, what is the theoritical maximum efficiency of AM system?
The following data are transmitted in a serial communication system (P is the parity bit). What parity is being used in each case? a. ABCDEFGHP = 010000101 b. ABCDEFGHP = 011000101 c. ABCDP = 01101 d. ABCDEP = 101011 e. ABCDEP = 111011
Que.26 What are Optical couplers? What are the functions of Couplers?
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in the system.Depending on the information given above, if the initial frequency of the frequency spectrum used by the FMDA system in one direction is 1000 MHz, which of the following is the correct spectrum of the bond's spectrum.A1.000.000 KHz - 10000.080 KHzB1000.000 KHZ - 1.000.040 KHzC1.000.000 KHZ - 1.040.000 KHzDNoneE1.000.000 KHZ - 1.020.000 KHZ
7. The constellation diagram for a modem that is used for transmission via an analogue channel is shown in the picture on the right. a. What kind of modulation is used? FSK, PSK, QAM or ASK? b. What is the bit rate if a symbol rate of 60 MBaud is sent?
solve all questions on Keyboard and all parts or will dislike answer Even if the received modulated signal is distorted, it is relatively easier to decode when A) using Analog modulation B) using Digital modulation TDMA is more flexible than FDMA in terms of resource allocation A) true B) False Fill in the blanks choosing from one of the options shown below: Transmitting the same signal on separate frequencies is also known as ……………….. and using two or more antennas for reception is also known as …………… a. (Frequency multiplexing , antenna multiplexing) b. (Frequency diversity , antenna diversity ) c. (Spatial diversity , spatial multiplexing) d) None of above Which of the following is secure by design, i.e. security is built into the design itself. b. CDMA a. FDMA c. TDMA Point to point microwave links are an attractive way of setting up wireless backhaul links A) TRUE B) FALSE
How does modulation enable data transmission over different transmission media, and what are the various modulation techniques?
Consider a CDMA system where transmitter A has the code 101010 and transmitter B has the code 111001. Assume that 1 is represented by +1V and 0 is represented by -1V. Show that the two CDMA codes (after mapping them to voltages) are orthogonal to each other. What is transmitted if A sends a bit of 0 and B sends a bit of 1? What did A and B most likely transmit if the received word is “-1 -1 -1 +1 +1 +1”?
PART I- PULSE MODULATION a. In your own words, explain the importance of line coder in digital communication. b. In telecommunication, a line code is a pattern of voltage, current, or photons used to represent digital data transmitted down a transmission line. Assuming that you are about to send a set of bit string: 1000 1001 1101 0110 down to the transmission line, illustrate the resulted coded signal after it went through line coder using bi-phase M code formats.
Z1 A16 A Yo O + ROMCS A17 Y,O RAMCS Y2 O RESM* 22 Y3 23 Z4 A6 A Yo O RESP* A7 PIACS Y2 O SIACS Y3 0 PTMCS If the MC68K is running at 10 MHz, the access time of the devices on the asynchronous bus must be at most