An Ac circuit with a Power Source has a resistor and an inductor connected in paralle!. The values are as follows: V = 194 R = 104 XL = 81 What is the power factor?

Q: Find the voltage Vy. What is the power delivered or absorbed by the dependent source? 29ip 500Ω Ν…

A:

Q: c) Four diodes are used to construct a single phase full-wave bridge rectifier circuit which is…

A:

Q: #3. Given v1(t) =200 sin (wt + 60°) and v2(t) = 460 cos (wt -10°), find the phase angle between the…

A: In this questions We need to determine the angel between both signal.  We are solving this problem…

Q: B-6-3. Plot the root loci for the system with K s(s+ 0.5)(x² + 0.6s + 10) G(s) H(s)-1

A: given that  open-loop transfer function is    G(s) =ks(s-0.5)(s2+0.6s+10) feedback path gain is H(s)…

Q: QUESTION 7 With reference to the instruction below, what is the value of the number stored at…

A: Choose the correct answer:

Q: 2 Cπ 2π α 2 SVm² sin wt² dwt

A:

Q: QUESTION 10 With reference to the instruction below, what will be the value of each of the bits in…

A: We need to select correct option for given instructions .

Q: Figure 2-32 Closed-loop system. R(S) Ge(s) Controller Gp(s) Plant D(s) C(s)

A: We need to find out the output due to both input.

Q: Consider each of the following four types of oscillations: A. underdamped B. critically damped C.…

A: Four types of Oscillations:

Q: 1,5 V 2.25 VI Determine U,, in the op amp circuit 20 ΚΩ Μ 5 ΚΩ 10 ΚΩ 10 ΚΩ Μ 30 ΚΩ 50 ΚΩ 40 ΚΩ 80 ΚΩ…

A: Given: In this question, the given details are, The given circuit is, To find the value of the op…

Q: Determine the bandwidth (in rad/sec) of a parallel RLC circuit. R = 774 ohms, L = 8 mH, and C =…

A: **In the first image, I have defined all the formulae and information about the Parallel RLC…

Q: *2.17 Determine currents I₁ to 14 in the circuit of Fig. P2.17. I 12 2Ω Σ4Ω 16A 13. I ΖΩΣ Figure…

A: The given circuit diagram is shown below,

Q: What resistance value would you have to change R2 to such that the net currents through R4 and R5…

A:

Q: In Fig. A10, the current I is: 6 A

A: Given data, Circuit diagram is given as,

Q: What if power is transmitted to everyone at 200 V instead of using a 9,000 V transmission line? By…

A:

Q: 2. A resistive load of 1002 is connected through a half-wave SCR. circuit to 220V, 50 Hz, single…

A: Given data: The resistance is R=10 Ω The given voltage is V=220 V The frequency is f=50 Hz The…

Q: 1. Find the transfer function and the corresponding poles for the following state-space system: [8…

A:

Q: C [H.W3]: For the circuit shown below; find vo? R₁ = 1KR²₂ R₂ = 2K₁r R₂ = 3 Kr R₁=9kr Ans: Vo= 6v₁…

A:

Q: In a hydro-electric station the volume of water which can be utilized per annum is 5* 10⁹m³ with a…

A: Volume of water used per annum = 5×109 m3 Head = 30 m Efficiency η=70% Load factor = 40% We have to…

Q: QUESTION 6 With reference to the instruction below, what values will be stored in file #N7:10 when…

A: PLC: Choose the correct answer for given instruction:

Q: The modulated signal s(t)=[A1+A2cos(21f1t)]cos(21f2f) was generated by modulating a sinusoidal…

A: Given: Modulated signal is st=A1+A2cos2πf1tcos2πf2f

Q: A. What is the advantages and disadvantages of using negative feedback? B. Why the bandwidth of the…

A: We need to explain the advantage and disadvantage, we need to explain bandwidth of op amp and slew…

Q: Q3: For a binary symmetric communication channel, compute the overall probability of receiving a bit…

A:

Q: WN is WN¹

A: the inverse of DFT coefficients matrix of is w-1 some basic detials, Definition; Let x be an N×1…

Q: Consider a transconductance amplifier that has a high-pass filter frequency response. The transfer…

A: Given,DC transconductance, tvs=1.1 mA/VInput resistance, Ri=500 ΩOutput resistance, Ro =110…

Q: P 14.6-4 Using Laplace transforms, find ve(t) for t> 0 for the circuit of Figure P 14.6-4 when (a) C…

A: Given: The circuit diagram can be given as,

Q: Q.12 The gauge factor of a resistance strain gauge is 2. It is subjected to a strain of 2 x 10-6. If…

A: Given- Gauge factor Gf=2, Strain =2×10-6, Original resistance =175 ohms, To Find- The value of the…

Q: 3 D. (1) F (11) F 4. Decide whether each of these statements is True (T) or False (F). For the model…

A:

Q: What resistance value would you have to change R2 to such that the net currents through R4 and R5…

A:

Q: If I the star is substituted with delta, what is the value of RB? 42 RB ул. дл RA m 82 Rc &82

A:

Q: 1. Using the superposition principle, find io and vo in the following circuit. 1 10Ω 20 Ω 6A 40 Ω 30…

A:

Q: We randomly take 10 units from the production of a machine whose production rate is 10% damaged.…

A: Probability problem:

Q: Q2:Two dice are thrown together. Let A be the event getting less than 3 (A2) on the second die. Are…

A:

Q: QUESTION 1 Using the SI symbols, epress the following measurments in engineeing notation 95000 Q…

A:

Q: A electrical company provides power to a house at 220V  AC and can supply up to 600A, for a maximum…

A: Given data: The resistance is R=0.02 Ω The voltage is 220 V

Q: patterns. (a) x(n) = (1 + n)u(n) -n (b) x(n)=(a" + a¯" )u(n). a real

A:

Q: Given the circuit from class and that v(t)- 155.56cos(377t+23.8°) solve for the voltages, currents,…

A: For the given circuit calculation of part 1,2,3 only as mention. Given: v(t)=155.56cos(377t+23.8°)V…

Q: 11. Phase-shifting transformers used in the metering of apparent power demand of polyphase circuits…

A:

Q: If f = 1 GHz Hr=1, E₁₁ =3, 0₁ = 5.8 S/m then (intrinsic impedance) ₁ = ? (2)

A:

Q: 1) DEFINE what is a waveform  2) what is the point of this experiment? 3) why do we need to…

A: A waveform is a representation of a signal as it varies over time. In electronics, waveforms are…

Q: Part B How much energy is delivered to the circuit element between 0 and 1.6 ms? Express your answer…

A: It is given that: v=e-500t-e-1500t Vi=30-30e-500t+10e-1500t mA

Q: What statement best describes the following signal: 1 13 2π -лt+ x(1) = }} sin -∞0 <1 < 00 33 A…

A: It is a sinusoidal signal with some phase deviation. Hence it is a :  1) Real signal 2)…

Q: 6. For a rotational system, the output is related to the input T by the differential equation: d²e…

A: Given: Id2θdt2+cdθdt+kθ=T

Q: True or false  1- Management it control and application everything in work place only.?  2-…

A: we have to tell the given statement are true OR FALSE with explanation

Q: For the circuit shown determine Vx V2 5V- R4 1k 11 0.02 A Vy

A: We need to find out the voltage across the resistor .

Q: Find the required in the circuit each circuit using superposition.

A:

Q: A series RL circuit connected to a 110-V ac source. If the voltage across the resistor is 43 V, the…

A: Given,AC voltage source, Vs=110 VandVoltage across resistor, VR = 43 V

Q: For a seven-point moving average system analyse and approximately sketch the magnitude and phase…

A: Seven Point moving average system:

Q: 4) Sketch the MUX equivalent for the function (F= BC + AC).

A:

Q: A fluid system has two sensors, a pressure sensor and a flow sensor.  The pressure sensor has one…

A: (3-a)  This is a digital electronic problem. When comparing analogue and digital electronics, it…