Calculate the active power in a 487 H inductor. a) 2482 W b) 1545 W c) 4565 W d) O W
Q: A 900 Ω resistor, a 0.25 μF capacitor, and a 2.5 H inductor are connected in series across a 240 Hz…
A: Series RLC circuit Resistance R=900 Ω Inductance L=2.5H Capacitance C=0.25μF Frequency f =240 Hz AC…
Q: Logic Equation Y1 : minimum SOP (Y2) The Logic citcuit :
A:
Q: 10. If you want the gain of the filter at 50 rad/sec to be 10 dB, what value will the 9 k resistor…
A:
Q: Implement and simulate the following function using multiplexer F=AC+BC+ABC
A:
Q: Exercise 6: Find the impulse response of the following second-order system: y[n] = £y[n − 2] + 5x[n]…
A:
Q: 7. Find the amplitude of the output voltage for this circuit. A) 10 V B) 3.7 V C) OV D) 9.3 V 10 Los…
A: In this question we need to choose a correct option
Q: In the circuit shown, the switch is closed and the capacitor charges up. Calculate how long it takes…
A:
Q: Please write answers to all parts of the question in the separate dot points as shown What is the…
A: Note: Since you have posted a question with multiple sub-parts, we will provide the solution only to…
Q: 2t 18. f(t)= e²t cos² t 19. f(t) = e4t[(sin2t)(cost)] 20. f(t) = 6e5t cos(2t) – et
A: it is asked to find the laplace transform using matlab
Q: 2. A double-circuit, three-phase, transposed transmission line is shown (fig. 2) The radius of each…
A:
Q: PROBLEM 2: A RTD is used to measure the temperature of an oven. The RTD forms one arm of a…
A: A Wheatstone bridge circuit with a RTD is given in the questions. The value of supply voltage is…
Q: 3. 4. 5. f(t) = sinßt f(t) = cosßt f(t) = e-at sinßt
A: Note :- we used b instead of β because β is not a ASCII symbol it doesn't supported in matlab.…
Q: Find the Laplace transform of the following time functions using MATLAB.
A: Given: Time domain functions, To find: Laplace transform of above functions using MATLAB.
Q: 5. 3-phase full converter, fed from 3-phase, 400V, 50Hz source is connected to load R=1092, E=350V…
A:
Q: 4) A p-type bar of silicon below the left is subjected to electron injection from the left and hole…
A:
Q: 1. A homogeneous dielectric (&= 4) fills region 1 (z<0) while region 2 (z 20) is free space. (a) If…
A: Given Data: A homogeneous dielectric with, Relative permittivity, εr1=4 εr2=1 (For free space)…
Q: 1. For this circuit, find the expression for I(s). i(0) - 1 A A) I(s) = -(S+6.5) (s+8)(s+0.5) B)…
A: In this question we need to choose a correct option.
Q: A four-pole, 240 V, wave-connected DC shunt motor gives 11.19 kW when running at 1,000 rpm and…
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…
Q: In 2001, the United States produced 51 percent of its electricity in the amount of 1.878x10^12 kWh…
A:
Q: WYE configuration
A:
Q: The figure shows a three-phase delta connected load supplied from a 400 V, 50 Hz, 3-phase balanced…
A: Given circuit, A 3-phase delta connected load supplied from 400 V, 50 Hz, 3-phase balance source.
Q: 4. For the given Boolean expression below a) Y = (A + B + C). A.B + AC+(AB).C b) Y = A.B. (BC) + A.B…
A:
Q: the laplace transform of f(t)=(1-t)u(t) is?
A: We need to find out Laplace transform of given signal.
Q: Q) If v(t) = 260 cos 50t V and i(t) = –63 sin (50t – 30°) A, calculate the instantaneous power and…
A:
Q: (a) Use source exchange to determine V, in the network shown below. Η -j1Ω 12/6°ν (Ε 1Ω 2/04 (1) ·+)…
A: The given network diagram is shown below,
Q: - The sawtooth current i(t) given in Fig. P9.33 is applied to a 250 μF capac- itor as shown in Fig.…
A:
Q: Problems 8, 9, and 10 use the active filter circuit shown below. IMF Vi 9 ksz 8. What is the cutoff…
A: given op-amp circuit has capacitance C = 1 μF feed back resistance RF = 10000 ohms
Q: 2. A source transform is performed on the s-domain representation of the time- domain circuit shown.…
A:
Q: QUESTION 9 Determine the voltage across R2 if PT = 5W VR2 = Vs 120V R1 M units R2 1.5kQ R3 50092 R4…
A: In this question we need to find the voltage are R2 resistor
Q: Use' to denote a complement and list inputs in alphabetical order. First, from the table, read off…
A: We need to find out the output expression for given truth table.
Q: An electromagnetic wave with a magnetic field of Ĥ (y, z) = 4j e³(v-2²) āx is propagating in a…
A:
Q: please do it in paper for better I can understand By hand, compute the 4-point discrete Fourier…
A:
Q: Consider the circuit shown in the figure below. (Let R = 34.0 22.) 25.0 V 5.00 ΩΣ 10.0 Ω www 10.0 Ω…
A: We need to find out the current through given resistor and potential difference between a and b .
Q: An ac generator with a frequency of 80Hz and an rms voltage of 43V is connected in series with a…
A: Given: AC source with frequency, f = 80 Hz and rms voltage, Vrms=43 V,. Voltage source is in series…
Q: Ic = ICA + ICB 16/270° - 24/-30° = 21.2/190.9°
A: Given , IC=ICA+ICB ICA=16<270° A ICB=-24<-30° A We need to calculate Ic
Q: The given G(s) is part of a unity feedback loop. G(s) 3000(s+4) (s+2)(s+7)(s+10)(s+12) Estimate the…
A: Given open loop transfer function G(s)=3000(s+4)(s+2)(s+7)(s+10)(s+12)H(s)=1 It is asked to find the…
Q: The open loop transfer function of a unity feed back system is given by G(s) = (e-0.1s)/s. The gain…
A: Given- The open loop transfer function of a unity feedback system, Gs=e-0.1ss To find- The gain…
Q: alculate the continuous-time output y(t) of a system with impulse response h(t) while the input of…
A: We need to find out output for given input and system.
Q: 6) Consider the below two signals used in a binary communication, determine the dimension and the…
A: According to the question, two signals are used in a binary communication as shown below We need to…
Q: 14. A four-pole 230-volt 60-cycle induction motor has a rotor resistance of 0.15 ohm per phase and a…
A: In this question We need to determine the output power of the induction motor and torque We know…
Q: For the inverting amplifier shown in figure below has Rin=200K and R₁ = 15 MQ. The op-amp used has…
A: According to the question, For the inverting amplifier shown in figure below has Rin=200 kΩ and Rf =…
Q: Q4) Consider the following PCM transmitted signal 1 0 A 0 -A I I I 0 I I a. b. I 0 I 1 0 I 0 1 1 I 1…
A: The PCM transmitted signal is a) We need to determine type of the line code in this PCM transmitted…
Q: An RLC series circuit has a 200 resistor and a 25.0 mH inductor. At 7700 Hz, the phase angle is…
A: We need to find in this circuit Impedance , minimum capacitance and average power . Given Vin = 408…
Q: Refer to the series resonant circuit of figure Q2. Suppose the circuit has a quality factor of Qs =…
A: it is asked to find the current, voltage ,reactive power, impedance, frequency at resonance for…
Q: 6) Consider the below two signals used in a binary communication, determine the dimension and the…
A: According to the question, two signals are used in a binary communication as shown below We need to…
Q: Given two discrete-time signals x₁ (n) = {0.9 0.5 0.8 0.5 0.8 1.0 1.5 2.0 0.2) and x2 (n) = {1.0 0.3…
A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…
Q: In addition to being used to search for volume elements in another coordinate system, the matrix…
A: The charge density is the measure of electric charge per unit area of a surface, or per unit volume…
Q: The open loop transfer function of a unity feed back system is given by G(s) = (e-0.1s)/s. The gain…
A: Given: Open loop transfer function of a unity feedback system, G(s)=e-0.1ss, To find: The gain…
Q: Q₁: A sequential network has one input and one output. The output becomes 1 when either 010 or 00 is…
A:
Q: Results of Experiment The data collected during the experiment is tabled below. These data values…
A: The open-circuit and short-circuit tests were performed on two transformers with following…
Step by step
Solved in 3 steps
- You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwattWhat frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
- Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.The diode shown in the below circuit is a short circuit. Ge 22ks2 True False A Moving to another question will save this response. a. Ask me anything. 00
- A Homework 6b 03182022.docx.pdf - Adobe Reader File Edit View Window Help Tools Fill & Sign Comment Оpen 1 200% T Click on Tools to convert files to PDF. 1. A silicon p-n junction has the following parameters: Na = 1017/cm³, Na = 5 x1015/cm³, Diameter of the circular junction = 10 µm. Calculate Vbi, Xno, Xpo, W, Volume charge in the n-type depletion (qAxnoNp) and Emax at T=300K. 3:28 AM Type here to search 27°C W 24-Mar-22 ---Ri LL = oN200mA t. Vps %3D 19N25V (a) Ri (b) maximum electric power of zener diode (c) maximum electric power of Ri I zmin 0, 2 Izmin %3D4. Calculate the capacitance of the pn junction diode in the circuit below. Cjo = 100 pF and Vbi = 0.725 V. 4.7 k2 6 V 10 k2
- Third approximation of a diode includes both barrier potential VB and the bulk resistance rB of a diode. ○ True ○ FalseMoving to another question will save this response. Quèstion 5 As we change the load resistance supplied through a diode, the operating point of the diode changes. O True False A Moving to another question will save this response. a Cop 近The accelerating anode in CRO is also called as negative electrode. Select one: O True O False Three coils each having resistance of 15 n are connected in delta across 436 V, 50 Hz supply. Then the total power consumed is O 12673.07 W O 755.20 W 844.92 W 7317.01 W