From the following cross-section notes, complete the table below. Use prismoidal method. Road bed width (m) Side slope 6 1:1 4.8 1:1 cut fill Station 3+000 2+980 Area cut (sq.m) at Station 3+000 Area cut (sq.m) at Station 2+980 Area fill (sq.m) at Station 3+000 Area fill (sq.m) at Station 2+980 volume cut (cu.m.) volume fill (cu.m.) corrected volume cut (cu.m.) corrected volume fill (cu.m.) 5.04 -2.64 5.82 -3.42 0.6 0 1.02 0 +0.39 +0.6 5.46 2.46 4.80 +1.80

From the following cross-section notes, complete the table below. Use prismoidal method. Road bed width (m) Side slope 6 1:1 4.8 1:1 cut fill Station 3+000 2+980 Area cut (sq.m) at Station 3+000 Area cut (sq.m) at Station 2+980 Area fill (sq.m) at Station 3+000 Area fill (sq.m) at Station 2+980 volume cut (cu.m.) volume fill (cu.m.) corrected volume cut (cu.m.) corrected volume fill (cu.m.) 5.04 -2.64 5.82 -3.42 0.6 0 1.02 0 +0.39 +0.6 5.46 2.46 4.80 +1.80

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross section at station 3+00 has a cut area of 7 ft² and a fill area of 8 ft2. What is the volume (yd³) of cut between these stations? Round to the nearest hundredths. Response Feedback: V = L cut A +A 54 2+60 3+00
>Example3/ The following offsets are taken from a chain line to an irregular boundary towards right side of the chain line. Chainage 0 25 Offset 'm' 3.6 5.0 Calculate the area using 1. Trapezoidal Method 2.Simpson's method 50 6.5 75 5.5 100 7.3 125 6.0 150 4.0
Topic: Surveying Earthworks Given the following cross-section notes for a road in cut: +2.5/X +C/0 +Y/7.8 The road has with of 10m and its sides have slope of 2:1. The area of the cross section is 47.4 sq. m. 1. What is the value of x? 2. What is the value of y? 3. What is the value of C?
QUESTION 10 A cutting is to be formed on a straight section of a proposed road. The values of eight consecutive cross sectional areas taken at a constant horizontal distance interval of 20m are 325m², 398m², 456m², 580m², 634m², 546m², 447m² and 362m² respectively. Calculate the volume contained between the first and last cross section using : a. End areas method b. Prismoidal formula
In the accompanying sketch, it is desired to determine the area of the sand bar by the indicated short offsets which were measured on both sides of a base line AB. Using the trapezoidal rule, determine the area of the sand bar. Also, determine the same area by employing Simpson's one-third rule. 3.0 4.0 3.0 3.0 4.0 3.0 3.0 3.0 3.0 3.0 4.0 4.0 4.0 2. E
Instruction: Show your complete solution and consider two decimal places. 1. Compute the area of the given closed traverse using DPD Method. Show your solution using tabulation. U N 45°55'21" E 276.48' 216.12' IN 19°46'15" W B D S 54°58'58" E 382.24' S 68°05'27" W 472.72' A
Question 2. Below shown is the profile for a road construction at a station. This is a fill section. Sometimes the letter C is used to designate cut and F to indicate fill for the vertical distance or depth. In other words, a point below the base would have a negative sign in a fill section. F 11.8 below corresponds to -11.8 ft. The baseline is 50ft. Calculate the area for the fill section. (Answer: 137.3 yd²) 50ft F 11.8 -42.5 F 14.3 -32.0 0 -25 25 olo F 15.8 25 25 Baseline F 16.3 65.4
From the following cross-section notes, complete the table below. Use prismoidal method. Road bed width (m) Side slope 6 1:1 4.8 1:1 cut fill Station 3+000 2+980 Area cut (sq.m) at Station 3+000 Area cut (sq.m) at Station 2+980 Area fill (sq.m) at Station 3+000 Area fill (sq.m) at Station 2+980 volume cut (cu.m.) volume fill (cu.m.) corrected volume cut (cu.m.) corrected volume fill (cu.m.) 5.04 -2.64 5.82 -3.42 0.6 0 1.02 0 +0.39 +0.6 5.46 2.46 4.80 +1.80
Refer to the figure. The net excavation (yd³) from Station 1+00 to Station 3+00 is most nearly: (A) 160 (B) 262 390 463 STA 1+00 C=150 ft² F=0 STA 2+00 C=50 ft² F = 0 STA 3+00 C=0 F = 40 ft²
Given:At sta 14 + 200X/-1.84 0/-1.22 X/-0.42At sta 14 + 300X/1.098 0/+3.05 X/+0.5Base for cut = 9m sideslopes = 1:1Base for fill = 8m sideslopes = 1.5:11. Compute the area of sta 14 + 2002. Compute the area of sta 14 + 3003. Determine the difference in volume of cut and fill using end area method.
Complete the following set of profile level notes and show the customary arithmetic check. STATION BS HI FS IFS ELEVATION 115.32 m BM1 0+ 05 010 0.77 2.1 25 TP1 1.66 3.66 017 0+21 0+ 25 0+ 29 23 25 2.7 13 0+33 19 2.1 TP2 2.22 2.88 0+ 38 0.4 08 13 0 50 14 TP3 1.77 3,44 0+ 55 17 TP4 2.15 2.71 2.9 0.69 28 BM2 2.67
A Find by Section Method and Join Method: 3 Hawe Bridge CIS 50 3' D E 50 3° G 50 3'