NORTON'S EQUIVALENT THEOREM 2. Find RN, IN flowing through and VL across the load resistor by using Norton's Theorem. LOAD Resistor IS 12K 25 V 3 ΚΩ ww + ह 9 ΚΩ www 6 ΚΩ ww 12 ΚΩ

Q: In a Darlington pair, the overall B=15000.31=100. Calculate the collector current for Q2 given base…

A:

Q: A star-connected three phase power pack is connected to balanced star-connected load of 2 + j3 Ω.…

A: In this question,  We need to determine the phase , line voltage, active power and reactive power.…

Q: 4. Given the bandgap for silicon, germanium and gallium arsenide are 1.12 eV, 0.66 eV, 1.42 eV…

A: Given, Temperature (T) = 400 K Case(i):- for silicon  Bandgap (Eg) = 1.12 eV Effective electron mass…

Q: 1. Find i(t) and Va(t) for t > 0. SOV 40 a to Та T | H eelle + VR (filt) 20a

A:

Q: Find a and Wo for the following circuit. 100 V A B D a = 2.5 Wo = 6 a = 1.5 Wo = 3 a = 2.5 Wo = 3 a…

A:

Q: 11. GaAs is doped with donor concentration of 3 x 10¹5 cm³. It is a requirement for the intrinsic…

A:

Q: Problem 1 For the network shown below, write the mathematical expressions for the voltage vc and the…

A:

Q: Consider the following circuit: 1 ΚΩ D1 KH If Let I be the input current and Ir be the current that…

A:

Q: 7. The electron concentration in silicon at T = 300 K is n = 5 x 10¹ cm³. 0 a. Is this a n-type or…

A:

Q: 2. Find V₁(t) and Vr(t) for t > 0. 25V +1 2002 t=0 3.5H - V₂ ²102 + Ji 2mF VR3012

A:

Q: b. The power p(t) c. Power delivered at 5 ma d. The energy of the power system for the interval from…

A: We need to find out power and energy for given current and voltage .

Q: Find v₂ and the power supplied by the source 9 V( + 1 KQ Lw 1.5 KQ 500 $2 Click here for the answer…

A:

Q: 5) For the following circuit, determine: a) Vo aggregate; b) The value of the resistance Rx, so that…

A:

Q: Select the best answer for the following questions: 1) An ongoing process that evaluates and…

A: An engineer always involves with the conceptual design and provide its better design purpose for the…

Q: Repeat Problem 2.37 for the function f(x₁, ..., X4) = IIM (0, 1, 2, 4, 5, 7, 8, 9, 10, 12, 14. 15).

A: We need to find out the POS and SOP for given Function , we will find out it by using of k map .

Q: 5) Write the mesh current equations for the circuit shown below. 10 Ω 492 2092 ww 4 192 8V 6V 592

A:

Q: Figure Q2(d) shows an RLC circuit. Given R₁ = 2, R₂ = 52, C = 2 F and L = 1 H. Find the transfer…

A:

Q: Find the F. I of g(t) = cos wat iw t cos w f 8(1) www.

A:

Q: 4. A 4-pole induction motor draws 25 A from a 50 Hz, 460 V, three phase line at power factor of 0.85…

A:

Q: Given that a BJI is biased to have a small signal input resistance r = 50 ks with B = 200, what is…

A: Given: rπ=50 kΩ and β=200. Required: Transconductance gm.

Q: #2): Evaluate the followings: a) (t³+2)8(t+1)= b) 1.₂²(t³+2)8(t+1)dt= c) ..[(sin2t)/t]8(t-1)dt- c)…

A:

Q: An 8-pole, lap-wound armature has 1200 conductors and a flux per pole of 0.03Wb. Determine the…

A: Flux ϕ = 0.03 Wb Number of revolutions = 500 rev/min Number of number of armature conductors Z =…

Q: 2. Consider the op-amp circuit in Fig. 2. a) Find i and uo when Us = -1.5V. b) Find i and uo when Us…

A:

Q: The input to a full-wave rectifier is 10 V AC (RMS). The load resistor is 10 ohms. The DC voltage at…

A: Given, input AC voltage, VRMS=10 V load resistor, RL=10 Ω

Q: Assume that a datasum of Ox6A has been computed for a sequence of bytes. What is the 1's complement…

A: The given datasum is 0x6A It is given in hexadecimal form. One digit of hexadecimal can be…

Q: Find the Thévenin equivalent with respect to the terminals a,b for the circuit in Fig. 4: Draw the…

A:

Q: Q#7 A Buck-Boost converter is given in Fig 2. The input DC voltage is 18 V, and a switching…

A:

Q: An 8-pole, lap-wound armature has 1200 conductors and a flux per pole of 0.03Wb. Determine the…

A: It is given that:- P=8 Z=1200  ϕ=0.03 Wb N= 500 rev/min E(emf) = ?

Q: Find the vector potential of an infinite solenoid with n= 5 revolutions per unit length, radius R =…

A: Given: n=5 rev. per unit length, R=2 cm , I=2 A. Required: Find the vector potential.

Q: Use the node-voltage method to find : current is - - voltage

A:

Q: Consider the following second-order difference equation: y[n] +1.4y[n − 1] +0.45y[n − 2] = x[n] −…

A: Considering the second order difference equation, yn+1.4yn-1+0.45yn-2=xn-xn-1taking z-transform on…

Q: An antenna has a maximum effective aperture of 2.147 m² at its operating frequency of 100 MHz, it…

A: Given:  Aem=2.147 m2, f=100 MHzZin=75 Ω, ZL=50 Ω Required: Directivity of the antenna system.

Q: With the following frequency responses for the signal and noise (|X(jw)| and |N(jw)|), what is the…

A: Given: the frequency responses of signal and noise as X(jω) and N(jω) respectively. To find: the…

Q: 1. A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a…

A: As per the policy of bartleby the provisions is to solve only one question at a time now I am…

Q: Given the circuit in Figure 16-5, what is the RMS current through the inductor? X₁ = 300 Ω 600 Vrms…

A:

Q: In the given common collector circuit, Vcc=5V and R₁ = 1kn. Note that the BJT has the 0.2V. Place…

A: BJT is a current controlled Device in which base current control the mode of operation of BJT  Mode…

Q: A forward (buck) converter has a d.c. input voltage of 30V, a 1:1 transformer and an ideal Mosfet…

A:

Q: What is the force exerted on Q2 by Q1? If Q1 = 3x10-4 C at M(1,2,3) and Q2 = -10-4 C at N(2,0,5) in…

A:

Q: Given points. P(2,5,-1), Q(-1,-4,1), and 7(5,0,2), find: (a) the vector Rroi (b) a unit vector in…

A:

Q: What is binning and what is it used for? A. This is the approach of separating the obtained…

A: QUESTION What is binning and what is it used for? ANSWER  Option(B) It…

Q: FOR THE FOLLOWING CIRCUIT BELOW, DETERMINE: A) THE EQUATION OF VO; H B) THE VALUE OF VO FOR VA =…

A:

Q: 1. Write down the relationship between potential difference and electric field and use it to show…

A:

Q: 2. An analysis of a certain circuit yields transfer function H(s) = Vin. If Vin(t) = 20 cos(100t…

A: Given here a transfer function and asked to find the v0t.

Q: Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical…

A:

Q: For each of the 3 circuits below calculate input impedance Zin. Do not consider any capacitor other…

A: Input impedance is found by applying a voltage vx and measuring current ix as shown below Small…

Q: A ferromagnetic ring has a uniform cross-sectional area of 2000 mm² and a mean circumference of 1000…

A:

Q: Given the circuit diagram below, write the equation for the COMPLEMENT function as an POS. B' B B' D…

A:

Q: 4. Assume a zero reference at infinity, and find the potential at P(0,0,10) that is caused by this…

A:

Q: -12V R2 680 Ohm Supply Voltage 12VDC R1(2 1 kOhm R4 1.5 k Ohm R3 4.7 kOhm (Y) Figure 8:…

A:

Q: What is the purpose of the amplitude limiter to FM Demodulation

A: In this question We need to define the purpose of the amplitude limiter to FM Demodulation.

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.