onsider a single electron (initially at rest) in a region where electric fields exist. Ignore any influences on the electron other than electrostatic. The electron will move None of these from low potential to high potential. from high potential to low potential. in the direction of the electric field.

onsider a single electron (initially at rest) in a region where electric fields exist. Ignore any influences on the electron other than electrostatic. The electron will move None of these from low potential to high potential. from high potential to low potential. in the direction of the electric field.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 6CQ: If a proton is released from rest in an electric field, will it move in the direction of increasing...

See similar textbooks

Similar questions

When a potential difference of 150. V is applied to the plates of an air-filled parallel-plate capacitor, the plates carry a surface charge density of 3.00 1010 C/cm2. What is the spacing between the plates?
When a potential difference of 150. V is applied to the plates of an air-filled parallel-plate capacitor, the plates carry a surface charge density of 3.00 1010 C/cm2. What is the spacing between the plates?
(a) Find the electric potential, taking zero at infinity, at the upper right corner (the corner without a charge) of the rectangle in Figure P16.13. (b) Repeat if the 2.00-C charge is replaced with a charge of 2.00 C. Figure P16.13 Problems 13 and 14.
How many electrons should be removed from an initially uncharged spherical conductor of radius 0.300 m to produce a potential of 7.50 kV at the surface?
If a negatively charged particle is placed at rest in an electric potential field that increases in the positive x-direction, will the panicle (a) accelerate in the positive x-direction, (b) accelerate in the negative x-direction, or (c) remain at rest?
A small spherical pith ball of radius 0.50 cm is painted with a silver paint and then -10 C of charge is placed on it. The charged pith ball is put at the center of a gold spherical shell of inner radius 2.0 cm and outer radius 2.2 cm. (a) Find the electric potential of the gold shell with respect to zero potential at infinity, (b) How much charge should you put on the gold shell if you want to make its potential 100 V?
The electric potential inside a charged spherical conductor of radius R is given by V = keQ/R, and the potential outside is given by V = keQ/R, Using Er = dV/dr, derive the electric field (a) inside and (b) outside this charge distribution.
The three charged particles in Figure P25.22 are at the vertices of an isosceles triangle (where d = 2.00 cm). Taking q = 7.00 C, calculate the electric potential at point A, the midpoint of the base.
Is the electric potential necessarily constant over the surface of a conductor?
A particle with charge 1.60 1019 C enters midway between two charged plates, one positive and the other negative. The initial velocity of the particle is parallel to the plates and along the midline between them (Fig. P26.48). A potential difference of 300.0 V is maintained between the two charged plates. If the lengths of the plates are 10.0 cm and they are separated by 2.00 cm, find the greatest initial velocity for which the particle will not be able to exit the region between the plates. The mass of the particle is 12.0 1024 kg. FIGURE P26.48
The three charged particles in Figure P20.11 are at the vertices of an isosceles triangle (where d = 2.00 cm). Taking q = 7.00 C, calculate the electric potential at point A, the midpoint of the base. Figure P20.11
Two very large metal plates are placed 2.0 cm apart, with a potential difference of 12 V between them. Consider one plate to be at 12 V, and the other at 0 V. (a) Sketch the equipotential surfaces for 0, 4, 8, and 12 V. (b) Next sketch in some electric field lines, and confirm that they are perpendicular to the equipotential lines.