A long vertical wire le partially placed in a uniform magnetic field B-53 mT. The B-field is directed at angle 0=36" to the wire (see figure). If an electric current of 1-3.7 A moves in the wire in the direction shown, determine the magnitude of the magnetic force (mN) exerted on a wire section of length L 71 cm. Give answer to two places to the right of the decimal. T

A long vertical wire le partially placed in a uniform magnetic field B-53 mT. The B-field is directed at angle 0=36" to the wire (see figure). If an electric current of 1-3.7 A moves in the wire in the direction shown, determine the magnitude of the magnetic force (mN) exerted on a wire section of length L 71 cm. Give answer to two places to the right of the decimal. T

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 3RQ

See similar textbooks

Similar questions

A rectangular coil of wire has a length of 3 cm and a width of 4 cm. It is in a 0.004 T magnetic field. What is the magnetic flux through the coil if the face of the coil is parallel to the B-field lines? What is the flux if the angle between the face of the coil and the magnetic field is 75°?
1-22. For the figure below, determine the magnetic field intensity in A/m and its direction (into or out of the paper) at point P between the two straight wires. 10A 6mm 4mm 20A
A coil of wire is wound around the left side of a ferromagnetic core. It is supplied by a source (not shown in the figure), such that the current i1 is directed as shown. At the instant shown, the current i1 is increasing. What will be the direction of the magnetic flux through the core? O a. To the left O b. None of the others are correct. To the right Clockwise O c. O d. O e. O f. There will be no magnetic flux Counterclockwise core
The applied MMF to a simple magnetic circuit is 350AT. It was found that the resulting magnetic field denstiy is 0.7 Wb/m2. The average length of this magnetic circuit is 1.64ft and its cross-sectional area is 4cm². What is the relative permeability of the magnetic material of the core?
1. What is the relationship between voltage and current when there is saturation in the magnetic circuit? 2. When there is no saturation in the magnetic circuit, what is the relationship between voltage and current? 3. Briefly explain what caused the saturation in the magnetic circuit. 4. What happens to alternating current, alternating current, and alternating magnetic flux in a magnetic circuit when frequency increases? 5. When a magnetic circuit is saturated, explain two solutions that can be used so that the magnetic circuit is no longer saturated.
L L Four long, parallel current carrying wires form a square on the plane as shown in the figure. If they carry equal currents in magnitude, what is the direction of the net magnetic field at the center P? O A) into the page O B) out of the page C) up (top of page) O D) down (bottom of the page) O E) no field
In the figure is shown a current of 50 A in a wire 120 cm long and at an angle of 45° to a magnetic field of flux density 6.0 x 10 -4 Wb/m2. What are the magnitude and direction of the force on this wire?
Question 3.4 (3.4)The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-ironcore has 360 turns and takes a current of 1.75 A. The core is square in section with sides of 20 mm. Takethe relative permeability of soft iron as 1100. 3.4.1) Determine the magnetomotive force in the core 3.4.2)Determine the field strength 3.4.3) Determine the total flux
show thatvthis is a magnetic flux density: then prove and interpret it with reasons on each step
Consider an iron ring of 10 cmdiameter is uniformly wounded with 3000 turns of wire. The coil current is 0.25 A and a flux density of 0.6 T is set in the ring. Determine the relative permeability of the iron and magnetic field strength.
Question Three: Magnetic Force between wires. Three long parallel wires are 5 cm from one another. (Looking along them, they are at three corners of an equilateral triangle.) The current in each wire is 10.00 A, but its direction in wire M is opposite to that in wires N and P. Determine the magnetic force per unit length on each wire due to the other two. M sem 5cm
A single straight wire produces a B-field. Another wire is parallel and carries an identical current. If the two currents are in the same direction, how would the magnetic field be affected? What if the currents are in the opposite direction?