Concept explainers
Consider the relative intensity graph shown at right.
Suppose that both slits were made narrower (without changing the distance between the centers of the slits).
On the graph at right, indicate how the relative intensity would change. Explain.
Suppose that after gradually narrowing both slits, one of the slit, were then covered. On the axes provided, sketch the relative intensity graph for this case.
How does your graph compare o what you would expect for a point source? If it is different, how could you modify the physical situation so that the relative intensity graph better approximates that due to a point source?
In order for the relative intensity graph to be a good approximation of that due to a point source, how must the width of the slit compare to A? Explain your reasoning.
Want to see the full answer?
Check out a sample textbook solutionChapter 11 Solutions
Tutorials in Introductory Physics
Additional Science Textbook Solutions
Sears And Zemansky's University Physics With Modern Physics
Conceptual Physics (12th Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Introduction to Electrodynamics
Lecture- Tutorials for Introductory Astronomy
- Two loudspeakers are placed above and below each other, as shownand driven by the same source at a frequency of400Hz. An observer is in front of the speakers (to the right) at pointO, at the same distance from each speaker. What minimum vertical distance upward should the top speaker be moved to create constructive interference at pointO?The speed of sound is 343m/s. Pls show all your workarrow_forwardGreen light shines through a 100-μm-diameter hole and is observed on a screen. If the hole diameter is increased by 20%, does the circular spot of light on the screen decrease in diameter, increase in diameter, or stay the same? Explain. Match the words in the left column to the appropriate blanks in the sentences on the right. The wavelets do not interfere in this case The diameter of the central maximum is inversely proportional to the diameter of the hole The diameter of the central maximum is proportional to the diameter of the hole Submit The hole is too large to observe the diffraction increases decreases does not change Request Answer diameter. and so the diameter of the spot of light on the screen Reset with the hole's Helparrow_forwardSolve the following problems as indicated. Show your complete solutions on a separate sheet of paper. 1. Refer to the illustration on the left. \60° The purple unpolarized light has an 900 original intensity, lo, of 25 W/m?. Assume that all the 3 filters are Unpolarized C idealized. Determine the intensities of light after passing thru points A, B, and C.arrow_forward
- After passing through a diffraction grating with a period of d = 6.5μm, located 5m away from the screen, laser light creates the image on the screen shown below. What is the wavelength of the light if the distance between zero and first maxima is 50cm? Show all your work. For a full credit, cite relevant formulas and problems from the notes.arrow_forwardSuppose that waves travel 1.5x as fast within the triangular object than in the surrounding medium. Continue the incident ray until it emerges through the triangular medium on the other side. Please draw the surface normal, the weak reflection, as well as the "would have" line for each interface as shown in class. and label all angles. Incident ray Faster, medium II Medium Iarrow_forwardIf light with a wavelength of 480 nm is used in a two-slit experiment with a barrier with slits that are 0.05 mm apart that is 1.6 m from the projection screen. What is the distance from the center of the first and third dark fringes? Show your work.arrow_forward
- Solve the following problems. Show your complete solutions legibly and concisely in the space below each item.arrow_forwardLight is incident from air onto a gas slick sitting on water. Determine the minimum thickness of gas required to produce constructive interference for orange light with a wavelength of 5.9 x 10^7 m. Show all your work please.arrow_forwardIn a double-slit diffraction experiment, monochromatic light of wavelength 680nm is sent through slits of width D = 0.02 mm with spacing d = 0.06 mm, and a viewing screen is placed at L = 1 m. a)Calculate angle from the central maximum to the first 2 interference minima. Show your work. b)What order fringe from a single slit is missing from the pattern due to destructive interference from the second slit? Explain your reasoning/show your work. m=_______________ c) If the slit spacing were 0.08 mm, what order of fringe would be missing from the diffraction pattern? Show all equations used. m=_______________arrow_forward
- Solve the following problems. Show your solution. 1. Echoes return in 2.5 s to a person standing in front of a cliff. How far away is the cliff of the peed of the sound in air at sea level is 343 m/s when the temperature is 20 o C 2. The airplane takes off at 9:00 AM and flies in a straight path at 300 km/hr until1:00 PM, its speed is increased to 400 km/hr and it maintain this speed in the same direction until it lands at 3:00 PM. What is the average speed of the airplane fir the entire flight? 3. An object that is undergoing uniform acceleration from rest moves 7.4 m in 2.5 s. what is the acceleration of the object?arrow_forwardIn the figure 1 given below, b and c are filtered images of a. Identify the image that is low-pass filtered and the one is high-pass filtered and explain your answer.arrow_forwardUse the following information for the Gas Identification part of the lab. The data below are angles that might be recorded by a student using a spectrometer to map bright lines in the emission spectrum of some unknown gas. Be sure to record both the gas ID number and the diffraction grating constant (slit spacing) to be used in the analysis. In the answer field below, convert the first m=1 angle entry above to the corresponding wavelength expressed in nanometres. PLEASE SHOW THE STEPS FOR HOW TO CALCULATEarrow_forward
- Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill