At the surface of any conductor in electrostatic equilibrium,
Want to see the full answer?
Check out a sample textbook solutionChapter 6 Solutions
University Physics Volume 2
Additional Science Textbook Solutions
The Cosmic Perspective Fundamentals (2nd Edition)
Lecture- Tutorials for Introductory Astronomy
Cosmic Perspective Fundamentals
University Physics with Modern Physics (14th Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
College Physics: A Strategic Approach (4th Edition)
- Problem 6: The voltage across a membrane forming a cell wall is 83 mV and the membrane is 9.25 nm thick. What is the electric field strength in the cell wall, in volts per meter? E = sin() cotan() atan() acotan() cosh() tanh() cos() asin() O Degrees tan() π ( ) 789 acos() E ^^^ 4 5 6 sinh() 1 1 2 3 cotanh() + 0 Radians VOBACKSPACE HOME END DEL CLEARarrow_forwardYou want make the largest possible B field at some location (some point in space) by running acurrent through a piece of copper wire of length L that you already have, with a battery of voltage Vthat you also already have. What is the best possible shape and size for the wire to take on? Whatis the largest B (an equation) based on V, L, resistivity of copper (ρ), and any other parameters -geometric or otherwise - that can be created?arrow_forwardA volume charge distribution in free space has p,=1.8r (nC/m³) for 0srs5m (inside of sphere of radius r), 0s8spi, 0s0s2pi, and zero otherwise. Determine magnitude of Electrical field (in V/m) at r=1m. Permittivity of free space is given as ɛ,=(1/(36pi)x10-° F/m. O a. 61.07 O b. 50.89 О с. 55.98 O d. 43.26 О е. 35.63arrow_forward
- (b) The density of iron is 7.85 g/cm3, and its atomic mass is 55.8. Assuming each iron atom contributes two mobile electrons to the metal, what is the number density of free charges in the wire, in electrons/m3? (Enter your answer without units.) (c) Use your results to calculate the drift speed (i.e., the average net speed) of the electrons in the wire. (d) Due to thermal motion, the electrons at room temperature are randomly traveling to and fro at 1.13×105 m/s, even without any current. What fraction is the current's drift speed, compared to the random thermal motion?arrow_forwardShow that for V less than zero, InetI0.arrow_forwardA large conducting cone ( 0=35° )is placed on a conducting plane with a tiny gap separating it from the plane as shown below. If the cone is connected to a V.=40 V source, find V at (r-5,0=55°,p=D45°) -Vo Gap Oa. 22.62 V b. 79.18 V c. 33.94 V d. 11.31 V e. 16.97 V f. 113.12 Varrow_forward
- Parallel conducting plates create nearly uniform fields that are used to accelerate and direct beams of electrons. Typically we would free the electrons from a surface by heating it up. One way is to run a current through a wire with resistance. The power dissipated in the wire causes it to increase its temperature to the point that it can radiate that power away, mostly carried off as light. The hot electrons escape the potential barrier at the surface and are "free" to use. Consider a source of electrons that is small, like a tiny hot filament. The electrons are freed from the surface but the positive charge they leave behind holds them in a cloud near the filament. Now we add another plate at voltage VV some distance dd away. We put a little hole in that plate to enable the electrons to zip on through. The experiment looks something like this. While they seem antiquated, the concept is still useful. It is the basis of modern X-ray tubes, and until only a few years ago all…arrow_forwardThe axis of a long dielectric tube with an inner radius r = 2m and an outer radius r = 5m coincides with the z-axis. Inside the dielectric body, there is a polarization vector in the form of P = P.(3yâx + 4xây). Find the equivalent volume charge density Ppv at point (2,0,4). Ppv = 0 O A) O, Ppv 7Por sin ø cos Ø %3D B) Ppv Por sin ø cos Øarrow_forwardHow much energy is imparted to an electron as it flows through a 20 V battery from the positive to the negative terminal? Express your answer in attojoules.arrow_forward
- Imagine that two parallel plates are charged to achieve a voltage difference Vo between the plates. They have area A and spacing d. The plates are then electrically isolated so that no charge can be added or taken away. A good conductor of thickness d/2 is placed in between the two plates, as shown. How great is the charge density on the surface of the conductor relative to that on either of the plates? Why? (You may use infinite plane approximations for the surfaces.)arrow_forwarda) Determine the charge current density to produce a resistivity of 1010 Ωm at room temperature in a disc of dielectric material with diameter of 18 cm and thickness of 2 cm. The value of Arbitrary constant and Boltzmann Constant is assumed to be 3.5 * 10-8 and 1.38 * 10-23 J/K respectivelyarrow_forwardConsider an infinitely long wire of charge carrying a positive charge density of A. The electric field due to 1 this line of charge is given by E = 2k, = -, where is a unit vector directed radially outward 2πεor T from the infinitely long wire of charge. Hint #3 3 a. Letting the voltage be zero at some reference distance (V(ro) = 0), calculate the voltage due to this infinite line of charge at some distance r from the line of charge. Give your answer in terms of given quantities (A,ro,r) and physical constants (ke or Eo). Use underscore ("_") for subscripts and spell out Greek letters. Hint for V(r) calculation V(r) = b. There is a reason we are not setting V(r→ ∞o) = 0 as we normally do (in fact, in general, whenever you have an infinite charge distribution, this "universal reference" does not work; you need a localized charge distribution for this reference to work). Which of the following best describes what happens to potential as roo? (That is, what is V(ro), with our current…arrow_forward
- University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax