The result obtained by dividing the tensile force with the original cross-sectional area of specimen.
Answer to Problem 1CQ
The result obtained by dividing the tensile force with the original cross-sectional area of specimen is Engineering Normal stress.
Explanation of Solution
Consider a specimen having a cross-sectional area as
The result of this tensile force over the cross-sectional area over the specimen is known as engineering normal stress.
Thus, the result obtained by dividing the tensile force with the original cross-sectional area of specimen is Engineering Normal stress.
Want to see more full solutions like this?
Chapter 6 Solutions
Materials Science And Engineering Properties
- Estimate the elastic and plastic strain at the ultimate tensile strength in the low-carbon steel specimen in Figure 6.16.arrow_forwardAn aluminum alloy [E = 67 GPa; ν = 0.33; α = 23.0 × 10–6/°C] plate is subjected to a tensile load P. The plate has a depth of d = 225 mm, a cross-sectional area of A = 5100 mm2, and a length of L = 4.1 m. The initial longitudinal normal strain in the plate is zero. After load P is applied and the temperature of the plate has been increased by ΔT = 63°C, the longitudinal normal strain in the plate is found to be 2900 με. Determine: (a) the magnitude of load P. (b) the change in plate depth Δd.arrow_forwardA tensile force P Newton is applied gradually on a prismatic bar of length L m and areas of cross- section A m². The strain energy stored in the bar will be equal toarrow_forward
- Testing a round steel alloy bar with a diameter of 15 mm and a gauge length of 250 mm produced the stress–strain relationship shown in Figure Determinea. the elastic modulusb. the proportional limitc. the yield strength at a strain offset of 0.002d. the tensile strengthe. the magnitude of the load required to produce an increase in length of 0.38 mmf. the final deformation, if the specimen is unloaded after being strained by the amount specified in (e)g. In designing a typical structure made of this material, would you expect the stress applied in (e) reasonable? Why?arrow_forwardStress and strain analysisarrow_forwardThe stress in an elastic material is: A Inversely proportional to the force acting B Inversely proportional to the materials yield strength C Proportional to the displacement D Inversely proportional to the strainarrow_forward
- Materials Science And Engineering PropertiesCivil EngineeringISBN:9781111988609Author:Charles GilmorePublisher:Cengage Learning