The oil side heat transfer coefficient, the effectiveness and the exit temperature of the oil.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 11.59P

To determine

The oil side heat transfer coefficient, the effectiveness and the exit temperature of the oil.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

a one shell and two tube pass heat exchanger, coolant enters the tube at 4.81 kg/s (spread over 72 tubes with each tube being 0.01 m in diameter and 1.95 m length) at an initial temperature of 25 C. Water enters the shell at 2.5 kg/s at an initial temperature of 5 C. The average convection coefficient of the water is known to be 1e4 W/m2.K. What is the overall heat transfer coefficient, assuming no fouling, negligible tube thermal resistance and near-identical inner and outer tube surfaces? What is the actual heat transfer rate? What is the coolant outlet temperature? The coolant properties are Cp = 1040 J/kg.K, μ = 7.65e-4 kg/s.m, k = 0.058 W/m.K and Pr = 14. Assume the water Cp = 4200 J/kg.K.

Oil at 10°C is to be heated by saturated steam at 1 atm in a double-pipe heat exchanger to a temperature of 30°C. The inner and outer diameters of the annular space are 3 cm and 5 cm, respectively, and oil enters at with a mean velocity of 0.8 m/s. The inner tube may be assumed to be isothermal at 100°C, and the outer tube is well insulated. Assuming fully developed flow for oil, determine the tube length required to heat the oil to the indicated temperature. In reality, will you need a shorter or longer tube? Explain.

F1 Vegetable oil at a flow rate of 10 kg/s (p=920 kg/m³; u=5x10-3 Pa.s; k=0.14 W/m K; cp-2.1 kj/kg K) from 51 pieces of 1.2 mm thick stainless steel plates It will be heated from 20°C to 50°C in a plate heat exchanger consisting of Heating will be carried out using steam at 121°C. The plate width (w) is 0.3 m and the clearance between the plates is 3 mm. The effective area is 1.5 times the projected area. The heat transfer coefficient for the steam side is 12000 W/m².K. Calculate the required plate length since the heat exchanger is operated in series flow order (Pressure drop must be determined)